1. KOHLER Continuous Two-drum Surface Winder

2. Features: Winds on 3 inch (75mm) or larger cores New Core Accelerator Advanced Cut Knife System cuts within 2 inches (50mm) of the core Large Diameter – 23¾ inches diameter drums Airshafts retained by Fail-Safe Locking Clamps at all times Cross-Machine Timing of Moving Components by Rugged Anti-Backlash Gearing Integral Suction Roll for Web Stabilization Kohler Two-drum Winder

3. Features: Individual Motor Drives for each drum Programmable Torque and Hold Down Loading Relative to Diameter Offset Drums for better Winding Characteristics Dual Hold Down Roll Systems Load Cells for Tension Feed Massive Rectangular Tube Side Frames Precision Bearings and Machine Tool Slides used throughout Kohler Two-drum Winder

4. Benefits: Tightly Wound Concentric Rolls +/- 0.030 inch (0.75mm) Edge Control Tail is 3 inches (75mm) or less, cut cleanly and folded back evenly on turn up Winder is not Tension Limited – can pull up to 20 PLI (3.6kg/cm) even during transfer to new core. Can wind finished, slit rolls without rewinding

5. Kohler Two-drum Winder Options: Semi-Automatic Shaft Handling Equipment Inline Slitting and/or Edge Trim Dual Spreader Rolls CSI KOHLER COATING 10995 Wright Road NW Uniontown, OH 44685 Phone: (330) 499-1407 FAX: (330) 499-6617 E-mail: info@kohlercoating.com Web Site: www.kohlercoating.com