Last updated: 6/28/2016www.alto-shaam.com Rotisserie Training Rotisserie.

Slides:

Advertisements

Similar presentations

WHIRLPOOL Vertical modular Washer

Advertisements

ELECTROLUX REFRIGERATOR

Variable Frequency Drives Bypass Options

Sequential Process Control

Engineer Training Machine Electrical Cabinet TJ8300 / TJ8500 Machine Electrical Cabinet (EC)

Operating Functions.

inFire HTC speed Furnace Webinar

MEYRA CAN. MEYRA CAN MEYRA CAN remote module identical remotebox for many wheelchair models identical remotebox for many wheelchair models mechanically.

WIRED TYPE MULTI ZONE FANCOIL CONTROL SYSTEM MODEL : WSF- 700 SYSTEM

VIDEOCON SBS REF. Display panel Water dispenser Castors REF Compartment Door handle FRZ Compartment.

3” BACKWASH VALVE WITH SUPERSTAR ACTUATOR BASIC SERVICE MANUAL Does not apply to PLC-MP version SUPERSTARS.

Heating Control Devices

1 Direct Fired Gas Heating Presented by Jim Jagers of Applied Air.

MAINTENANCE APPLICATIONS. MAINTENANCE APPLICATIONS FOR MOTOR COACHES.

In this presentation you will:

Futera III Wiring Diagram Presentation G.

©2011, The McGraw-Hill Companies, Inc. Chapter 4.

Graphic Symbol Location 1. DIN Terminal X52 The machine is powered by electricity using copper cable with 5 wires (3 phase wires + neutral wire +

GO ORDNANCE !!! ORDNANCECORPS 1 Antenna Mast Group We will now trace the electrical circuits of the antenna mast mast group. Be fore we get started you.

Elec467 Power Machines & Transformers

Engineer Training XL1500 Safety System. Engineer Training XL1500 Safety System Confidential 2 Standard Requirements Both the machine and the Safety System.

SOLAR TRACKER PROJECT. INTRODUCTION: Solar tracker is a system that is used to track sun light to increase the efficiency of electricity gained from solar.

MAINTENANCE APPLICATIONS FOR MOTOR COACHES. DURING REGULAR MAINTENANCE CYCLES, APPLY TERMIN-8R ® TO ALL VEHICLE ELECTRICAL AND MECHANICAL COMPONENTS:

Marubot Football League Service Manual.

Engineer Training Electrical Cabinet (EC) TJ8300 / TJ8500 Electrical Cabinet (EC)

Ultra Roasting Oven X3000. Goals A micro-controlled rotisserie Cooks to user desired level Easy to use interface.

Copier Jam Detector Design Problem

2013 Microwave Service Training All models. Samsung HA Warranty ALL Warranties are subject to change, always verify. 1 Year Parts & Labor Base Warranty,

Engineer Training Electrical System Overview and Requirements.

ELECTRIC RANGE.

VLT Diagnostics Click on the button above your Keypad.

Engineer Training UV Electrical Cabinet (16 and above) TJ8300 / TJ8500 UV Electrical Cabinet (Machines 16 and above)

HYDRONIC HEATING AQUASTATS

Continue The information provided in this training module covers the schematic flow charts for all ovens and ranges that utilized a preheat board, Self.

Operation Sabbath Mode - SELECT PROGRAM - Lights, alarms and fans Normal Sabbath Overview.

Control Technology and Automation

BAKE BROIL - SELECT PROGRAM - CONV BAKE CONV BROIL SELF CLEAN On any diagram screen, double click any of the following components to bring you to a description.

Throw Pole Throw Pole nc no. Electric symbols Single pole single throw normally open Single pole single throw normally closed double pole single throw.

PROGRAMMABLE LOGIC CONTROLLER (PLC) AND AUTOMATION

Engineer Training UV Electrical Cabinet (1-15) TJ8300 / TJ8500 UV Electrical Cabinet (Machines 1-15)

Interactive Control in Engineering Projects Electronics and Control.

Continue FCU150 Trash Compactor. Normal ModeDelay Mode.

To complete installation on electronic models run one wash cycle then click the DIP switch setting no.4 to the on position DIP switch settings.

Working “Control any electrical device with your T.V remote(any brand)” wizardelectronics.weebly.com.

Service Section Technical Training December 2005.

4) Design the logic to control the motor on a simple remote control car. There are two buttons on the remote control for the motor. If neither button is.

Last updated: 6/6/2016www.alto-shaam.com Halo Heat Training Cook & Hold OvensHolding Cabinets.

6/9/2016 Quick Reference Parts Guide Introduction This Quick Reference Parts Guide is an easy way to locate part numbers to common replacement parts. It.

NN-CS596S Steam Microwave Oven. NN-CS596S Oven Specification.

We apply 120 VAC to the HM Unit (Remember to check polarity!) Our primary step down T/X provides power to terminal “X” and “COM” on the ignition control.

