International Symposium on Low Power Electronics and Design Switched-Capacitor Boost Converter Design and Modeling for Indoor Optical Energy Harvesting.

Slides:



Advertisements
Similar presentations
Basic Electronics Ninth Edition Grob Schultz
Advertisements

Lock-in amplifiers Signals and noise Frequency dependence of noise Low frequency ~ 1 / f –example: temperature (0.1 Hz), pressure.
Electronic Engineering Final Year Project 2008 By Claire Mc Kenna Title: Point of Load (POL) Power Supply Design Supervisor: Dr Maeve Duffy.
EE435 Final Project: 9-Bit SAR ADC
Analogue to Digital Conversion
Pixel-level delta-sigma ADC with optimized area and power for vertically-integrated image sensors 1 Alireza Mahmoodi and Dileepan Joseph University of.
Design and Implementation a 8 bits Pipeline Analog to Digital Converter in The Technology 0.6 μm CMOS Process Eri Prasetyo.
NSoC 3DG Paper & Progress Report
1 Dr. Un-ki Yang Particle Physics Group or Shuster 5.15 Amplifiers and Feedback: 3.
A CMOS Front-end Amplifier Dedicated to Monitor Very Low Amplitude Signals from Implantable Sensors ECEN 5007 Mixed Signal Circuit Design Sandra Johnson.
Why prefer CMOS over CCD? CMOS detector is radiation resistant Fast switching cycle Low power dissipation Light weight with high device density Issues:
Design Goal Design an Analog-to-Digital Conversion chip to meet demands of high quality voice applications such as: Digital Telephony, Digital Hearing.
Introduction to Analog-to-Digital Converters
Lock-in amplifiers
Department of Electrical & Computer Engineering 1 ES585a - Computer Based Power System Protection Course by Dr.T.S.Sidhu - Fall 2005 Class discussion presentation.
Digital to Analogue Conversion Natural signals tend to be analogue Need to convert to digital.
Analogue Electronics II EMT 212/4
DC/DC Converter with Transparent Electronics for application on Photovoltaic Panels Romano Torres 19th July Supervisor: Vitor Grade Tavares Second.
Outline Direct conversion architecture Time-varying DC offsets Solutions on offset Harmonic mixing principle FLEX pager receiver Individual receiver blocks.
Servos Servos are everywhere. Elements of servo System -- to be controlled Sensor or detector -- measure quantity to be controlled Reference -- desired.
1HSSPG Georgia Tech High Speed Image Acquisition System for Focal-Plane-Arrays Doctoral Dissertation Presentation by Youngjoong Joo School of Electrical.
Amplifiers: From Ideal to Real Why amplify? Gain = Vout / Vin = sensitivity Ideal Op Amp Negative gain summation amplifier Positive gain for increased.
Digital to Analog Converter for High Fidelity Audio Applications Matt Smith Alfred Wanga CSE598A.
Prof R T KennedyPOWER ELECTRONICS 21. Prof R T KennedyPOWER ELECTRONICS 22 Class D audio amplifiers switching - PWM amplifiers -V cc.
EE445:Industrial Electronics. Outline Introduction Some application Comparators Integrators & Differentiators Summing Amplifier Digital-to-Analog (D/A)
Guohe Yin, U-Fat Chio, He-Gong Wei, Sai-Weng Sin,
Power Management for Nanopower Sensor Applications Michael Seeman EE 241 Final Project Spring 2005 UC Berkeley.
ESE 232 Introduction to Electronic Circuits Professor Paul Min (314) Bryan Hall 302A.
Guy Lemieux, Mehdi Alimadadi, Samad Sheikhaei, Shahriar Mirabbasi University of British Columbia, Canada Patrick Palmer University of Cambridge, UK SoC.
Operational Amplifiers The operational amplifier, also know as an op amp, is essentially a voltage amplifier with an extremely high voltage gain. One of.
12/14/2010Sophia University Solid –State Circuits & Devices Laboratory 1 A low-power delta-sigma modulator using dynamic-source-follower integrators Ryoto.
6.376 Final Project: Low-Power CMOS Measurement System for Chemical Sensors Stuart Laval December 8, 2003.
G7 - Practical Circuits 1 G7 - PRACTICAL CIRCUITS [3 exam question - 3 groups] G7A - Power supplies; schematic symbols G7B - Digital circuits; amplifiers.
THERMAL NOISE ESTIMATION IN SWITCHED-CAPACITOR CIRCUITS
Outline Abstract Introduction Bluetooth receiver architecture
Task List  Group management plan  Background studies  Link budget: optical/electrical  Build, test learning Rx board  Order components for transceiver.
Wireless Power Transfer Via Inductive Coupling SENIOR DESIGN GROUP 1615 RYAN ANDREWS, MICHAEL DONOHUE, WEICHEN ZHANG.
Sound Source Location Stand Group 72: Hiroshi Fujii Chase Zhou Bill Wang TA: Katherine O’Kane.
CMOS Analog Design Using All-Region MOSFET Modeling
M. Atef, Hong Chen, and H. Zimmermann Vienna University of Technology
EXAMPLE 2 – PHOTODIODE A photodiode is a semiconductor device that converts light into current. The current is generated when photons are absorbed in the.
Basics of Bypass Capacitor, Its Functions and Applications.
For more course tutorials visit ECET 310 Entire Course (Devry) For more course tutorials visit ECET 310 Week 1 Homework.
FUNCTION GENERATOR.
32ch Beam-Former for Medical Ultrasound Scanner Performed by : Alaa Mozlbat, Hanna Abo Hanna. Instructor : Evgeniy Kuksin.
Performing AC Analyses on PFC Converters
BIOELECTRONICS 1 Lec 9: Op Amp Applications By
Communication 40 GHz Anurag Nigam.
B.Sc. Thesis by Çağrı Gürleyük
CSE598A Analog Mixed Signal CMOS Chip Design
Analogue Electronics Circuit II EKT 214/4
The open loop gain of this op-amp is 105 and the bandwidth is 10 Hz
Hugo França-Santos - CERN
In The Name of God Design of A Sample And Hold Circuit Based on The Switched Op-Amp Techniques M.Rashtian: Faculty of Civil Aviation Technology College.
Lock-in amplifiers
6.0 Voltage Regulators.
Electronic Instrumentation
ECET 310 Competitive Success/snaptutorial.com
ECET 310 Education for Service-- snaptutorial.com.
ECET 310 Teaching Effectively-- snaptutorial.com.
Vibration Energy Harvesting Circuit to Power Wireless Sensor Nodes
Instrumentation & Measurement (ME342)
Sample & Hold Circuits CSE598A/EE597G Spring 2006
BESIII EMC electronics
Amplifiers: A Bio amplifier is an electrophysiological device, a variation of the instrumentation amplifier, used to gather and increase the signal integrity.
ECE 3336 Introduction to Circuits & Electronics
10k 20k Vin Vout H3 What is the gain?
Chapter 5: Active Filters
A 12 bit 50 MS/s Dual Channel Time Domain Two Step ADC
A 12 bit 50 MS/s Dual Channel Time Domain Two Step ADC
Presentation transcript:

