Chassis Subsystem Electronics Rack DC Power Supply Rack MM M M M M M M M M M F F F F F F F F F F F F F F FF M M F F AC X 24 M M M M FF FF F F F F 1 DC.

Slides:

Advertisements

Similar presentations

F AST T RACK REMOTE SWITCH WIRING SET UP FOR THE LIGHT BoardPlug Power strips relay Wiring Harness.

Advertisements

H/W Team R&D Center / BCS Dept. Installation of.

Student DIY Microphone Workshop A simple, yet effective, student-built, phantom- powered, DIY microphone project for use in school audio/visual labs. Recommended.

© DIAMOND SA / / 1 MT-RJ CONNECTOR SYSTEM Duplex SFF for FTTx applications.

LIGO-G V8 1 aLIGO DC Power Distribution Contents.

NetSure™ RDB Series.

Electronics. Solid snap together electronic connectors.

Connecting Speaker Level Outputs to Harman Amplifiers.

Connectors Connectors are a major cause of equipment failure. Pins are wired incorrectly, bare wires touch and short circuit or connector pins are accidently.

5/13/ Assembling and Testing Your Robot. 5/13/2015 Mounting the Topside Hardware  Parts Boe-Bot Chassis (1) Standoffs (4) 1/4” 4-40 Screws (4)

Glenair Micro-D Connectors: New Product Offerings.

I have almost 20 years experience in the components and devices used in industrial control, instrumentation and automation applications. Before I came.

PACS IIDR 01/02 Mar 2001 FPU Harness and Distribution Board1 D. Kampf KAYSER-THREDE.

RaceBot can do car race using two DC motors. Let's learn how to go forward, backward, right turn, and left turn. with practicing ' ㄱ ' shape racing, and.

Soldering Jumper Wires SPIRIT Strip about ¼” of insulation Apply solder until wire appears soli d “Tin” the wire.

Wire bundles connecting to Keyence Sensors (screw plug on other end) Colored Wires from bundles (brown, blue, white are nonfunctional, cap with scotch.

+ – + – Chassis Subsystem Electronics Rack DC Power Supply Rack MM M M M M M M M M M F F F F F F F F F F F F F F FF M M F F AC X 24 M M M M FF FF F F F.

Electronics and Cables around IMC Common Mode Servo Board Yuta Michimura Ando Group Department of Physics, University of Tokyo August 10, 2015.

ST/PRM3-EU | | © Robert Bosch GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as copying.

June 2008 R&D Center / BCS HW Team Introduction to iPECS P5 Hardware.

FlyBot is an airplane robot. This robot consists of the DC motor which supplies rotatory power to the propeller. Fly.

Configuring a PC. Installing the Mother board To Install the Mother board, fit it into the computer casing. You will then need to Insert 24 pin ATX power.

1 LIGO- D Option 01 LIGO- D Option 02 D DC Power Distribution Strips LIGO-D V3 1 This concept diagram emphasizes the DC Power.

1 LIGO-G V1 Magnetometer DC Power Assessment Magnetometers are distributed in the corner station and both end stations. The complete chain of one.

CTC Compatible Products for Commtest® Instruments

Introduction  Exceptionally long life & high switching speeds.  Non contact, zero operation force.  Wear & maintenance free operation.  Bounce free.

1 FREE CLIMBER 4400 ASSEMBLY INSTRUCTIONS PART NUMBER

CTC Compatible Products for the CSI 2120 & 2130 Data Collectors

Printed 10/7/2011 SCOUT, REV5, WIRING KIT, GUIDE SONAR Connector: JST Length: 6.5 inches 28AWG Start: BreakFly End: Sonar 0, 1 FEMALE Connector: JST.

AMP 20 Pin Female D26 - Male (high density) Pin 1 Video 0 Pin 1 - Video 0 Pin 2 GND (Video 0)Pin 10 - GND (Video 0) Pin 3 Video 1Pin 2 - Video 1 Pin 4.

Pickle Power Production by Mrs. Luevand

Physics Electricity in the home. Direct current (d.c.) is an electric current that always flows in one direction. Made by batteries. Electronic circuits.

1 LIGO-G V5 LLO CDS Components Front End Computer Timing Master 18VDC18VDC I/O Extension Timing Fanout 24VDC24VDC Chassis DC Power AC VoltageAC.

Raymond Giron, Adam Bahr, George Asbeck.  Originally developed by HP in the 1960’s  Wanted an easier way to interface the instruments and controllers.

