1. Curtain Motor
HDL-MWM70B.12
HDL-MVSM45B.12

2. HDL-MWM70B.12
HDL-MWM70.12 contains master motor (MWM70B.12) and slave motor (MWM70S.12). It is the curtain controller, the master can be controlled by HDL Buspro. It supports manual mode and it has over load protection and over heat protection.

3. Installation

4. Indicator

5. Basic Information Remark: Indicate some information, it is
better to manage the device.
Modify subnet ID: Can modify the subnet
ID and device ID of the curtain motor, and
the subnet ID should be same as the
Gateway.

6. Motor running Motor running: Auto off when power on:
the default mode is 'Forward',
if now control curtain to open, then it's opening, means the running mode is correct; if it's closing, means need to select 'Backwards' mode.
Auto off when power on:
if choose, when the motor power off and then power on again, the motor will close automatically.

7. Drag mode No Action: Free mode, end-user can
manually drag the curtain to any
position.
Long Drag: Drag the curtain to the
setting length, the curtain will fully
open or fully close
Short Drag: Drag the curtain to the
setting length, the curtain will fully
open or fully close

8. Test for installation
This step is very important, it is used to measure the curtain distance! It has two ways to measure.
Method one:
(1): Keep pressing the programming button for 5s, the LED will flash 1 time/2S, the curtain enters into the testing mode.
(2):The motor will measure moveable distance for the rail automatically (Open-close), when the motor stops, finish.
(3): Short press the button, change the curtain status, if you press the button 1 time, the curtain will open, stop or close.
(4): If it works properly, keep pressing the button for 5S, it will exit the testing mode.

9. Test for installation Method two:
In the setting page, click the ‘Start’, the curtain will measure distance automatically,
when it stops, will exit the test automatically.

10. Test It is used to display the curtain info
Curtain switch: It is used to control the curtain directly from software. It supports to stop, open close, percentage control
Adjust ON/OFF: When you want to reset
the open or close position, you can manually
drag the curtain to the position you want,
then click 'save'

11. Panel Setting

12. HDL-MVSM45B.12
HDL-MVSM45B.12 is the tubular motor. It can control the roller shutter by HDL Buspro.
It has overheat protection.

13. Features Support open, close, stop and percentage control
Communication: HDL Buspro
AC motor is power source, provide enough power, it can make the torque of tubular motor big enough
Overheat protection
Support online upgrading.
The settings are similar to HDL-MWM70B.12