International Symposium on Low Power Electronics and Design Switched-Capacitor Boost Converter Design and Modeling for Indoor Optical Energy Harvesting with Integrated Photodiodes Stanley W. Hsu, Erin Fong, Vipul Jain, Travis Kleeburg, Rajeevan Amirtharajah University of California, Davis

Introduction/Motivation Integrated Photodiode Switched-Capacitor Boost Converter (SCBC) Delta-Sigma Modulator (DSM) Supply Ripple Effects on DSM Summary 2 Outline

Introduction/Motivation Integrated Photodiode Switched-Capacitor Boost Converter (SCBC) Delta-Sigma Modulator (DSM) Supply Ripple Effects on DSM Summary 3 Outline

4 Introduction Ultra-low voltage sensor circuits powered by free-space optics (Kleeburg, 2010) Integrated photovoltaics for optical power, data, and clock delivery Subcutaneous medical implants Ultra-low duty cycle sensor (Ayazian, 2012) Integrated photovoltaics (2.5 mm x 2.5 mm) Off-chip capacitive and resistive transducers, and electrodes

–Rectified AC mains at 120 Hz 5 Energy Harvesting from Indoor Lighting –Pulse-width-modulated dimming at > 200 Hz Low light intensity limits harvested energy Issue: light flickering Source: ksj.mit.edu Source:

