1. Boat Design

2. Your boat must be a Power boat

3. Or a Sail Boat

4. A Catamaran can be powered and/or have a sail

5. Small Power Boats:
Must draw seats, dashboard, controls, propeller.

6. Small Power Fishing Boats
With outboard engine
Must draw seats, dashboard, controls, outboard engine, etc

7. Not enough detail for this project

8. Original picture of a boat from the Internet Title: Boat Design
Cover slide:
Original picture of a boat from the Internet
Title: Boat Design
Your full name, Date, DDP
5 (or more) total slides of your boat:
3 different views of the boat
a. Top view
b. Rear view (showing propeller or outboard engine)
c. Isometric view
2 show close up details
Detail views of the cabin
Websites

9. Cover slide:
Original picture of a boat from the Internet
Boat Design
Your full name
Date
DDP

10. Top view

11. Rear view (showing propeller or outboard engine)

12. Isometric view

13. 2 show close up details
Detail views of the cabin

14. 2 show close up details
Detail views of the cabin

15. PAST STUDENT
EXAMPLES

16. PAST STUDENT
EXAMPLES

17. YOUR BOAT DESIGN MUST BE MADE BY LOFTING!

18. BASIC HULL TUTORIAL

19. 1. Front Plane
New Sketch
Draw a Point
2. Place it 5” below the red origin as shown
3. Regenerate

20. 4. Click Front Plane
Reference Geometry
Plane
Distance 144”

21. 5. Plane 1
New Sketch
Draw as shown above (or similar)
Mirror command to create the left side
Regenerate

22. 6. Click Plane 1
Reference Geometry
Plane
Distance 144”

23. 7. Plane 2
New Sketch
Draw as shown above (or similar)
Mirror command to create the left side
Regenerate

24. 8. Right-click and hide all planes
Should resemble this when you’re finished.

25. 9. Lofted Boss/Base
Pick green dots on the bottom of the hull as shown above
Start/End Constraints: See settings above

26. 10. New Sketch on Top Plane
Draw the outline (or similar) as shown on the right.

27. 11. Cut-Extrude, 30”
Draft 10 degrees
Add Seats, Dashboard, Steering wheel, Cabin, Outboard Motor, Propeller, Mast (if Sailboat), Fishing gear, Railings, etc.