Vehicle Registration Details Extraction System Using GSM

AGENDA Introduction Block Diagram Power Supply&Testing Micro-Controller&Testing GSM module&Testing RFID module&Testing IR Sensor LCD module&Testing Problems Refference

Introduction Heavy Rainy season Chances of accident To Control the Traffic Rule The project addresses microcontroller based Vehicle Registration details Extraction system using GSM

Block Diagram

CKT DIAGRAM

Power Supply Regulated dc power supply Output=5v component

Testing of Power Supply

Microcontroller ■ 80C51 Central Processing Unit ■5 V Operating voltage from 0 to 40 MHz ■64 kB of on-chip Flash program memory ■ Four 8-bit I/O ports with three high-current Port 1 pins ( 16 mA each) ■Three 16-bit timers/counters ■Programmable Watchdog timer (WDT) ■Eight interrupt sources with four priority levels TTL- and CMOS-compatible logic levels

Testing of Microcontroller

FACED PROBLEMS Crystal Reset Power Supply Poor pin contacts Syntax Errors Undefined Symbol

GSM Module

Features of GSM Single supply voltage 3.2v-4.5v Typical power consumption in SLEEP Mode: 2.5mA. SIM300 tri-band

Testing with a PC Connect the GSM Modem to a PC COM Port Create a HyperTerminal (Windows tool for serial port communications) window with Baud rate 9600 and connect it to the COM Port to which GSM is connected. Type any AT command in the HyperTerminal window and you could see the modem responding by sending “OK”.

Testing with a PC

Faced Problems Connections setting Matching proper Baud rate Serial port communication

IR Sensor Obstacle detection

Testing OF IR Sensor

RFID Module Radio-frequency identification(RFID) An RFID system is just a reader and a tag communicating over the air at a certain frequency Parts – Readers – Antennas – Tags Fig 1: An RFID tag used for electronic toll collection.

LCD • 2 line x 16 character Display • Each character location consist of 5 dot x 8 bit display 4bit or 8bit MPU interface Memory map

Testing OF LCD Establish connection with Microcontroller Load Program for transmitting string. Check Data lines of LCD. Adjust Potentiometer.

PROBLEMS Loose Connection. LCD Initialization. Display String operation LED+ LED-

Refference Timo H.,Javier R. and Jaun M.2003.GSM,GPRS and Performance and Ed. Chichester:John Wiley And Sons,Ltd. I.Pottier and G.Burel,” Identification and authentication of handwritten signatures with a connectionist approach,” in Proc.IEEE Int.

THANK YOU