Industrial Inspections Making Good Inspections Better David Long EPA Region 6.

Slides:



Advertisements
Similar presentations
Alaska Association of Harbormasters and Port Administrators Wrangell, Alaska October 26, 2010 Shane Serrano ADEC.
Advertisements

Contractor Management. Struggling with Contractor Management ? ? ? Getting purchasing on board? Specifically stating environmental compliance in contracts?
Collecting Paint for Recycling in New Hampshire Marc Morgan HHW Coordinator.
The Pretreatment Program September 14, 2012 Bethlehem, PA.
Storm Water Permit Compliance Susan Murphy. Storm Water: To See or Not To See… We submit a Notice of Intent for Coverage (NOI) Prepare and Implement a.
Spill Prevention Control & Countermeasures Compliance and Planning.
4/27/2015 Licking County Engineer’s Office MCM#6 Training MCM#6 – Pollution Prevention/Good Housekeeping for Municipal Operations Licking County & Partners.
What is NPDES? “National Pollutant Discharge Elimination System”
Preventing Storm Water Pollution: What We Can Do ~Employee Training Series~ Fleet Maintenance PREPARED IN COOPERATION WITH THE Texas Commission on Environmental.
Our Vision – Healthier Kansans living in safe and sustainable environments.
ANNUAL SPILL PREVENTION CONTROL AND COUNTERMEASURE TRAINING (SPCC) Presented by: Prepared for: Stephen F. Austin State University February 2, 2012.
25th Annual U.S. EPA Region VI Pretreatment Association Workshop Liquid Waste Transporter Enforcement Stories August 5, 2009 Ms. Erin La Rue Pretreatment.
2009 ENVIRONMENTAL SEMINAR Boat Bottom Pressure Washing Requirements & General Permit for the Discharge of Stormwater Associated with Industrial Activity.
1 BMPs for Kitchen Management City of Los Angeles Department of Public Works Bureau of Sanitation Industrial Waste Management Division Fats, Oil & Grease.
GEORGIA ENVIRONMENTAL PROTECTION DIVISION SMALL BUSINESS ENVIRONMENTAL ASSISTANCE PROGRAM.
MAINTAINING WATER QUALITY CITY OF TULSA PERMIT ENFORCEMENT.
Spring Training 2008 IPP INSPECTION. PURPOSE OF INSPECTION The main purpose of an industrial waste pretreatment program is to protect the environment,
Regulatory Update. January Meeting Recap/Update Enforcement News -Wal-Mart -MSHA Advanced Notice -EPA – Clean Water Act (CWA) & EPD -OSHA – Stone, Clay,
Hazardous Waste Issues Associated with Municipal Operations Dan Sowry Environmental Specialist Office of Compliance Assistance and Pollution Prevention.
Wastewater and Floor Drain Sludge 6-1 (a) Wastewater From Vehicle Maintenance Facilities n Vehicle and Floor Washwater –Wastewater contains soaps, grease,
NPDES Primer for Executive Officers of Wastewater Facilities Indiana Department of Environmental Management Office of Water Quality Compliance Branch.
Society depends on clean and safe water.
Hazardous Waste Initial Training Environmental Health, Safety and Risk Management June 2010.
Laschone P. Garrison State of Connecticut, Department of Public Health.
Wastewater P2. Environmental Concerns  Heavy metals from sanding waste  Oil, grease, and coolant from vehicles  Toxic chemicals from cleaners, strippers,
SPILL PREVENTION CONTROL AND COUNTERMEASURE (SPCC) Title 40 CFR 112.
Virtual Environmental, Health & Safety Manager Compliance Management System T. Cozzie Consulting, Inc. telephone
Applying for the VT Multi-Sector General Permit
BY: GROUP 2 Food Safety Regulations and Standards.
ISO Standard is based on the management model of plan – do - check – act. Today we all be discussing the elements of the standard that deal with.
