MULTIPIN CONNECTOR CONNECTION RADIALL P/N 691803004 Receptacle for cable and for 52 socket contacts A1932AP RADIALL P/N 691802002 Plug for cable and for.

Slides:



Advertisements
Similar presentations
HV Cable Suitable to sustain up to 15 kV Cable characteristics: 1.According CERN safety instruction IS 23 2.Single conductor- = 0.16 mm 3.Conductor resistance.
Advertisements

Twisted Pair Cable Dense assembly (OD 5-7 mm) with –Twisted pairs : total 21; 44-pin mm dual row Omnetics connector differential signals single-ended.
A/V Connectors & Cables. Chasis Mount Connector A connector that is built into a piece of equipment.
1 Cable Assembly for CanSat. 2 Heat Shrink Tubing Battery Pack Connection Pin Connectors Radio Cables Mic & Speaker Plugs See close up connection page.
Component Symbols & Information Prof. Dr. Moustafa M. Mohamed Vice Dean, Faculty of Allied Medical Science, Pharos University in Alexandria.
Sales Presentation November 2010
Using three IR sensors, SensingBot can sense the front obstacles so it can avoid them. Sensing.
BumperBot uses two contact switches to go through a labyrinth. Bumper.
Connecting Speaker Level Outputs to Harman Amplifiers.
NA62 GTK Cables & Patch Panels. TCC8_GTK1 TCC8_GTK2_GTK3.
Power supply cable Charge injection 3 channels readout (external cables to the scope) 3 channels readout (internal cables) Set up for reading two cards.
RPC Electronics Overall system diagram –At detector –Inside racks Current status –Discriminator board –TDC board –Remaining task.
PCB Layout Design. PCB Layout Special Layout Considerations 4 in.
BLM FOR THE INJECTORS PROJECT CABLING NON-CONFORMITIES LIU-PSB Working Group Meeting (15/08/2013) Christos Zamantzas
FanBot is a fanning robot using High-speed DC Motor. Fan.
Configuring a PC. Installing the Mother board To Install the Mother board, fit it into the computer casing. You will then need to Insert 24 pin ATX power.
Subject: Mixed Connectors !!! ? What is it ? Why ? Provider? Samples….
1 LIGO-G V1 Magnetometer DC Power Assessment Magnetometers are distributed in the corner station and both end stations. The complete chain of one.
CTC Compatible Products for Commtest® Instruments
TOPIC-MAKING CONNECTION OF ONE SWITCH AND ONE SOCKET
43.35” (LENGTH OF INNER LIQUID HE RESERVIOR)  CONNECTION CHAMBER: FF 4.75”  FF: FLANGE-TO-FLANGE DISTANCE 10.45” TO 12.45” 6.35” TO 8.35” (JACK -2” TO.
ISR Work Progress Report Muon Week April 10 th 2003 A. Benvenuti INFN Bologna.
CTC Compatible Products for the CSI 2120 & 2130 Data Collectors
CONNECTORS and PLUGS USED FOR WIRING PA SYSTEMS Follow this link to find out the difference between a signal and speaker cable:
ST/PRM3-EU | | © Robert Bosch GmbH reserves all rights even in the event of industrial property rights. We reserve all rights of disposal such as copying.
Your Connectivity Partner. Locations Main Office: High Tech Products Lallio, Italy USA Office: HTP Connectivity Parsippany, NJ.
HBD FEM the block diagram preamp – FEM cable Status Stuffs need to be decided….
AIDA 1 Mezzanine board Contacts for underside connectors Thermal contact pads.
Some questions:  In which order cables will be put ?  Who, where will put PS signal cables in bundles ?  Which kind of cable binders: velcro or panduit.
Oct 29, 2001 Ron Sidwell 1 Purple Card. Oct 29, 2001 Ron Sidwell 2 Purple Card Spec Two channels per printed circuit board Size ~20 sq. in. or best effort,
The AFTER electronics from a user’s point of view D. Attié, P. Colas Mamma meeting,CERN Feb T2K electronics.
LUCID services G Avoni - D. Caforio LUCID BOLOGNA meeting1 Main topics: HV scheme (additional connections in pocket) Temperature probes New.
Lecture 4 Connectors RJ 45, RJ 11, BNC & Fiber Cable Connectors.
XMA Connector Purpose: Objectives: Content:
Front End Board (16 channels) Superlayer Cross Section Frontend Enclosure HV cap board HV cap Board Signals from chamber wires go to HV cap board to be.
Connectors & Cables © D. J. McMahon rev
Design of High Voltage System Kyungju Ma & Reno Collaboratiors
Notes taken from Gillette’s Designing with Light.
12 September 2006Silicon Strip Detector Readout Module J. Hoffmann SIDEREM SIlicon Strip DEtector REadout Module.
Copyright ©2014 , JAE Electronics, Inc. Confidential DW Series Overview JAE May 2014 Battery Connectors for Power Storage.
12/10/01 - Cecilia Gerber UIC Slide 1 Testing Card specifications l Will be used in the Run2b SASEQ-based test stands  needed. Build 75, two.
Chiho Wang ATLAS TRT Duke University IU, Oct Fuse Box Design & Mounting Chiho Wang Duke University.
Belle-II iTOP HVB Status SLIDE FOR INCLUSION IN GARY’S PRESENTATION Belle II General Meeting Gerard Visser Indiana University CEEM 11/13/2012.
Chiho Wang ATLAS TRT Duke University CERN, Feb Fuse Box & Capacitor Status Chiho Wang Duke University.
PandaX 实验中的电子学概述 郭国栋 Outline Introduction Original scheme Improved scheme PMT base design in PandaX I and PandaX II Decoupler design in.
TRIPLEGEM and VFATs at The Test Beam Area TRIPLEGEM and VFATs at The Test Beam Area N. Turini……reporter Eraldo Oliveri! Eraldo Oliveri main worker! N.
A few points that need discussion today (Gerard) UH needs golden front boards (2?), golden HVB (1), and HV cabling to PS with the correct connectors. IU.
ATLAS TRT Duke University CERN, Feb Fuse Box Status Duke University.
Large GEM prototype production NS2 technique. Reminder NS2 technic 10 to 15mm Readout connector O-ring Drift electrode Free to slide External screws to.
VARITECTOR SPC Signal Pluggable Connection Surge Protection for Control and Instrument.
Test Tube Activities at Ohio State (7/29/03) Amphenol/Spectra Strip will send two 10 m long samples of signal cable –With a (round) jacket, shielding –20.
Test beam straw prototype production status
CONSTRUCTION OF SEPAM CONFIGURATION CABLE (CUSTOM CCA783 CABLE)
1: Connect turntable to phono pre-amp using an audio cable Audio Plugs
on behalf of the AGH and UJ PANDA groups
MODULAR I/O DL 351 MIDAS NAME MODEL 제조사
Mini-drawers, FE-ASIC , Integrator
POWER AMPLIFIERS E 5:4 LAB.GRUPPEN NAME MODEL 제조사 General
Electronics for RPC Upscope
Multi-Function Connector Proposal (11-118r0)
UPS Connectivity Options: PPDM ( )
P5 Gladys Nzita-Mak.
Motherboard and its component What is Motherboard? Location Function.
. . SDSU Controller Internal Cabling
Overview of T1 detector T1 is composed by 2 arms
HCAL HV splice box.
Testing of the EMCO Prototype Boards
General wiring procedure for a new instrument
Back & Front panels FRONT VIEW BACK VIEW ZSX ZSX ZSX ZSX ZSX 4
. . SDSU Controller Internal Cabling
Presentation transcript:

