This file contains the PowerPoint presentation for the significant changes to the JFMM applicable to all Volumes with the exception of the Nuclear Addendum.

Slides:

Advertisements

Similar presentations

COMPANY MAINTENANCE MANUAL

Advertisements

Field Orders on Construction Contracts Guidance Document CLC-8 May 13, 2013.

Agenda Introduction Advisory Circular Changes Consultant Selection Procedures Contract Format and Provisions Methods of Contracting and Allowable Costs.

Ensure Vendor/Engineer of Choice Product Quality

NOTE This file contains the PowerPoint presentation for the significant changes to the JFMM with the exception of the Nuclear Addendum section (Part II.

NAVAL REACTORS PROGRAM TMDE Status

Regulation No. 96 Proposal for 03 Series of Amendments GRPE, January 2011 Informal document No. GRPE (61st GRPE, January 2011, agenda item.

RDIT READINESS METRICS FOR FORCE XXI SOFTWARE ENGINEERING DIRECTORATE - CECOM RD&E CENTER US ARMY COMMUNICATIONS ELECTRONICS COMMAND MR. JOSEPH J. POTOCZNIAK.

ACADs (08-006) Covered Keywords Byproduct material, source material, controller, custodian, ORM, sealed source, exempt source, special nuclear material.

SUBSAFE Approved for Public Release

OVERSIGHT & COMPLIANCE BRANCH (OCB) INVOICE PAYMENTS February 16,

Lecture 8. Quality Assurance/Quality Control The Islamic University of Gaza- Environmental Engineering Department Environmental Measurements (EENV 4244)

Quality Management System

Supplementary Training Modules on Good Manufacturing Practice

Quality Assurance/Quality Control Policy

UNIT 3.04 Career Opportunities By PresenterMedia.comPresenterMedia.com.

WLTP DRAFTING TF, "RECORDED" BMW, Christoph Lueginger DISTINGUISH BETWEEN MEASURED AND RECORDED.

QC | Slide 1 of 16 June 2006 Good Practices for Quality Control Laboratories P art 4: Inspecting the laboratory Supplementary Training Modules on Good.

PROPOSALS THE REVIEW OF THE 1958 AGREEMENT AND THE INTRODUCTION OF INTERNATIONAL WHOLE VEHICLE TYPE APPROVAL (IWVTA) IWVTA Informal Group WP th Session.

Unit Introduction and Overview

This file contains the PowerPoint presentation for the significant changes to the JFMM. It has been designed to work with a Word document file that provides.

B O N N E V I L L E P O W E R A D M I N I S T R A T I O N 1 Network Operating Committee (NOC) June 12 th, 2014.

CHAPTER 5 Infrastructure Components PART I. 2 ESGD5125 SEM II 2009/2010 Dr. Samy Abu Naser 2 Learning Objectives: To discuss: The need for SQA procedures.

Pre-Project Activities Text Chapters 5 and 6. Pre-Project Activities 1.Contract Review 2.Development Plan 3.Quality Plan.

24/03/2006 Introduction to IMO Performance Standard for Protective Coating and IACS Common Structural Rules BV Surveyor’s Training Development Department.

IDM Chapter 104 Utility Coordination Joe Gundersen Senior Utility Engineer, INDOT August 21, 2014.

Jason Martin February 2013 Design Section Engineer’s Manual 1.

By: Farzad Dadgari Soil and Environmental Specialist SWHISA.

Commissioning of Fire Protection and Life Safety Systems Presented by: Charles Kilfoil Bechtel National Waste Treatment Plant Richland WA.

EXISTED SITUATION OF HOSPITAL 1.Feasability of the hospital is necessary. 2.Construction Completed as informed. 3.Architectural Detay Drawings Completed.

From Research Prototype to Production

Familiarization with the 2010 Manila Amendments

NCSX Management Overview Hutch Neilson, NCSX Project Manager NCSX Conceptual Design Review Princeton, NJ May 23, 2002.

Project Tracking. Questions... Why should we track a project that is underway? What aspects of a project need tracking?

Matthew Udenenwu Waste Permits Division 2015 TCEQ Environmental Trade Fair.

NAVAL CORRESPONDENCE Topic TERMINAL OBJECTIVES 31.0 Identify the proper format and purpose of Naval Correspondence to include the use of Standard.

1 Resident Management System – Quality Control System Introduction Version 2.35 April 2005.

POLICY & OVERSIGHT DIVISION (POD) February 2014 MILESTONE ACQUISITION PLANS TRAINING 1.

Acquisition of Services DAU Acquisition Community Conference April 17, 2007.

1 EARLY SAFETY MANAGEMENT OF PROJECTS AND EXPERIMENTS HSE UNIT PH DSO EDMS No

Mary Ellen Ley, USGS/Chesapeake Bay Program March 21, 2012.