Inspection Records and Reports NC DWR, Raleigh Regional Office 3800 Barrett Drive Raleigh NC (919)
U.S. Environmental Protection Agency
Permitting, Fees, and Reports Cal Poly Lecture Tour Ron Scholtz Analog Devices, Inc.
CENTRALIZED WASTE TREATMENT 40 CFR 437 Lessons Learned.
Preparing for a Multi-Media Inspection at your Medical Facility John Gorman EPA Region 2 What to expect when an EPA Inspector.
Identifying and Visiting Small Businesses for Water Pollution Prevention Presented by: Richard Hoiland - City of Vancouver, WA NAHMMA Conference – Tacoma.
Storm Water Pollution Prevention Training
THAI TOKO ENGINEERING CO.,LTD.
OMNI FACILITY SERVICES Copyright  Progressive Business Publications Handling Hazardous Wastes.
A Basic Overview of the US FDA’s Regulations for Regulatory Compliance
Construction and Demolition Inert Processing Operations Compliance First: Evaluation of Solid Waste Facilities’ State Standards Training Provided By: California.
Using the Directives Process to Track EMS Requirements Department of Energy EMS Training Workshop Columbus, OH March 7-8, 2005 Daniel L. McCollum, Quality.
ISO OPERATIONAL CONTROL
HOW TO DO Pollution Prevention & Good Housekeeping NC STATE UNIVERSITY.
ESTA Technical Standards Committee Product Stewardship.
Field Visit MODULE 8: Walkthrough of a Healthcare Waste Treatment Facility.
The Foundation Developing and Implementing Your Storm Water Management Program.
Presented to Georgia Airports Association Conference October 21, 2009 EPA Spill Prevention Control and Countermeasures – Update Also – What’s Coming with.
Florida Industrial Pretreatment Association Workshop April 25, 2008 Dan Parnell JEA Industrial Pretreatment.
Illicit Discharge Detection and Elimination 6/4/20161 Illicit Discharge Detection and Elimination.
ISO MONITORING AND MEASUREMENT. ISO Environmental Management Systems2 Lesson Learning Goals At the end of this lesson you should be.
Organizational Study of Inspectional Services City of Springfield, Massachusetts February 21, 2008.
MCM#6 Pollution Prevention/Good Housekeeping Part 1 Municipal Facility Management.
Hazardous Materials Business Plan Training Topic 2
Copyright  Progressive Business Publications Handling Hazardous Wastes.
Checking and Corrective Action EPA Regions 9 & 10 and The Federal Network for Sustainability 2005.
Module 14Slide 1 of 23 WHO - EDM Basic Principles of GMP Active Pharmaceutical Ingredients Part Three, 18.
Task Manager Construction Coordinator Training -- EMS-- Fermilab 95% of Asbestos found is either Amosite or Chryosotile95% of Asbestos found is either.
Goals: ◦ Minimize the environmental impacts of construction projects and tasks undertaken at the Lab; ◦ Remain in compliance with environmental rules;
Spill Prevention Control & Countermeasure (SPCC) Annual Training
Stormwater Pollution Prevention Program Compliance
Lecture (13): Hazardous Waste Management
ACA Fall Conference September 15, :00 pm to 5:00 pm Industrial General Storm Water Permit requirements for fueling activities Aaron Ortiz QISP WGR.
Advanced Environmental Management (AEM) Training Phase I
NC DPPEA Compliance Assistance - Water
Environmental Health and Safety (EH&S) Supplier Awareness Training
Van Wert, OH Water and Wastewater Element Training
“How To Ace an Inspection” Russell McLaren – Entergy ARES Water Lead
Taking a Dip in Your SWPPP
Whose Job Is It? Responsibility for Laboratory Safety and Security
Presentation transcript:

