1. Year 9Dice

2. Select “New” Select “Metric” Standard (mm).ipt 1 2

3. 3 Sketch Panel bar Model Tree View Icons

4. 3 Select the “Rectangle” tool Plot a rectangle on the sketch panel 4

5. 5 Select the “Dimension” tool 6 Dimension each side to 100mm

6. 7 Select “Finish Sketch” and press F6 8 Choose “Extrude” and enter 100mm as the distance in the dialogue box

7. 9 Select “OK” when you can see this 3D cube. 10 To sketch on a face we need to select the “Create 2D sketch” icon and select the face on which we want to sketch.

8. 11 It’s easier to draw on the face if we can view it straight on. To do that we select the “View Face” icon and select the face we want to look at. “View Face” iconSketch panel across face. 12 Use the “Circle” tool to draw a circle on the top left of the cube.

9. 13 And now Dimension to the sizes shown below

10. 14 We can use the “Rectangular Pattern” tool to duplicate the circle on both the vertical and horizontal axes. Select the circle you want to copy and enter the relevant information into the dialogue box. 3 circles 30mm apart …And do the same for the vertical axis

11. 15 Select the sections you wish to extrude; in this case we will be sketching number 5 on the dice, and extrude to 3mm. Cut material away To a distance of 3mm Repeat these steps for the other numbers on the dice.

12. 16 Use the “Fillet” tool to round off the edges of the dice. Select the edges of the cube. Change the Radius to 5mm. Do the same for the outer and inner parts of the circles, however this time set the radius to 3mm.