How to Use Remote Clock

Use the following link and save Remote Clock to your desktop or an easily accessible place: RemoteClockSetup632.rar

In order to open and install the Remote Clock software, you will need a tool to open a winrar file. If you do not have the tool, you can use one of the following:

For example: If using 7-Zip, open 7-Zip from the location you saved the file.

Drag the Remote Clock icon to 7-Zip

Click OK

Open Remote Clock by double clicking the below

Install Remote Clock with the provided:

Remote Clock will look like the following

Click File then Connect to display the following:

After clicking Change Settings: You only have to fill in your Phone Number and select the communication port your modem attaches to. Example: if my LCD system were connected to telephone number , I would dial [91] The reason for the [91] is because 91 is used to dial out of my personal building. You will use whatever combination is required to dial out of your system. Another example: 1 is required to dial out long distance from system 2. The number that would have to bed dialed is [1] Set your communication port for the port that your modem is located at. In my example on the previous slide, my communication port was Comm 3.

Note when using analog phone lines: Commport to Modem is used when you are connecting via an analog phone line to a single bus system (only one pane will have a screen) Modem via Backbone Bus is used when you are connecting via an analog phone line to a multi-bus system

When your information is entered, press connect.