Airmar H2183 Heading Sensor

Developed by Allan Goodger Moss Vale TAFE From Boards originally developed by Ken Postill Ultimo TAFE.

Typical product developments and applications JF Daucourt Product Development & Quality Manager.

University of Minnesota Unmanned Aerial Vehicle Research Lab Common Harness Wiring Instructions.

ITAR Restricted Data THEMIS Power Subsystem CDR Peer Review 6/14/04 Probe and Probe Carrier Harness Dave Manges (301)

QBPM System Installation Systems –Rack mount chassis –LO and CAL RF cable plant ( need 714Mhz from eels bedroom) –Down mix boxes –DC power cable plant.

Dual PD Amp Circuit Board Test Results By Alexa Staley LIGO G v1 1.

Smart Agent Installation Required Customer Connections 5 Core Power Cable To Laser Head 1.Power To Laser Head 2.Ethernet 10/100 Connector 3.Mains Input.

Front End Board (16 channels) Superlayer Cross Section Frontend Enclosure HV cap board HV cap Board Signals from chamber wires go to HV cap board to be.

P:\ISO \Work Instructions\Assembly\Options\ARMADILLO SWEEPER OPTIONS\10X ARMADILLO SWEEPER OPTIONS MODEL: KIT-MFG-ENG SHDN DSL M&FS SWA.

Springs and Fasteners in Industrial Prints

1 D DC Power Extension Cord LIGO-D V4 1 This concept diagram emphasizes the DC Power Extension Cords. LIGO- D Options 01 and 03.

Cable for UPAMD Steve Sedio Foxconn 8/02/2011. Requirements: Power, 25 milliohms max – AWG selected by worst case resistance and operation at 50C Signal.

WIRE REPAIR. TROUBLESHOOTING STEPS l Confirm the Complaint l Study the electrical schematic l Locate and repair the fault l Test the repair.

YJQ-W1Q Pneumatic Crimping Tool Instruction GENERAL INFORMATION 1. YJQ-W1Q is widely used for the crimping of wires and contacts in electronic connectors.

What is wrong with these plugs? L N E L N E L N E.

1 Sensors and Switches... WHAT’S IN THE BOX? 2 Sensors and Switches... SENSORS, CORDSETS & PROX SWITCHES.

ETHERNET CABLE TYLER THORNBURG LTEC STRIPPING AND CUTTING First you will need to strip the wire. I used scissors to cut off the rubber around.

PL-8C E PICTURE SPECIFICATIONS FEATURES

24VDC Adaptor Pigtail This adaptor pigtail is used to connect +24VDC to IO Extenders. When used in conjunction with the IO Extender On/Off Switch, strain.

CONSTRUCTION OF SEPAM CONFIGURATION CABLE (CUSTOM CCA783 CABLE)

D Sequencer – Insertable

음향 시스템 사양서 POWER SUPLY WITH 3.5 PHOENIX CONNECTOR AMX: PSN6.5

Controller Rework.

Quick Reference Troubleshooting

Visual Instructions.

स्वयचलित आकाशकदिल बनवणे

SPD cable length and rack location

Coaxial Cables & Connectors

Module 1 – Power Supply AMC APS-PBC-60

Back & Front panels FRONT VIEW BACK VIEW ZSX ZSX ZSX ZSX ZSX 4

Electrical components and systems

RIDDLE If you screw a light bulb into a lamp socket by turning the bulb towards the right with your right hand, which way would you turn the socket with.

Replacing TrueAir Thermostat with Ecobee SI

E22158 ST1 to STNG kit A SeaTalk1 port 12vdc RS130 E way R52131

Presentation transcript:

Chassis Subsystem Electronics Rack DC Power Supply Rack MM M M M M M M M M M F F F F F F F F F F F F F F FF M M F F AC X 24 M M M M FF FF F F F F 1 DC Power Extension Cables Extension Cords DC Power Extension Cords Power Strips DC Power Strips Power Supplies DC Power Supplies Pigtail Cords DC Power Pigtail Cords LIGO- D Options 01 and 03 LIGO- D Options 02 and 04 LIGO-D DC Power Extension Cord LIGO-D