6 Integrated Photodiode Power Electronics Vdd Domain Circuits Light Vdd Indoor Lighting-Powered Sensor Bypass Capacitor Supply ripple Cost, Area/Volume Circuit performance

Introduction/Motivation Integrated Photodiode Switched-Capacitor Boost Converter (SCBC) Delta-Sigma Modulator (DSM) Supply Ripple Effects on DSM Summary 7 Outline

8 Integrated Photodiode Designs P+/NWP+/DNW Voc523 mV508 mV Isc density 134  A/mm 2 52  A/mm 2 Power generated/area  W/mm  W/mm 2 P+/NWP+/DNW

9 Integrated Photodiode Results 3 P+/DNW photodidoes stacked in series (no bypass capacitor) Increasing frequency or duty cycle decreases ripple.

Introduction/Motivation Integrated Photodiode Switched-Capacitor Boost Converter (SCBC) Delta-Sigma Modulator (DSM) Supply Ripple Effects on DSM Summary 10 Outline

Phase 2 – Charge capacitors to VIN Phase 1 – Boost output to 4x VIN 11 Switched-Capacitor Boost Converter S4

12 Buck Converter Model Fast Switching Limit: Slow Switching Limit : (Seeman, 2008) Combined Output Impedance:

13 Proposed Boost Converter Model Model accounts for bottom plate parasitic effects and allows cascading of multiple stages N=4

14 SCBC Output vs. Switching Frequency Model is accurate to within 10%, from 500 Hz to 5 MHz

SCBC Simulated Ripple to Output Ratio 15

Introduction/Motivation Integrated Photodiode Switched-Capacitor Boost Converter (SCBC) Delta-Sigma Modulator (DSM) Supply Ripple Effects on DSM Summary 16 Outline

17 Conventional 1 st Order DSM Design Integrator Pre- Amp + 1-bit DAC Analog input Digital output - error Latch Comparator

18 Proposed 1 st Order DSM Design Low Pass Filter Pre- Amp + 1-bit DAC Analog input Digital output - error Latch Removed!

19 Proposed 1 st Order DSM Schematic Attenuates input! Gain <1 Switched-capacitor low pass filter 1b DAC feedback Dynamic Comparator No pre-amplifier

20 DSM Die Photo and Measured Results 1 Technology180 nm Supply Voltage1.4 V1.8 V Sampling Rate50 kHz1.6 MHz Nyquist Rate4 kHz -7dBFS input ~27 dB~50dB SNDR ~27 dB

Introduction/Motivation Integrated Photodiode Switched-Capacitor Boost Converter (SCBC) Delta-Sigma Modulator (DSM) Supply Ripple Effects on DSM Summary 21 Outline

Sampling switch behaves as passive mixer (Cook, 2006) Distortion due to passive mixing –Sampling switch Mixing between input and ripple –1b DAC feedback switch Mixing between ripple and itself 22 Supply Ripple Effects on DSM

23 Measured DSM Lower Sideband Spectrum

24 Measured DSM SNDR vs. Ripple Vdd = 1.4V Sampling Rate = 50 kHz Input Amplitude = -7dBVdd ~4.5 bits ~2 bits

Introduction/Motivation Integrated Photodiode Switched-Capacitor Boost Converter (SCBC) Delta-Sigma Modulator (DSM) Supply Ripple Effects on DSM Summary 25 Outline

P+/NW integrated photodiodes achieves µW/mm 2 with Voc=523 mV Switched-capacitor boost converter model for predicting output voltage to within 10% accuracy from 500Hz to 5 MHz Supply ripple effects on passive delta-sigma modulator results in IM2 distortion at 26 Summary

27 Integrated Photodiode Power Electronics Vdd Domain Circuits Light Vdd Summary Bypass Capacitor  If DSM can tolerate an increased supply ripple from 10% to 21% of Vdd, bypass capacitor can be reduced from 56.5 nF to 3.86 nF.

Texas Instruments for chip fabrication –William McIntyre –Arun Rao –Keith Schoendoerfer –Greg Winter –Bijoy Chatterjee 28 Acknowledgements