ParrotBot is a parrot robot that says hello as moving its beak and wings. Parrot

1. Put Motor Frames on Battery Case and fix with 40mm Supports. Assembling

2. Overlap L-type 2x6 Frames and L-type 2x2 Frames and fix to Support with bolts. Assembling

3. Connect 2 30mm Supports each and fix Motor Frames and Supports to CPU Board with bolts and nuts. Assembling

4. Fix Voice Board and Support that is fixed to CPU Board with bolts then fix it to Motor Frame that is fixed to Battery Case with bolts. Assembling

5. Fix Motor Frame to Main Frame with bolts. Fix 35mm Support and 20mm Support to Main Frame with bolts. Assembling

6. Fix 35mm Support to Main Frame with bolts. Put Small 4 Frame on Motor Guide and fix with bolts and nuts. Fix Servo Motor to 35mm Support with nuts then insert Motor Guide to Servo Motor axle. Assembling

7. Fix L-type 2x6 Frame and L-type 2x2 Frames to Option Frame with bolts and nuts. Assembling

8. Fix 10mm Support to L-type Frame with bolts. Fix Small 5 Frame to Support with Nylon Nut. Assembling

9. Fix 7mm Support to L-type 2x2 Frame with a bolt. Fix Small 5 Frame to Support with a Nylon Nut. Assembling

10. Fix Small 5 Frame to Small 4 Frame that is fixed to Motor Guide with 3x10 Bolt and Nylon Nut. Fix L-type Frame that is fixed to Option Frame to Support that is fixed to Main Frame with Nylon Nut. Assembling

11. Fix L-type 2x6 Frame to L-type 2x2 Frame with bolts and nuts. Put L-type 2x2 Frame on Support that is fixed to Main Frame and fix with 20mm Support. Assembling

12. Fix Main Frame which Servo Motor is fixed and prepared Main Frame with a nut. Assembling

13. Insert Controllable nut to 75mm axle then put it between Main Frames and fix with 15mm Support. Assembling

14. Put L-type Frame on Controllable nut and fix with bolts. Assembling

15. Insert 3x10 Bolt to Main Frame then insert Caterpillar Wheel Guide to 3x10 Bolt and fix with bolts. Fix Sound Sensor Board to Motor Frame with bolts. Assembling

16. Fix Small 8 Frame and L-type 2x2 Frame with bolts and nuts. Fix Small 5 Frame and Small 4 Frame to Small 8 Frame with bolts and nuts to make a crest. Assembling

17. Put Remocon Receiving Board and a crest on Motor Frame that is fixed to Main Frame and fix with bolts. Assembling

18. Put a head of parrot (Main Frame) on a body (Voice Board) and fix with bolts. Assembling

19. Overlap 3 Middle Frames each and fix with bolts and nuts to make wings. Assembling

20. Put wings on Support and fix with nuts. Assembling

21. Connect Power Cable of Battery Case to Power Connector of CPU Board. Connect Servo Motor Cable to OUT Port 1 of CPU Board. Assembling

22. Connect 3Pin Cable to OUT Port 2 of CPU Board and Voice Board. Connect 3Pin Cable to IN Port 1 of CPU Board and Sound Sensor Board. Assembling

23. Connect 3Pin Cable to IN Port 7 of CPU Board and Remocon Receiving Board. Assembling

24. Completed ParrotBot. Assembling

Setting Position of Starting Point Radius of Rotation Set starting point of servo motor Set starting point of servo motor