Smart Vehicle Tracker Installation Guide AVT-2000B V2.10

All materials contained on this documentation is protected by the copyright law and may not be reproduced, transmitted, published or broadcasted without the prior obtaining authorization of GPS Designer International CORP.The documentation is provided for testing, evaluation, integration and product information purpose and it may contain deficiencies or inadequacies information of products. This product is not intended for use in life support appliance, devices or systems where a malfunction of the product can reasonably be expected to result personal injury. GDIC or its supplier will not be liable for any consequential, direct, indirect, incidental, punitive or other damages including without limitation, damages for loss of business profits, business interruption, loss of business information or other pecuniary loss that arising out the use of or inability to use the documentation or product, even if GDIC has been advised of the possibility of such damages. The customers using or reselling the product in such application do so at their own risk and agree to full indemnify GDIC for any damages resulting from illegal use or resale. Subject to change without notice at any time. General Notes:

1. Introduction of Hardware: Insert the SIM Card: Insert the backup battery Install the Cable: Power/Input/Output Cable: Connect “USB” Cable: Mount the Device LED Indicators: Table of Content

1. Introduction of Hardware

2. Insert the SIM Card Please follow the steps below to insert the SIM Card correctly. a. Unscrew the back cover of device and pull out the lid by sliding lock to the right side. b. Uplift the battery (if the battery is connected to the device) c. Unlock the SIM card slot by sliding the holder toward the “OPEN” direction. d. Place the SIM card into the SIM card holder. e. Lock the SIM card slot by sliding the holder toward the “LOCK” direction. f. Then, put back the battery and screw the back cover of the device. Please ensure the SIM card is well placed in the holder and well contacted; otherwise, the device might not detect the SIM card successfully.

4. Install the Cable: 4.1 Power/Input/Output Cable: This connector includes power, positive/negative digital inputs, and negative digital outputs. The pin assignment is following:

3. Insert the backup battery Please follow the steps below to insert the backup battery correctly. a. Unscrew the back cover of device and pull out the lid by sliding lock to the right side. b. Connect the cable to the socket in the corner and place the battery well. c. Then, put the cover of the device back and screw it well.

4.2 Connect “USB” Cable: USB Cable can be used for the unit configuration. All input and output ports might not be working properly if the main power is NOT connected.

5. Mount the Device Please refer to the following: a. Please inlet the holding metal bars to the two sides of the device body. b. Then, screw the metal bars onto a flat place.