1. Pegboard Toy Assembly and Sides

2. Assembly Please open up a “Standard.iam” file and place these objects in your window

3. Feeling Frustrated? It will happen at some point or another, but don’t give up. Feeling frustrated is all a part of learning.

4. Assembly PLACE the pegboard and pegs into an assembly window (.iam)

5. Constrain Use the constrain feature to connect parts of your assembly.

6. Constrain Round Peg Constrain the axis of both the peg and the hole in the pegboard.

7. Constrain Square Peg For the square peg, you must constrain 2 adjacent sides.

8. Constrain Square Peg For the square peg, you must constrain 2 adjacent sides.

9. Constrain Square Peg For the square peg, you must constrain 2 adjacent sides.

10. Next… We need to put ends on our Pegboard.

11. Sides!

12. End to your pegboard 1.Draw 2.Extrude 3.Save.75” wide.375” cut out

13. Next… We need to put ends on our Pegboard.

14. 3 “Clicks” before you draw… 1.Click on the side you want to work on. 2.Click on “Create 2D sketch” 3.Click on the same side as you did in #1

15. 1. Click on the side you want to work on

16. 2. Click on “Create 2D sketch”

17. 3. Click back on the long edge on the pegboard

18. Your pegboard will look like this…

19. OK… Remember this?

20. Draw an End Piece Use the line tool to draw around the end of the pegboard.

21. Finish Sketch and Extrude Extrude the end 3” – the same as the width of the pegboard.

22. RETURN!

23. Work Planes… In the browser, right click on the “WORK PLANE” button, and uncheck the visibility.

24. Other End… “PLACE” the other end on the screen, and constrain it into place.

25. Viola! Finished!?! Now you have a wonderful pegboard toy!