Boiler Energy Saver Advanced Boiler Controls. Most boiler controls at present consist of a switch!

All Freezer Advance. When the Freezer is first supplied with power or if a power outage occurs, the display will indicate this by flashing the temperature.

6/23/2016 Quick Reference Parts Guide Introduction This Quick Reference Parts Guide is an easy way to locate part numbers to common replacement parts.

BASIC ELECTRICITY AND MAGNETISM

6/27/2007 Quick Reference Parts Guide Introduction This Quick Reference Parts Guide is an easy way to locate part numbers to common replacement parts.

Start program Start Start Time Duration Counter.

Voyager II and III – Energy Recovery Modules

Quick Reference Parts Guide Introduction

OIL BURNERS CONTROL BOX SERIES 599 SE Riello Burners - TRAining CEntre.

Lesson 14: Introduction To Sequential Control

ET 438B Sequential Control and Data Acquisition

Batteries: the Chemistry

Copier Jam Detector Design Problem

ACOE347 – Data Acquisition and Automation Systems

Confidential Oilfree Scroll Compressor 　　Simplex/Multiplex SRL kW 　　Troubleshooting Hitachi Industrial Equipment Systems Co., Ltd. Air Compressor.

AUTOMATIC AIR-CONDITIONING SYSTEM OPERATION

Presentation transcript:

Last updated: 6/28/2016www.alto-shaam.com Rotisserie Training Rotisserie

Electric Rotisserie Model AR-7E 208V or 240V 1PH or 3PH Stackable AR-7E over AR-7E AR-7VH over AR-7E AR-7E over AR-7H AR-7VH over AR-7E over AR-7H Last updated: 6/28/2016www.alto-shaam.com

AR-7E Rotisserie Last updated: 6/28/2016www.alto-shaam.com Electronic Control 7 Spit Removable Carousel Drip Guides Drip Tray w/ Drain Door Gasket

AR-7E Oven Cavity Last updated: 6/28/2016www.alto-shaam.com Convection Fan CoverConvection Element and Fan Wheel

AR-7E Oven Cavity Last updated: 6/28/2016www.alto-shaam.com Drive Shaft Upper Radiant HeatersCavity Air Sensor Slave Bearing

AR-7E Components Last updated: 6/28/2016www.alto-shaam.com Service Part Access Convection Fan Motor Drive Motor Electrical Assembly

AR-7E Components Last updated: 6/28/2016www.alto-shaam.com Electrical Assembly 208V-12V Step Down SC-15 Fuses Top - Light Transformer Bottom – Light Transformer and Drive Motor Radiant Heat Contactor Convection Heat Contactor

AR-7E Components Last updated: 6/28/2016www.alto-shaam.com Power Supply Board VAC Input 12 VDC Output Door Switch

AR-7E Components Last updated: 6/28/2016www.alto-shaam.com Convection Motor Fail Switch Switch Actuator

AR-7E Components Last updated: 6/28/2016www.alto-shaam.com High Limit 527°F Trip, Manual Reset High Limit Bulb Location

AR-7E Components Last updated: 6/28/2016www.alto-shaam.com 5 Cube Relays Oven Light Transformer Upper Heat Contactor Lower Heat Contactor Convection Fan Motor Drive Motor

AR-7E Components Last updated: 6/28/2016www.alto-shaam.com Cavity Air Sensor Air Sensor Connection Block Radiant Element Access

AR-7E Control Operation Last updated: 6/28/2016www.alto-shaam.com Power to Unit Control Off No Display – No Operation

AR-7E Operation Last updated: 6/28/2016www.alto-shaam.com Power Up Hold Mode Oven Lights On Displays/Heats to last set hold temp Cavity Sensor Below Set Point = Convection Fan On Fail Switch Closed Convection Element On Displays available presets

AR-7E Operation Last updated: 6/28/2016www.alto-shaam.com Cooking Mode – Pre Heat Pre Heat Cavity to 400F (Regardless of Set Pt) Cavity Sensor Below Set Point = Convection Fan On Fail Switch Closed Convection Element On Cavity Sensor Satisfied = Pre heat complete READY Light Illuminated Cook, time, hold all lit

AR-7E Operation Cooking Mode – Cook 1 or 2 Pre Heat Complete, Start Button Pressed Carousel Runs the entire cycle Cavity Sensor Below Set Point = Convection Fan On Fail Switch Closed Convection Element On Radiant Heaters On Cavity Sensor Above Set Point = Elements Off Time Expired = Drop into HOLD Mode (4HR Max) Last updated: 6/28/2016www.alto-shaam.com

AR-7E Operation Last updated: 6/28/2016www.alto-shaam.com Displays when a program has been manually stopped Displays when door is open JOG Function active when “door” displayed

AR-7E Service Last updated: 6/28/2016www.alto-shaam.com Pull pin to remove the door