Program PAL using BP by Svilen Piralkov

Running BP Win Open BPWin from the Deskop When Registration prompt appears click “NO”

Main Window Click “Device” to select the PAL to be used

Select Device Choose “Lattice GAL22V10/B/BQ/C/D” and click “Select” Verify that the Device selected is the same as the chip used.

Main Window Once the device is selected click “Data Pattern” to load the JED file

Data Pattern Make sure “Hexadecimal” is selected Click “Open”

Load File Click “Browse…” to choose the JED file to load it to the PAL

Select a File Select the file and click Open

Load File Click OK

Data Pattern Click OK

Main Window Verify that the “Device” and “Data Pattern” are the ones desired Check the following boxes: Continuity Erase Program Verify & Test Twice Secure & Test Twice Click “PROGRAM”

Program PAL Click “Ok”

Fuse Warning If this window appears click “Ignore” After programming the device the software should return back to the main window

PAL Programmed No errors should appear and “Function Complete” should be displayed at the bottom.