Programming Software and Setting

if forget the IP address of SB-DN-1IP, programmer can press the reset button till the led goes red, then it is reset and the IP is SB-DN-1IP Programming Module Data interchange for HDL-BUS and TCP/IP Reset without Power off Intelligent Data Transfer Remote programming

Before Programming, Make sure that programming module and PC are at the same IP segment E.g., IP : Router IP: ☺ PC IP Setting Set the PC at the same IP segment as SB-DN-1IP, * (*<255) IP setting Communication setting

* Another way to test and double check IP setting, Programmer can do as following steps: “Start”  “Run” ， input “cmd” and confirm, then input “ping X ” （ IP of SB-DN-1IP), to see the communication is ok or not. Picture 1Picture 2 Communication setting

HDL-BUS Pro Setup Tool software is used to program all on-line devices. Software introduction

You can not find SB-DN-1IP in the device list, but you can find it by Step1: HDL-BUS software  Devices  Bus switchboard Programming

Step2: select a device to view status and edit We can see the SB-DN-1IP, and all devices which linked to current SB-DN-1IP. Programming

Step3: View/Edit network parameter Programming The default port : 6000 Make sure the device’s IP and PC’s IP are at the same IP segment, but the IP and IP MAC should be different from one module to one module, they should be unique.

Programming Step4: View/Edit configuration Switchboard ID(Device ID): ID remark of SB-DN-1IP Subnet ID: set current HDL-BUS subnet ID. remark 1 IP port switch board offers a subnet ID for all HDL-BUS devices which linked to the current SB- DN-1IP

Software HDL-bus Programming software main page Menu Toolbar

1 、 Click this Button to search device Device search

1 、 Select 255 to search all on-line devices 2 、 Click Search Device search

1. Searched devices 2. Add all searched devices Device search

1 、 on-line device List 2 、 double click to enter into the setting page of the device Device search

2.2 Device IP manage Select Address management Note: It is an effective way to solve the device ID overlap issue. PS: address management uses MAC to communicate. Add Manage

2 、 Right click or double click for modify device MAC address 3 、 Set subnet ID and Device ID according the MAC address, then Save. 2.2 Device ID manage

1 、 press this button 3 seconds to activate the ID addressing function(LED goes red) 2 、 Select ”Modify address ”to re-set its ID. Add Manage

3 、 Click “indicate initial address”, 4 、 input new ID, then click “Modify initial address ”, it will be saved and the LED will be off. Add Manage