SB-DN-SEC250K security module SB-DN-SEC250K can manage 8 independent zones’ arming and alarm. Addressing button HDL -BUS

Work flow SB-DN-SEC250K Arm/disarm: Enable/disable security function Buzzer: To urge the owner/trespasser to disarm/leave Siren: Alarm (check more detailed doc for workflow ftp://59.41.255.150/documents/miscellaneous/)

SB-DN-SEC250K Setup steps: Check firmware versions of sensors and security module. (A video has been made to attach to this PPT. ftp://59.41.255.150/softwares/HDL%20tutorial%20video/module%20tutorial%20video/12.%20security%20module/) Enable the security function of sensors. Register the sensors in security module and refresh, see if the security module can get the status of sensors. (also you can set some indicators in security module, so that when arming fails you would know which sensor channel fails - e.g., window1 still open, door2 still open…) Choose DLP as a user interface to arm and disarm. (better to use DLP because DLP has password for every page – long press the first button and fourth button at the same time to jump to setting page, ftp://59.41.255.150/documents/miscellaneous/) Register the panel in security module Find a SD card (<8GB, recommend to use Kingston card) and format it as FAT32, create a folder and name it “special”, put some voice files (.mp3 and sort them with a header “001”, “002”, “003”… - check the video). Check the universal switch list of Z-Audio, especially the “208”, “150” (150 is reserved for folder “special”) and “1-149”. Fill in targets in security module and have a test. (check the video) Check the “security workflow.doc” (ftp://59.41.255.150/documents/miscellaneous/)

SB-DN-SEC250K Sensor setting Assign this channel of sensor to one area of security module. Enable security function Same settings can be applied to other channels.

Security module has built-in battery and so has real time. SB-DN-SEC250K Basic information Almighty password:888,888 Read history: free Delete history: password needed. Security history Security module has built-in battery and so has real time.

SB-DN-SEC250K Enable security function of security module. Enable security function

Register sensors in logic module SB-DN-SEC250K Register sensors in logic module Security module should be able to get the status of sensors. Enable and register the sensors Set sensor type Double click to set the indicator targets Generally just leave it unchecked. When arming procedure is started, the security module will check the status of sensors and determine if it is clear to arm, if it is not, the indicator will be triggered.

SB-DN-SEC250K Authorize some devices(generally the user panel) to arm/disarm

SB-DN-SEC250K Set arm and disarm commands in DLP “single on”

SB-DN-SEC250K Check the folder “special” in Z-Audio

SB-DN-SEC250K Check the universal switch list of Z-Audio, “208”, “150” (reserved for the folder “special”) and “1-149”. Download the list - ftp://59.41.255.150/documents/en_PDF/

SB-DN-SEC250K Fill in targets according to customer’s requirements. To do that, it is very important to get familiar with the security workflow. (“security workflow.doc” - ftp://59.41.255.150/documents/miscellaneous/) Below is an example of setting warning sound for “ENTER BUZZER ON” Set warning sound targets