MULTIPIN CONNECTOR CONNECTION RADIALL P/N Receptacle for cable and for 52 socket contacts A1932AP RADIALL P/N Plug for cable and for 52 socket contacts RADIALL P/N Plug for cable and for 52 socket contacts RADIALL P/N Receptacle for cable and for 52 socket contacts CERN P/N Shielded 56-conductor HV cable HV Decoupler Box PartQuantity ( )priceOrdering status ( 25 )Required quotation to radiall (50),, (3000),, (3000),, (400),, m6.6 SF

Mod. A1932A front pannel Components of front pannelExternal connectors Output Channels(1…48), Floating Ground(FAGND), IINT IEXT Multi connector Radiall Type, 52pin male( to be mated with Radiall ) FAGNDRadiall R socket, 2mm AGNDRadiall R socket, 2mm PASSIVE INTERLOCK00-type LEMO connector SIGNAL INTERLOCK00-type LEMO connector CodeDescription WA1932APAAAAA1932AP-SY1527H.V.channels+3kV/500uA- Multipin Conn.(48ch) WA995XAAAAAAA995-insertion/extraction tool Radiall for A996 WA996XAAAAAAA pin cable connector for A173XB- A183XB-A1932A-A1535 Ordering Option External Connections and Ordering option

Needed partNeeded parts