Deconstructing a Hubsan and Rebuilding Build Your Quadcopter Deconstructing a Hubsan and Rebuilding

Hubsan and New Parts

Hubsan Parts Parts you will reuse Propellers 4 Motors 4 Flight controller board 1 Parts you will NOT reuse Camera 1 Propeller Protector 1 Black rubber feet protectors 4 Battery Mount 1 Lights 4 Top and bottom of frame Various small screws

New Parts Carbon Fiber X frame 1 White Motor Mounts 4 Black Carbon Fiber base 1 White Risers 4 Small Black Screws 4 Small Black Nuts 4 Small clear rubber bands 4 Propeller Remover Metal 1 Rubber Bands 2

Disassemble Hubson Using metal tool remove 4 propellers Pull off propeller guard protector Pull off rubber feet 4 Loosen 2 tiny screws on bottom of quad Break 4 landing legs by pulling straight down behind the motors Remove 4 screws from battery mount Pull out battery mount Pull camera out of front hole.

Keep Disassembling Remove 2 screws that hold flight controller to frame Use pointed tool to loosen colored motor wires and light wires (copper wire) and gently pull them out Remove 4 motors carefully by using pliers and pulling up and twisting carefully. The motors are also magnets Take to Bob do unsodder and resodder You are now down with disassembly.

Assembling New Quadcopter Attach double sided tape square to X frame Clean out 4 white motor mounts with pick if necessary Attach 4 white motor mounts to frame Insert 4 motors. Motors have 2 different sets of wires. These need to be diagonal to each other Press Flight Controller (FC) onto double sided tape.

Keep Assembling Push motors through motor mounts until flush. Avoid touching the flight controller board Take large rubber band and stretch over flight controller twice Put large rubber band around base until it fits snugly Take 4 long black screws and insert in each corner of base Screw 4 white spacers over each black screw Slide tiny white rubber bands over motor mounts to hold wires in place. Slide to middle of frame arm

Almost Done Slide base through 4 holes on frame and secure with tiny black nuts onto black screws. Identify propellers by A and B. Attach propellers to correct spots. Insert battery on top of quadcopter under rubber band Plug battery in Go flying!

All Done!