Simulation geometry 2000 V terminal Vacuum Glass substrate, ε = 5.8 Resistive coating, ε = 6.8 and σ = 1e-8 S/m The pore has a 40μ diameter and 40:1 aspect.

Slides:



Advertisements
Similar presentations
SOGANG UNIVERSITY SOGANG UNIVERSITY. SEMICONDUCTOR DEVICE LAB. Power MOSFET (3) SD Lab. SOGANG Univ. BYUNGSOO KIM.
Advertisements

ANL MCP #145 Phosphor Tests 1/24/2011 Incom substrate, 33mm diameter, ANL MCP#145 20µm pores, 8° bias, 60:1 L/D, 65% OAR Chemistry 2 resistive layer, MgO.
Coolidge X-ray Tube. + High voltage - Anode cathode Cooling fins A Vacuum Low ac voltage Gas envelope A X-rays.
Impacts of Inductive and Conductive Interference due to High-Voltage Lines on Coating Holidays of Isolated Metallic Pipelines René Braunstein.
CH. 3 Solar Cell Basic III: Principle Organic Materials for Electronics and Photonics II.
Previous Lecture 12 Voltage Dividers with Resistive loads.
Systems of magnetic dipolar particles with shifted dipoles Details to be found in the poster.
Photomultiplier Tube. What is it? Extremely sensitive detector of light in the ultraviolet, visible and near infrared Multiplies the signal produced by.
David Seebacher, AEC’09, CERN, Switzerland Impedance of Coatings.
10 Picosecond Timing Workshop 28 April PLANACON MCP-PMT for use in Ultra-High Speed Applications.
Comparison of Field Emission Behaviors of Graphite, Vitreous Carbon and Diamond Powders S. H. Lee, K. R. Lee, K. Y. Eun Thin Film Technology Research Center,
Facilities and Program for Coating 8” Plates Jeffrey Elam, Anil Mane, Qing Peng, Joseph Libera Argonne National Laboratory LAPD Collaboration Meeting June.
A tour of the chip D.G.Ast. Not well aligned ! Transistors T1 and T2 share a gate contact. The smallest transistors is T4. To right is the first Diode.
1 Ankit D. Mohapatra, Dr. Marcus Hohlmann Florida Institute of Technology, Melbourne, Florida Barry University, 8-9 March, 2013.
ECE340 ELECTRONICS I MOSFET TRANSISTORS AND AMPLIFIERS.
Charge relaxation times Z. Insepov, V. Ivanov. Glass conductivity.
Discharge tube phenomena Electric discharge tube.
O. Siegmund, UCB, SSL 1 Incom substrate, 33mm diameter, ANL#103 20µm pores, 8 deg bias, 60:1 L/D, 65% OAR Electrode deposited last (on top/bottom) ANL.
Atomic Layer Deposition for Microchannel Plates Jeffrey Elam Argonne National Laboratory September 24, 2009.
3.TRANSISTOR CIRCUIT CONFIGURATION
Update on Physical Parameters that influence Timing Jean-Francois Genat LPNHE Paris LAPPD Electronics & Integration Review July 9th 2012, Chicago.
Atomic Layer Deposition for Microchannel Plate Fabrication at Argonne
Sergey Antipov Argonne Wakefield Accelerator group Z. Insepov, V. Ivanov The Direction of the E-field in Glass Pores.
Chapter 26 Electromagnetism. Mass of Electron Determined by J.J. Thomson Determined by the deflection of the electron in a cathode ray tube.
1 1. Provide better power/ground distribution Increased static capacitance due to thinner core Lower power/ground plane transient impedance due to larger.
Electrostatic FEA of the Ground Plane Features Bo Yu Sept. 14, 2015.
HOW FAST IS A NANOSECOND?. ONE-BILLIONTH OF A SECOND!!!
Gain and Time Resolution Simulations in Saturated MCP Pores Valentin Ivanov, Zeke Insepov, Sergey Antipov 1 First Author Institution, 2 Second Author Institution,
(8”x8”) MCPs Resistance Measurements Oct 04, 2011 Anil Mane, Jeffrey Elam.
Electric Fields and Potential. Electric Fields Every electric charge is surrounded by an electric field – the area around an electric charge where electric.
Development of Large-Area Photo-detectors: MCP development S. Antipov, Z. Insepov, V. Ivanov Abstract Electric field inside high gain microchannel plate.
P. Chaiyabin1, J. Lomon1, Prayoon Songsiriritthigul1. , P
PDEs in shells; Example: current conduction in a steel tank
Date of download: 10/3/2017 Copyright © ASME. All rights reserved.
European DHCAL Meeting 13/06/08
A 3D Atomistic Quantum Simulator for Realistic Carbon Nanotube (CNT) Structures Objective: Investigate the electrostatic effect of the 3D environment.
RESISTANCE.
Thevenin Theorem Any combination of batteries and resistances with two terminals can be replaced by a single voltage source e and a single series resistor.
Volume 111, Issue 10, Pages (November 2016)
Created by Mr. Gable Technology Education Maple Grove Junior High
Nanocrystal Diamond SEE Layer for MCP’s
ALD work status and next plan Nov
Single 20µm MCP Phosphor Tests 7/27/2010
Development of Large-Area Photo-detectors:
G. Palacios 02/25/18 E_y field as a function of anode vertical position for 200kV CEBAF gun upgrade G. Palacios 02/25/18.
CD: Cross Section During manufacturing, plastic is impressed with microscopic bumps arranged as a single, continuous, extremely long spiral track of data.
MCP from Glass Substrates
Heritage from the LOFT-M3 study: Collimator Assembly
Background magnetic field and holding coil simulation
Impedance & Bandwidth Measurements of '2-strip anode test plate'
Sergey Antipov Simulations Sergey Antipov
200 kV gun CST microwave studio simulations Shield modifications
Impedance & Bandwidth Measurements of '2-strip anode test plate'
Impedance & Bandwidth Measurements of '2-strip anode test plate'
200 kV gun CST microwave studio simulations Shield modifications
Chapter 27 Problems 1,11,12,15,16,22,32,33,36,49,56.
RESISTANCE.
What number is the arrow pointing at?
Large area Inconel coatings
Poster ID: FIP/P7-26: Preventive measures to avoid electrical arcing incidences in SST-1 PF current leads As a preventive measure to mitigate arcing inside.
Volume 111, Issue 10, Pages (November 2016)
ALD work status and next plan Nov
Gabriel Palacios 09/04/18 Tests for Joe Gabriel Palacios 09/04/18.
Incom MCP 20µm Substrates 7/27/2010
Ohm’s Law & Circuits Chapter 7.2 & 7.3.
Ballistic miniband conduction in a graphene superlattice
ELECTRICITY & MAGNETISM Electrical Resistance (P )
ALD on MCPs updates LAPD group meeting presentation 10/16/2012
Practice Geometry Practice
Fig. 2 Gate and magnetic field dependence of the edge conduction.
Presentation transcript:

Simulation geometry 2000 V terminal Vacuum Glass substrate, ε = 5.8 Resistive coating, ε = 6.8 and σ = 1e-8 S/m The pore has a 40μ diameter and 40:1 aspect ratio Resistive coating is 1μ thick 2000 V terminals are 20μ thick Simulation is full scale 3D Single pore at this point cathode ground cutout

Electric field streamlines The voltage on the cathode is 2500V. MCP voltage is 2000V. Some field lines do not enter the pore. Edge effects Field alignment along the pore

Edge Effects in the pore

Color: |E|; Arrows & streamlines: Electric field 2000V

Yes, It is a 3D simulation