1. 1. Top Plane, New Sketch Sketch Circles 2. 50 & 1
1. Top Plane, New Sketch Sketch Circles 2.50 & 1.625 Sketch Centerline
2. Offset Centerline 1.25” Bi-directional
3. Sketch Circle .8125
Sketch Line on right side
4. Offset Centerline ” Bi-directional

2. 5. Trim
6. Sketch Fillet .625”
7. Boss-Extrude .5625
8. New Sketch on Surface View “Normal To”
Sketch Circles 2.50 & 1.625

3. 10. New Sketch on Surface View “Normal To”
Draw a Centerline as shown above
Offset Centerline ” Bi-directional
9. Boss-Extrude ”
12. Cut-Extrude, Through All
11. Connect ends of both lines

4. 13. Right Plane, New Sketch
Sketch Circle .4325
14. Cut-Extrude
Pull arrow forward or click Reverse Direction
D1 = 1.625”
15. Drawing on next slide