1 MUST HAVE SHOULD HAVE COULD HAVE Module # 140

Practical Class Exercise’s, 2 nd session Objectives: Know how to: –Setup a Flowmeter –add Channel based on a Flowmeter –Add and configure a Flowmeter based MP –Add and configure LIW MP –Add and configure Dump to Empty MP –Use the above Material Paths to do Feeds –Reference: Qi Technical manual.doc Ch 3 – Flowmeter program block Ch 4 – Flowmeter Ch 4 – Assign Channels Ch 4 – Configure Material Paths

3 Class Exercise #1 – Setup a Flowmeter Via the Flowmeter Button Configure Flowmeter (K) –Verify Flowmeter is functioning How ? :Switch to the Flowmeter Channel and manually add water, check to see that the Qi display is counting. Via the PAC Button Add a Flowmeter based Channel, use Channel 3 –Reference: Qi Technical manual.doc Ch 3 – Flowmeter program block Ch 4 – Flowmeter –Refer to next slides after your own attempt.

4 A Configured Flow meter A correctly configured Flow meter example

5 Example of Flowmeter based Channel Note: Some parameters are Instrument capacity dependent

6 Class Exercise #2 Add MP2, GIW & SPILL only –PAC >> Material Paths –Enter required MP number –Configure all Parameters TIP: Save this page as : “Defaults” then this page can be loaded and edited Do some Feeds using this Material Path (refer Module 090) –Check that Feeds are error free with a green screen –Example follows on next slide. Try on Own first

7 A Configured MP2

8 Class Exercise #3 Add MP3, LIW & Dump to Empty –PAC >> Material Paths –Enter required MP number –Configure all Parameters TIP: load previously saved “Defaults” and edit Do some Feeds using this Material Path (refer Module 090) –Check that Feeds are error free with a green screen –Example follows on next slide. Try on Own first

9 A Configured MP3

10 Class Exercise #4 Add MP4, LIW & K1 –PAC >> Material Paths –Enter required MP number –Configure all Parameters TIP: load previously saved “Defaults” and edit Do some Feeds using this Material Path (refer Module 090) –Check that Feeds are error free with a green screen –Example follows on next slide. Try on Own first

11 A Configured MP4

12 Class Exercise #5 Add MP7, GIW use (Flowmeter as the channel) –PAC >> Material Paths –Enter required MP number –Configure all Parameters TIP: load previously saved “Defaults” and edit Do some Feeds using this Material Path (refer Module 090) –Check that Feeds are error free with a green screen –Example follows on next slide. Try on Own first

13 A Configured MP7

Review Questions Can you add a Material Path while still in “Run Mode” ? Can you edit a Material Path while still in “Run Mode” ? What are the Four Material Path “Feeder Types” ? Bonus Questions What is the meaning of the “Assembly Slot” number that is found on the Channel Setup Page? ? Can it be edited