Single Ended Line Test with Upgraded ECFL 30

Slides:



Advertisements
Similar presentations
Digital Current Transformer Reporter
Advertisements

Trouble Shooting with ELQ 30 CROSSTALK BRIDGED TAPS INTERRUPTION UNBALANCE Typical Cable Problems ELEKTR NIKA To learn more click on the selected topic!
Importing Data into IX1D v 3 – A Tutorial © 2006 Interpex Limited All rights reserved Version 1.0.
ELEKTR NIKA Upstream Power Back Off (UPBO) The Problem is: Upstream bit rates on long loops are dramatically reduced. Very high-speed digital subscriber.
ELEKTR NIKA VDSL 2 Vectoring The Problem: The bit rate of VDSL2 lines is limited by the crosstalk noise. Typical a cable bundle comprises several tens.
Application Notes for Line Testing with ET 91 To learn more click on note! Single Sided Measurements END to END Measurements LCL Balance Impedance Return.
To learn more click on the selected method! Typical Cable Faults Unbalance Recommended Fault Location Method Disturbing voltage ▼ Murray ▼ Küpmüller ▼
Automatic xDSL Test Sequences of ELQ 30A
Application Notes for Frequency Division Multiplex System Testing with ET 91 To learn more click on note! Basic, Super & Master Group Voice Frequency Noise.
ELEKTR NIKA To learn more click on the selected topic! Manual End to End Measuring Modes of ELQ 30A ► ► ► ► ► ► Loss Measurement with MTTS Group Delay.
Automatic Single Sided Test Sequence of ELQ 30A To learn more click on the selected topic! ELQ 30A provides single sided test sequences to estimate the.
FREQUENCY CONTROL MODES OF ET 91 To learn more click on note! END to END Loss Measurement Group Delay Distortion Measurement Frequency Tracking with Sweep.
Ethernet over VDSL Technical Specifications. Agenda –Rate – Reach –Band Allocation –SNR and BER –PSD mask and Power Backoff Algorithm –Rate Limitation.
20101 The Physical Layer Chapter Bandwidth-Limited Signals.
1 Lab #7 – Thevenin/Norton Activity #1 – finding the Thevenin/Norton Equivalent for the function generator –The function generator is a voltage source.
FREQUENCY CONTROL MODES OF ET 92 To learn more click on note! END to END Loss Measurement Group Delay Distortion Measurement Frequency Tracking with Sweep.
Trouble Shooting with EFL 10 Insulation Faults Flooded cable R b ≠ R aC b ≠ C a Typical Cable Problems Which one is the Proper Fault Location Method ?
TRANSMILLE PATs The New Alternative To Fast, Easy & Efficient Portable Appliance Testing.
Arctic RS-485 / RS-422. RS- 485 Also known as RS-485 Half Duplex, RS wire same pair is used to transmit and receive data only one device can transmit.
ELG4125 Transmission and Distribution Systems
8000 SERIES INTEGRATED THE INTEGRATED REFERENCE SOLUTION PRECISION DIGITAL MULTIMETERS.
Single Ended Measuring Modes of ELQ 30A To learn more click on the selected topic! ELEKTR NIKA Receiving Modes Impulse Noise Measurement Spectrum Analyzer.
Transmission Lines No. 1  Seattle Pacific University Transmission Lines Kevin Bolding Electrical Engineering Seattle Pacific University.
 “A multimeter is an instrument designed to measured electric current, voltage and usually resistance, typically over several ranges of value”.
Long Time Spectrogram Measurement with ET 91 The results are displayed on a 3 dimension picture ■ The time is on the vertical axis ■ The frequency is on.
Communication Markets Division © 3M All Rights Reserved. 965AMS Autotest Training.
Channels of Communication HL – Option F.4 Mr. Jean April 22 nd, 2014.
Automatic Voice Frequency Test Sequences of ELQ 30A To learn more click on the selected topic! The Automatic Master-Slave Measuring mode is intended for.
Which one is the Proper Fault Location Method ?
A Training Presentation On 220 KV GSS CHOMU,JAIPUR
XDSL Line Tester Modem EX 30M ELEKTR NIKA EX 30M is a handheld, cost-effective test set to check DSL services and the copper cable capability. It is a.
PLC Testing with ET 91 Level Test Set To learn more click on note! Pilot Level Measurement on RF Test Point Measurements in Special Tracking Mode Pilot.
Frequency Division Multiplex System Testing with ET 92 To learn more click on note! Basic, Super & Master Group Voice Frequency Noise END to END Measurements.
Downstream Power Back Off (DPBO)
Manual Measuring Modes of ELA 10 To learn more click on the selected topic! Level, Loss Noise, Spectrum Line Parameter Optional Measurements Transmitting.
FREQUENCY CONTROL MODES OF ET 91 To learn more click on note! END to END Loss Measurement Group Delay Distortion Measurement Conventional Setting Modes.
Huawei xDSL solution(ADSL2+ and VDSL2 solution) - Huanetowrk.com
Measurement and Instrument. Ohm Meter -Equivalent Circuit-
Single Ended Measuring Modes of ELQ 30A+
To learn more click on the selected system!
VDSL 2 Vectoring ELEKTR NIKA
Manual End to End Measuring Modes of ELQ 30A+
Trouble Shooting with EFL 10
Automatic xDSL Test Sequences of ELQ 30A+
Trouble Shooting with ELQ 35
Single Ended Line Test with Upgraded ECFL 30
Telephone & Exchange Tester ETET 30
xDSL Line Tester Modem EX 30M
Telephone & Exchange Tester ETET 30
Trouble Shooting with ELQ 30
VDSL 2 Vectoring ELEKTR NIKA
Automatic Voice Frequency Test Sequences of ELQ 30A+
Chapter 9. High-Speed Digital Access: DSL, Cable Modems
Which one is the Proper Fault Location Method ?
Which one is the Proper Fault Location Method ?
Downstream Power Back Off (DPBO)
xDSL Line Tester Modem EX 30M
Downstream Power Back Off (DPBO)
Single Ended Line Test with Upgraded ECFL 30
xDSL Line Tester Modem EX 30M
Automatic Single Sided Test Sequence of ELQ 30A+
Manual Measuring Modes of ELA 10
Manual Measuring Modes of ELA 10
VDSL 2 Vectoring ELEKTR NIKA
Automatic Test Sequences in Master-Slave Mode
Upstream Power Back Off (UPBO)
Automatic Test Sequences in Master-Slave Mode
Trouble Shooting with ELQ 30A+
Upstream Power Back Off (UPBO)
Presentation transcript:

