Job Performance Requirement 14-15 Hoisting Ladders by Rope.

Slides:

Advertisements

Similar presentations

Ground Ladders.

Advertisements

35 FOOT LADDER 3 PERSON.

CVFD Training – Ladder Practices

Ladder Safety Today’s topic is Ladder Safety. This training is a part of OSHA’s Portable Wood and Metal Ladder Safety Standards (29 CFR ). You.

Ladder Safety Today’s topic is Ladder Safety. This training is a part of OSHA’s Portable Wood and Metal Ladder Safety Standards (29 CFR ). You.

Ropes and Knots Skill Drills.

1 Risk Management Department Ladder Safety July, 2006.

Lashing.  A means of fastening two poles (or spars) together Qualities of a Good Lashing  Firmness – it should be string and tight, or else it is likely.

ROPES State of Georgia BASIC FIRE FIGHTER TRAINING COURSE.

Firefighter III Module C Ropes.

Safety Briefing By C/CMSgt William Pruitt. Safety for personnel Long pants are required All obstacles will have safety guides in case of emergency. It’s.

North Idaho Emergency Services Academy. Objectives Types of fire service laddersTypes of fire service ladders Ladder termsLadder terms Ladder raising.

Job Performance Requirement 14-5 Two-Person Beam Raise.

Energy Coffee Can Racer Lab

Ladders Skill Drills.

5/18/2015Dixon High School Fire Department1 Introduction The Recruit will also practice and masters certain skills and will be tested on these skills.

FVCC Fire Rescue LADDERS.

4/19/2017 Ground Ladders Brantley County Firefighters Association Monthly Training Conducted by the Atkinson Volunteer Fire Department December 2008 Atkinson.

PULLING FIBER OPTIC CABLES

8/15/2015 Perkins AP Calculus AB Day 12 Section 2.6.

Tujuh Bukit Project Indonesia Field Response Team Knots

14’ Roof Ladder Beam Raise Level I 4/1/12. Introduction This presentation demonstrates the basic operation of a one person beam raise. The evolution begins.

12 Ladders Skill Drills. 2 Objectives Perform one-, two-, three- and four-FF carries. Perform one-, two-, three- and four-FF raises. Tie the halyard.

Search and Rescue Skill Drills.

Job Performance Requirement Tying a Figure Eight on a Bight.

Job Performance Requirement Modified Gasner Bar Pack.

Part C  Accordion load  Lay the first length of hose in the bed on edge against the partition with the coupling at the rear of the bed  At the front.

Ropes and Knots Skill Drills.

35’ Ladder Beam Raise Two Person Level I 4/1/12. Introduction This presentation demonstrates the basic operation for a two person beam raise. The evolution.

Job Performance Requirement 14-2 Shoulder Carry. JPR 14-2A A The shoulder carry is useful for operations when firefighters will carry a ladder a good.

Ladders Module 2. Introduction The fire service ladder is one of the most basic fire fighter tools. Ladder technology has not changed much over the years.

North Vancouver City Fire Department Firefighter Down! R.I.T. Rope Rescue The Big ‘W’ ‘Dirty Rescue’

Job Performance Requirement 14-7 Three-Person Raise.

Job Performance Requirement Removing Tempered Glass.

Search and Rescue Skill Drills.

Job Performance Requirement 14-8 Four-Person Ladder Raise.

Job Performance Requirement Tying a Rescue Knot.

Photo by University of Houston Digital Library - Creative Commons Attribution-ShareAlike License with.

3 PERSON PERPENDICULAR RAISE LD35’-2

STRAIGHT ARM WALL LADDER RAISE LD16’-4

STRAIGHT WALL LADDER OVERHEAD RAISE LOW SHOULDER CARRY

Two Person Low Shoulder Raise and Carry

2 Person 24’- Carry LD24’-2 The 24’ ladder is on the ground with the fly section down The recruits will prepare for a low shoulder carry 12/7/09.

2 PERSON PIVOT If the ladder is not in the proper position for extending the fly The butt person will give the command to pivot the ladder.

3 PERSON LADDER PIVOT If the ladder is not in the proper position to extend the fly The butt person will give the command to pivot the ladder.

FVCC Fire Rescue LADDERS PART B.

Job Performance Requirement 15-10

Job Performance Requirement 14-1

Job Performance Requirement 10-11

9 Ropes and Knots.

Job Performance Requirement 16-6

9 Ropes and Knots.

Job Performance Requirement 15-11

Job Performance Requirement 20-1

Job Performance Requirement 16-10

2 Person 28’- Carry LD28’-1 The 28’ ladder is on the ground with the fly section down The recruits will prepare for a low shoulder carry 12/7/09.

Job Performance Requirement 10-28

Job Performance Requirement 15-21

Job Performance Requirement 15-9

Job Performance Requirement 16-7

Job Performance Requirement 10-27

Job Performance Requirement 16-8

Job Performance Requirement 16-8

Job Performance Requirement 15-3

Job Performance Requirement 15-14

North Carolina Fire & Rescue Commission Ladders I Updated 9/2011

Presentation transcript:

Job Performance Requirement Hoisting Ladders by Rope

JPR 14-15A A A bowline or a large figure of eight on a byte knot is tied at one end at a point that will create a loop that is 9 feet in circumference or at least sufficient for the bowline knot to rest above the next set of rungs.

JPR 14-15B B The middle of the ladder is ascertained by counting rungs. Once the middle is established, the firefighter counts up two rungs and passes the rope through the hole that the rungs create. Strips of electrical tape or painted bands can be used to semipermanently identify these rungs. With the ladder on the ground, the butt (or base) of the ladder is gently lifted and the rope slid up to the marked rungs while the slack rope is taken up.

JPR 14-15C C The knot should be approximately in the center of the ladder between the beams. The ladder is then rolled over so that the rope runs under the ladder rungs and is arranged to be between the ladder and the building.

JPR 14-15D D The command to hoist may be given. The tip will tend to lean away from the building and prevent the ladder tip from snagging on any projections caused by windowsills, protruding brickwork, or any other structural element that might cause difficulty. Once the rope knot is at the point of raising, the ladder is pivoted on the edge of the structure and gently pulled down on the roof. Then the remaining portion of the ladder is pulled onto the roof.