1.Take holster off phone if applicable 2.Verify antenna is completely inserted 3.To insert antenna slot: 1.Hold antenna button atop phone while inserting antenna 2.Release button to lock antenna into place NOTE: Antenna must be completely inserted It is completely inserted when antenna easily locks/snaps/clicks into the 95° position to either left or right

When talking on the phone, antenna should be vertical with ground Keep in mind if you rotate satellite antenna down, your call will be dropped Make sure antenna has and maintains “line of sight”

For OPTIMAL performance, the antenna must be able to “see” the entire sky Nearby tall buildings or similar structures, heavily leafed trees, mountains, etc. can degrade performance if they block signal between equipment’s antenna and satellites

5 bars are ideal on the signal strength indicator Signal strength indicator will fluctuate in normal cases If no or continued low signal check your “line of sight”

1.Fully extend phone antenna straight up so it has a clear 360° view of the sky 2.Turn phone on and allow time for full signal strength and registration to process 3.Dialing sequence: [00] [country code] [area code][local number] to U.S to another iridium sat phone xxx xxxx 4.Press green “OK” button 5.You will hear several beeps and then ringing before connection

1.Make sure you have long-distance international dialing capabilities from your landline 2.Dialing sequence: [011] [8816] [xxx] [xxxx]

Phone is on & antenna is fully extended The phone rings and/or vibrates, the status indicator light will also be alternating red & green When ‘Call, Answer?’ is in display, press the OK button You will see ‘Connected’

Phone is on & antenna is stowed Phone chirps up to 3 times to alert you of an incoming call Phone displays “Call Attempt” YOU MUST rotate and fully extend antenna quickly to receive call You will see “Iridium Call Attempt”, DO NOT attempt to answer until phone rings or vibrates When phone does ring or vibrate you will see “Call, Answer?” in display, press “OK” button You will see “Connected”

After a few seconds during a call you will see “End Call?” At anytime during a call, you can press “OK” to end the call.

It is necessary to set this up while phone is registered – meaning you will have to be outside or connected with external antenna Press the “Message Button”, it will state ‘Call Voic ?’, press ‘OK’ It will display your satellite phone number, press ‘OK’ Display will state ‘Calling’ Your call will be forwarded to your voic box, press * to interrupt the greeting and then enter the last seven digits [ ] of your sat phone number and follow the set-up guide

Press “message key” Select “Call Voic ” Press “OK” The satellite phone number will appear (e.g ) and “Call?” Press “OK” Interrupt voic greeting by pressing ‘*’ –or-automated menu will ask for password Wait for prompt to enter password – the last seven digits of your satellite phone number

Charging the phone Car antennae

Ho ward Tiemann Government Account Manager Toll free: Technical Support Toll free: Intl: Iridium phone: