PARTS – ARM PISTON CONNECTOR 13 – ARM BARREL CONNECTOR 14 – HAND BARREL CONNECTOR 15 – BASE BARREL CONNECTOR

12 – ARM PISTON CONNECTOR

1. Sketch on Front plane 2. Extrude Boss/Base New Sketch on Surface Point to the Right Side Left-Click your mouse Click Sketch button 4. View Normal To Circle  Extruded Cut Through All

6. Fillet Spin the part until you see the bottom. New Sketch on Surface Point to the Bottom, Left-Click your mouse Click Sketch button 8. View Normal To Circle  Extruded Cut.25 Save as 12 – ARM PISTON CONNECTOR Put into Titlebox (see next slide)

FRONT VIEWRIGHT SIDE VIEW BOTTOM VIEW

13 – ARM BARREL CONNECTOR

1. Sketch on Top plane2. Extrude Boss/Base New Sketch on Surface Point to the Top Left-Click your mouse Click Sketch button 4. View Normal To Draw Rectangle as shown above No need to Smart Dimension

5. Extrude Boss/Base 1 Click Merge result box 6. New Sketch on Surface 7. View Normal To Two Circles  Extruded Cut Through All 9. Fillet – ARM BARREL CONNECTOR Put into Titlebox (see next slide)

14 – HAND BARREL CONNECTOR

1. Sketch on Front plane Save as 14 – HAND BARREL CONNECTOR Put into Titlebox (see next slide) 2. Extrude Boss/Base New Sketch on Surface 4. View Normal To Draw Rectangle & Circle as shown above 5. Extruded Cut Through All

15 – BASE BARREL CONNECTOR

4. View Normal To Draw Rectangle as shown above No need to Smart Dimension 3. New Sketch on Surface 1. Sketch on Top plane 2. Extrude Boss/Base 1.25

5. Extrude Boss/Base 1 Click Merge result box 6. New Sketch on Surface 7. View Normal To Two Circles  Extruded Cut Through All 9. Fillet.25 Save as 15 – BASE BARREL CONNECTOR Put into Titlebox (see next slide)