Install Instructions August 1, 2008

Standard Knock-out plates need to be removed from the machine

You will receive a Template in your User Manual for all Knock-out Plates

For the four small holes – use a 7/32 drill bit For the two larger holes – use a 3/8 drill bit Carefully drill holes on the appropriate Knock-out plate to the exact dimensions of our template. Reinstall Knock-out plate on the machine before adding Microtronic Msmart hardware.

Finished Product

This is what you receive in your Msmart Kit Reader Velcro Reader Antenna or Head MDB Connector Cable Cable from “Reader Head plug” to “Head” Cable from “ANT” on Reader to plug on “Head”

Plug in details White plug from “Head” to “HEAD” port on Reader Cable with Gold plug on both ends for “ANT” port on Head MDB Cable will connect with Black end into “VMC” port on Reader White MDB plugs go from the Vending Machine and Validator or Coin Mech

Before Installation Make sure all power is turned off to the Vending Machine Have pre-drilled Knock-out Plate ready You will need a Phillips Head Screwdriver and an 11/32” Nut Driver On National Vending machines you may also need a ¼” Nut Driver for easier removal of the Knock-out Plate

Connection to the Vending Machine Reader mounted with Velcro provided in kit Make sure cables are not in the way by strapping them together. Cables from Reader to Head Predrilled Knock-out Plate installed Head is mounted with 4 screws provided in kit

Green Light is “Ready to Go”

Vending Machines with Keypad Press “Machine Config” Arrow down to “Card Reader” Select “MDB CARD” Arrow down to “Revalue” Select “ON” if you want the machine to also Load Value to the Microtronic Media or “OFF” if not. Press “Exit” You should then have a “Green” light and you are again... READY TO GO!