Industrial Inspections Making Good Inspections Better David Long EPA Region 6

This presentation is not intended to be used as the definitive developmental tool or guide. It is intended to point out some of the more common problems that have been noted during EPA reviewed industrial inspections. Remember, the EPA provides the information and tools. It is your responsibility to build the best program you can and then, constantly review and improve that program.

What is the “Golden Rule” when performing an industrial inspection? Follow the yellow brick road Don’t eat the yellow snow If you don’t document your inspection, did the inspection really happen?

A typical industrial inspection usually includes the following sections: SECTION A – GENERAL FACILITY INFORMATION SECTION B – RECORDS AND REPORTS SECTION C – CHEMICALS AND STORAGE SECTION D – OPERATION AND MAINTENANCE SECTION E – POLLUTION PREVENTION SECTION F – COMPLIANCE SCHEDULES SECTION G – WALK THROUGH INSPECTION

SECTION A – GENERAL FACILITY INFORMATION Typical information includes: Company name Facility address Corporate address Name of ranking official Number of employees

SECTION A – GENERAL FACILITY INFORMATION Typical information can also include: Other environmental permits Major product or service Main waste materials produced

SECTION B – RECORDS AND REPORTS Typical information can include: Self monitoring records Chain of Custody records Sampling locations Laboratory procedures (40 CFR 136)

SECTION C – CHEMICALS AND STORAGE Typical information can include: What chemicals are handled at the site How and where are virgin chemicals stored Is there a spill pollution prevention plan

SECTION D – OPERATION AND MAINTENANCE Is the process wastewater treated prior to being discharged to the sanitary sewer Is it possible to by-pass the waste treatment system Have any bypasses occurred Is the treatment unit equipped with an alarm Does the IU generate waste sludge How and where is the sludge stored/disposed

SECTION E – POLLUTION PREVENTION Do any processes recycle or reuse water Has the IU implemented any pollution prevention activities Have employees been trained in pollution prevention activities

SECTION F – COMPLIANCE SCHEDULES Is the IU under a compliance schedule Have design plans and specifications been completed Has construction been completed

SECTION G – WALK THROUGH INSPECTION Process description Treatment system Floor drains Virgin chemical storage areas Waste (oil, paint, solvent, etc.) generation and storage areas

SECTION A – GENERAL FACILITY INFORMATION SECTION B – RECORDS AND REPORTS SECTION C – CHEMICALS AND STORAGE SECTION D – OPERATION AND MAINTENANCE SECTION E – POLLUTION PREVENTION SECTION F – COMPLIANCE SCHEDULES SECTION G – WALK THROUGH INSPECTION These sections represent the bulk of an industrial inspection or what my 10 year old daughter calls the tinker toys of my job.

So how do you make a good industrial inspection better? You have to go back to the beginning……..

The Industrial User Survey Has the industrial survey been kept updated? What procedure is being used to update the industrial user survey? Have all industrial users been properly categorized?

What procedure is being used to update the industrial user survey? User Survey/Mass Mailing When was the survey performed? How many responses/non-responses? How many of the respondents have you visited? How many of the respondents have you inspected?

What procedure is being used to update the industrial user survey? (continued) How did you target the industries surveyed? Water use records Complaints from citizens or City personnel Referral from City Offices (Building Inspections, Fire Department, Health Department, etc.)

What procedure is being used to update the industrial user survey? (continued) Phone Book Manufacturers Guides Scheduled re-inspection every three years

Have all industrial users been properly categorized? What the industries tell you. What your inspection shows you. Keeping up with the literature

When inspecting a new facility, try to remember the following: Be professional and be courteous, but know also that you are not Blanche Dubois … You are not dependent upon the kindness of others and you should not just accept what you are told. Look inside cabinets and under sinks, ask workers questions about their jobs, ask why there is a hose going from a production unit to a floor drain…

Remember, when the EPA comes to visit your city, we will be asking: Are you doing your inspections? Are you doing all of your sampling? Is your paperwork completed on time? Was there anyone available to meet with the EPA Inspector when he came to do a PCI in your City?

Concluding Thoughts by David: Seek and you shall find Seek harder, and be refined Seek not and be fined

David Long 1445 Ross Avenue Dallas, Texas (214)