Configuration Management of Post-Fukushima Regulations CMBG June 2013 David Gambrell Director, Severe Accident Management Southern Nuclear.

AR Revision U.S. Army Inspector General School 1 Revision of Army Regulation Summary of Change.

NQA-1 Evolution 2008 – 2015 Mike Nicol DOECAP ASP Workshop Sept

12/2/2004Module 2A1 The NCSX Engineering Web – An Overview Part I Work Planning, Project Files, Management Plans and Procedures.

REVISION OF THE IPPC DIRECTIVE  DIRECTIVE ON INDUSTRIAL EMISSIONS.

Towards a Glossary of Activities in the Ontology Engineering Field Mari Carmen Suárez-Figueroa and Asunción Gómez-Pérez {mcsuarez, Ontology.

RIPA Quality Assurance Guideline (Draft) RIPA Technical Conference Henry Hotel Dearborn, MI April 30, 2012.

Value Stream Mapping: August 2005 Current State Nancy Terranova October 26, 2006.

BACKGROUND NSTM 300 was completely re-written to clarify and update requirements for today’s increasingly complex shipboard electrical systems. The enclosed.

Regulatory Issues in Laboratory Management

Expert Group Meeting on the Revision of the Handbook on the Management of Population and Housing Censuses New York, 14 – 17 December 2015 Overview of the.

Module 12 - part 2Slide 1 of 23 WHO - EDM Basic Principles of GMP Documentation Part 2 Part One, 14.

CABLING SYSTEM WARRANTY REGISTRATION. PURPOSE OF CABLING REGISTRATION.

HPT Rev. 0 Page 1 of 28 TP-1 TVAN Technical Training Health Physics (RADCON) Initial Training Program Radioactive Materials Handling and Accountability.

Chapter VII Alternative certification January Maritime Training & Human Element Section IMO Familiarization with the 2010 Manila Amendments.

California Department of Public Health / 1 CALIFORNIA DEPARTMENT OF PUBLIC HEALTH Standards and Guidelines for Healthcare Surge during Emergencies How.

6/6/ SOFTWARE LIFE CYCLE OVERVIEW Professor Ron Kenett Tel Aviv University School of Engineering.

WHO - PSM Basic Principles of GMP Documentation - Part 1 Workshop on GMP and Quality Assurance of HIV products Shanghai, China 28 Feb - 4 March 2005 Maija.

0 Design Change Construction & Completion Management (Outline and related procedures) Hanul NPP Engineering Center.

International Data Centre October 2015Page 1 Progressive Commissioning Jerry Carter, Senior Scientist W. Randy Bell, Director Gerhard Graham, Coordinator.

Introduction to Procurement for Public Housing Authorities Small Purchase Procedures Unit 4.

January am.  Acknowledgment of Receipt Form, Page 3  Request for Proposals – Submittal Form, Page 4  Cost Proposal Requested from the top.

NOTE This file contains the PowerPoint presentation for the significant changes to the JFMM. It has been designed to work with a Word document file that.

BSB Biomanufacturing CHAPTER 4 GMP – Documentation Part I (SOP)

NSTM 074 VOL 3 (SERIES) FAMILIARIZATION

Accelerator Operations Department Readiness (Part 2)

Proposed Revision of: NSTM 631 Rev

2016 File Maker pro training for Summer program hiring

How to Use References Chapter 4.

Presentation transcript:

This file contains the PowerPoint presentation for the significant changes to the JFMM applicable to all Volumes with the exception of the Nuclear Addendum section (Part II of Volume V). It has been designed to work with a Word document file that provides the specific changes. The pages of this file correspond to the Word document file included on this CD-ROM (JFMM TRAINING NOTES.doc). NOTE

COMUSFLTFORCOMINST Rev B Change 4

JFMM FOREWORD

Change Request Form Form Modified: Added a processing statement to transmit the form via as “High Importance” if the “Urgent” block is checked.  Added a requirement to include any proposed added or deleted text.  Moved the NMCI address. Foreword;

JFMM Volume I NEW CONSTRUCTION

New Appendix C- CSP Added a new sample message from the Supervising Activity to the Type Commander signaling readiness for Bravo and subsequent Sea Trials. Volume I, Chapter 3, Appendix C-csp; Shore Power Covers:

JFMM Volume II INTEGRATED FLEET MAINTENANCE

CNO Availabilities  Added SUBSAFE responsibilities. Volume II, Part I, Chapter 3, paragraph 3.3.5; Volume II, Part I, Chapter 3, paragraph ); Volume II, Part I, Chapter 3, paragraph ; Volume II, Part I, Chapter 3, paragraph ; Volume V, Part I, Chapter 5, paragraph ); At-Sea Testing - Submarines  Provided guidance for continuing Trials with leakage from unisolable components. Memorandum of Agreement  Modified the sample message to comply with CAN 5-1 of the SUBSAFE Manual. Sea Trials Depth Authorization - Submarines

