2. This is what the parts look like
Go to the next slide to start the tutorial

3. You’ll be saving
this picture
Go to the next slide

4. 1. Go back to the slide before this one
Right-click, “Save as Picture”
Save to your DDP Folder
“Christmas Tree”

5. 2. Front Plane
New Sketch
3. Main Menu
Tools
Sketch Settings
Sketch Picture
4. Browse for Christmas Tree.jpg

6. 5. Roll your mouse wheel to zoom in on one tree pattern
Don’t pull the blue squares to resize the picture
Click Green Checkmark under Sketch Picture

7. 2 3 1 6. “3 Point Arc tool” 7. Click #1. Beginning of Arc
#2. End of Arc
#3. Middle of Arc
Click ESC (Escape Key)
Click Enter Key to start new ARC

8. 8. Make sure the ends of all ARCS
start off at the end of the last ARC
9. Width for all slots .31”

9. 10. Extruded Boss/Base .31”
11. Right-click on tree
Click Appearances Ball
Select Body or Part 1
Pick any Green from Left menu

10. 13. Go back to Step 2 (5th slide)
Repeat the whole process, but create a different part of the tree
12. Save As “Tree 1”
14. Assemble when finished
1st slide shows what tree looks like assembled