Single Ended Line Test with Upgraded ECFL 30 The purpose of this advanced test option is to upgrade the services of ECFL 30/ELC 30 test set with two important measuring modes: • Single End Loss Estimation up to 30 MHz • Automatic Single End Pair Qualification The upgrade provides an economic solution for ECFL 30/ELC 30 test set owners because the upgrade is obviously much cheaper than the price of a new instrument. In several cases the upgraded ECFL 30 is suitable to replace a new instrument. Single End Loss Estimation up to 30 MHz Automatic Single End Line Qualification To learn more click on the selected topic! ELEKTR NIKA

Single End Loss Estimation The loss estimation is based on the measurement of physical parameters of tested cable. The applied test method consists of two measurement groups: ■ Measurements with open loop ■ Measurements with closed loop The far end is automatically closed /open with the help of the remote controlled switch ELC 30 ■ Selectable Frequency Ranges: 1,5, 3, 9, 12, 18 and 30 MHz ELEKTR NIKA

Automatic Single End Line Test The upgraded ECFL 30 provides single end test sequences to estimate the data transfer capacity of the tested lines used for different VDSL, ADSL2, SHDSL etc. systems. During the test sequence ECFL 30 performes several DMM and transmissive tests like: DMM Tests: ■ AC, DC Voltage a-b, a-E, b-E ■ Insulation Resistance a-b, a-E, b-E ■Capacitance Cm, Ca-E, Cb-E ■ Loop Resistance ■Loop Length Transmissive Tests: ■ Loss Estimation ■ Noise Measurement at near end Estimation at far end ■ S/N Calculation at near end Estimation at far end ■ Data Transfer Speed Prediction Up & Down Stream ■ Bit allocation (b) For VDSL & ADSL ELEKTR NIKA

Test Setup and Start ELEKTR NIKA Having the START/STOP key pressed ECFL 30 starts the automatic test. When the test program is completed the short form result page appears providing immediate PASS/FAIL information The reason of failure is marked by asterisk ELEKTR NIKA

Detailed Results of VDSL and ADSL Qualification ELEKTR NIKA

THANK YOU FOR YOUR ATTENTION!