Fleet Maintenance Availabilities Volume II, Part I, Chapter 4, Paragraph a; Volume II, Part I, Chapter 4, Paragraph 4.4.7; Volume II, Part I, Chapter 4, Paragraph ; Volume II, Part I, Chapter 4, Appendix G; Scheduled CMAV - Submarines  Modified for trimester scheduling.  Minimum requirements to be identified in a Memorandum of Agreement.  New 100 Hour Transition Periods at the start and completion of availabilities.

Fleet Readiness Plan  Inaccurate data/questions require follow through. Volume II, Part II, Chapter 1., Paragraph e; Volume II, Part II, Chapter 2, Paragraph 2.5; Work Candidate Guidelines Work Package Preparation Milestones  Modified to align with the Fleet Readiness Plan.

JFMM Volume III DEPLOYED MAINTENANCE

JFMM Volume IV TESTS AND INSPECTIONS

Diesel Engines Work arising from Pre-Availability Testing will be incorporated into the Work Package. Clarified Initial Routine Inspection. Inspection report to also be distributed to the shipyard/SUPSHIP/NSRO. Volume IV, Chapter 4, paragraph 4.3.2; Volume IV, Chapter 4, paragraph 4.4.c(3); Inspection - Submarines New Construction – Submarines & CVNs Reporting Requirements

Work Authorization & Control Volume IV, Chapter 10, Paragraph ; Volume IV, Chapter 10, Paragraph ; Volume IV, Chapter 10, Paragraph b; Volume IV, Chapter 10, Paragraph d; Changes: Allows distribution per local Memorandum of Agreement Permits the numbering of WAF Revisions and Continuation Sheets to be determined by the software generating them. Clarified how much expected draft change requires entry on SOSMIL. Added three new conditions to be added to the SOSMIL. Submarines Only:

Weight Handling Equipment & Testing Volume IV, Chapter 13, paragraph ; Volume IV, Chapter 13, paragraph ;, Chapter 13, paragraph ;, Chapter 13, paragraph ; Volume V, Part I Chapter 11, QA Form 17W; Changes: Clarified the procedural requirements for fabrication, repair and testing. Identification of Equipment. Witnessing Qualification. Submarines Only: Record Keeping. New QA Form 17W (located in V-I-11).

Reboiler Inspection Volume IV, Chapter 27; New Chapter: Establishes procedures and inspection requirements for Steam Reboilers and support systems.

JFMM Volume V QUALITY MAINTENANCE

In-Process Control Volume V, Part I, Chapter 5, Table 5-6; Volume V, Part I, Chapter 5, Paragraph ; Volume V, Part I, Chapter 5, Paragraph ; Modified data ranges to agree with S9505-AM-GYD-010. Clarifying operational limits of at-sea testing. Clarified the need for a Record of Installation. Torque Requirements Table Voyage or At-Sea Repairs – Submarines Only Exceptions to REC Control – Submarines Only

Departures From Specifications Volume V, Part I, Chapter 8, Paragraph 8.2.1; Volume V, Part I, Chapter 8, Paragraph 8.2.4; Volume V, Part I, Chapter 8, Paragraph 8.2.5; Volume V, Part I, Chapter 8, Paragraph Modified the last sentence for accuracy. Added a NOTE identifying the ability of local technical authority to recategorize in some instances. Reporting Departures Major Departures - recategorization Added new sub-paragraphs for Special Hull Treatment. Aligns with the current E-DFS/E-WD process. Temp Departures for SHT – Submarines Only Extending a Temporary Departure

VOLUME VI MAINTENANCE PROGRAMS

Calibration Responsibility Volume VI, Chapter 9, paragraph 9.2.5; Volume VI, Chapter 9, paragraph 9.7.1; Volume VI, Chapter 9, paragraph 9.7.3; CO is responsible for a high degree of readiness including installed instruments. Calibration Requirements List Added a requirement to calibrate Level I instruments replaced during deployment. T.M.D.E. Markings Clarifies the meaning of “Out of Cal” label.

VOLUME VII CONTRACTED SHIP MAINTENANCE

Contracted Ships Maintenance Changes include Volume VII, Chapter 2, paragraph ; Volume VII, Chapter 2, paragraph ; Volume VII, Chapter 5, paragraph Volume VII, Chapter 5, paragraph j; Updated the Monetary Value for Cost/Pricing Data Threshold. Established Fleet Forces Command as the Authority Directing Estimates be Prepared for Competitive Procurement.