DC Power Extension Cords 2 Standard 3-foot cords, molded backshells and screws on both connectors M F M F D Opt 02 Yellow 16/3 13A McMaster-Carr 8046K13 Cable D Opt 02Conec 303W3CPXX42A10X Connector D Opt 02Conec 303W3CSXX42A10X Connector D Opt 04 Yellow 12/3 25A McMaster-Carr 8046K16 Cable D Opt 04Conec 303W3CPXX42A10X Connector D Opt 04Conec 303W3CSXX42A10X Connector D Opt 01 Orange 16/3 13A McMaster-Carr 7394K33 Cable D Opt 01Conec 3003W3PXX42A10X Connector D Opt 01Conec 3003W3SXX42A10X Connector D Opt 03 Orange 12/3 25A McMaster-Carr 7394K13 Cable D Opt 03Conec 3003W3PXX42A10X Connector D Opt 03Conec 3003W3SXX42A10X Connector LIGO-D

D DC Power Extension Cord - Connectors LIGO-D Plus Return Minus 18 VDC A1 A2 A3 Plus Return Minus 24 VDC A1 A2 A3 D Options 01, 03+/- 18VDC MaleConec Part Number3003W3PXX42A10X D Options 01, 03+/- 18VDC FemaleConec Part Number3003W3SXX42A10X D Options 02, 04+/- 24VDC MaleConec Part Number303W3CPXX42A10X D Options 02, 04+/- 24VDC FemaleConec Part Number303W3CSXX42A10X Connectors

LIGO-D Plus Return Minus 18 VDC A1 A2 A3 Plus Return Minus 24 VDC A1 A2 A3 D Option 01 OrangeSJTW16/313AMcMaster-Carr 7394K33 D Option 02 YellowSJEOOW16/313AMcMaster-Carr 8046K13 D Option 03 OrangeSJTW12/325AMcMaster-Carr 7394K13 D Option 04 YellowSJEOOW12/325AMcMaster-Carr 8046K16 Cable D DC Power Extension Cord - Cables

D Option 01 – DC Extension Cord - BOM LIGO-D TLAVersionOptionDescription D V101 DC Power Extension Cord (+/- 18V, 10A) Orange ItemPart TypeDescriptionDesignatorManufacturerSupplier Supplier Part NumberQuantityUnit 1Wire Orange SJTW AWG 16/3 13A Stranded18V Cable McMaster- Carr7394K333ft 2Connector Conec 3 Pin Socket Connector Solder cup 20A, Riveted Conec 3Connector Conec 3 Pin Plug Connector Solder cup 20A, Riveted Conec 4Backshell Molded Backshell with 4-40 screws +/- 18VDC 10A (Used between DC Power Strip and 18VDC Chasses)

D Option 02 – DC Extension Cord - BOM LIGO-D TLAVersionOptionDescription D V102 DC Power Extension Cord (+/- 24V, 10A) Yellow ItemPart TypeDescriptionDesignatorManufacturerSupplier Supplier Part NumberQuantityUnit 1Wire Yellow SJEOOW AWG 16/3 13A Stranded24V Cable McMaster- Carr8046K133ft 2Connector Conec 3 Pin Socket Connector (2 Female, Center Male) Solder cup 20A, Riveted Conec 3Connector Conec 3 Pin Plug Connector (2 Female, Center Male) Solder cup 20A, Riveted Conec 4Backshell Molded Backshell with 4-40 screws +/- 24VDC 10A (Used between DC Power Strip and 24VDC Chasses)

D Option 03 – DC Extension Cord - BOM LIGO-D TLAVersionOptionDescription D V103 DC Power Extension Cord (+/- 18V, 20A) Orange ItemPart TypeDescriptionDesignatorManufacturerSupplier Supplier Part NumberQuantityUnit 1Wire Orange SJTW AWG 12/3 25A Stranded18V Cable McMaster- Carr7394K133ft 2Connector Conec 3 Pin Socket Connector Solder cup 20A, Riveted Conec 3Connector Conec 3 Pin Plug Connector Solder cup 20A, Riveted Conec 4Backshell Molded Backshell with 4-40 screws +/- 18VDC 20A (Used between DC Power Strip and 18VDC Chasses)

D Option 04 – DC Extension Cord - BOM LIGO-D TLAVersionOptionDescription D V104 DC Power Extension Cord (+/- 24V, 20A) Yellow ItemPart TypeDescriptionDesignatorManufacturerSupplier Supplier Part NumberQuantityUnit 1Wire Yellow SJEOOW AWG 12/3 25A Stranded24V Cable McMaster- Carr8046K163ft 2Connector Conec 3 Pin Socket Connector (2 Female, Center Male) Solder cup 20A, Riveted Conec 3Connector Conec 3 Pin Plug Connector (2 Female, Center Male) Solder cup 20A, Riveted Conec 4Backshell Molded Backshell with 4-40 screws +/- 24VDC 20A (Used between DC Power Strip and 24VDC Chasses)