Break down Lance rack Cut one of each of these for each rack (drawings not to scale) 31” 25” 2” 3” 1” 3” 2” Top Separator 3-1/2” 31” 25” 3” 2” 3-1/2” Rear Brace 32-1/2” 26-1/2” ½” 3” ½” 2” 3-1/2” Base Holder

Cut two these (as shown) for each rack Side View 66” or whatever is appropriate for the height you want 2” The top holes (between red and blue) are not the same. 10o Back Legs Front Legs It is best (but not absolutely necessary) to angle cut the bottom to sit flat on the ground 24” (or whatever fits your dimensions – leg length and angle of tilt) Side Brace 3”

If you don’t want the side braces angled, you can lengthen the rear brace tenons and insert a spacer block (the thickness of the legs) between the back legs and the side brace. Front View Top View

Lay out to measure and mark After cutting all the holes and assembling the rack, mark the sides of each outer board along the tenons so you know where the pegs need to go. 10o slope by offsetting top 11-½” from bottom 1. Mark this hole on the rear leg Drill peg hole centers slightly outside of leg edge line 11-1/2” 10o 65” 66” 2. Measure side brace length and mark these holes on the side braces 3. Mark this cut-off line