1. Using the Arduino to Make an LED Flash Work in teams of two! living with the lab 1 1 14 digital I/O pins (I/O = input / output) USB cable plug power pins 6 analog input pins © 2012 David Hall

2. living with the lab 2 The content of this presentation is for informational purposes only and is intended only for students attending Louisiana Tech University. The author of this information does not make any claims as to the validity or accuracy of the information or methods presented. Any procedures demonstrated here are potentially dangerous and could result in injury or damage. Louisiana Tech University and the State of Louisiana, their officers, employees, agents or volunteers, are not liable or responsible for any injuries, illness, damage or losses which may result from your using the materials or ideas, or from your performing the experiments or procedures depicted in this presentation. If you do not agree, then do not view this content. The copyright label, the Louisiana Tech logo, and the “living with the lab” identifier should not be removed from this presentation. You may modify this work for your own purposes as long as attribution is clearly provided. DISCLAIMER & USAGE

3. The Circuit 470  digital I/O pin 0 living with the lab 3 NOTE: It would probably be better to use a different pin than digital pin 0 since this pin receives information from your computer through the USB cable. The RX printed beside pin 0 and the TX printed beside pin 1 mean “receive” and “transmit,” respectively. digital pin 0

4. enter and run the following sketch Enter and run the following sketch: void setup() { // initialize the digital pin as an output: pinMode(0, OUTPUT); } void loop() { digitalWrite(0, HIGH); // set the LED on delay(1000); // wait for a second digitalWrite(0, LOW); // set the LED off delay(500); // wait for 500 ms } living with the lab 4

5. how the sketch works HIGH = 5V and LOW = 0V (Always!!!!) void setup() { pinMode(0, OUTPUT); } void loop() { digitalWrite(0, HIGH); delay(1000); digitalWrite(0, LOW); delay(500); } initialize pin 0 as an output infinite loop set pin 0 to LOW (0V) wait 500 ms set pin 0 to HIGH (5V) wait 1000 ms time (ms) voltage (V) 0V 5V 500 ms1000 ms living with the lab 5

6. Now Experiment on Your Own! (1)Try changing the time to 1.5 seconds on and 1 second off (2)Connect the resistor to digital pin 5 and change the program to match (3)Blink out SOS in Morse code (dot-dot-dot-dash-dash-dash-dot-dot-dot) a.three short pulses (0.25 seconds each) followed by... b.three long pulses (0.75 second each) followed by... c.three short pulses (0.25 seconds each) followed by... d.a brief pause (1 second) e.repeat a through d using an infinite loop Show your instructor when you have completed exercise (3) living with the lab 6

7. Find each command in the reference section of arduino.cc (discuss each command with others at your table) void setup() { // initialize the digital pin as an output: pinMode(0, OUTPUT); } void loop() { digitalWrite(0, HIGH); // set the LED on delay(1000); // wait for a second digitalWrite(0, LOW); // set the LED off delay(500); // wait for 500 ms } The End living with the lab 7