 A form of energy that travels in waves  These waves are a form of electromagnetic radiation. Light is not the only form of electromagnetic radiation.

 You may have noticed that color takes up a small portion of the electromagnetic spectrum.

1. Reflection (like the text above) 2. Refraction 3. Absorption 4. Diffraction (you will not need to remember this, but will see it in more advanced websites)

AbsorptionRefractionReflection

 Opaque  A substance that blocks all light from traveling through  Light is reflected or absorbed  Transparent  Any substance that allows light to easily pass through without being scattered.  Transluscent  Any substance that scatters light as it passes through

Eyepiece or Ocular Body Tube Arm Coarse Adjustment Fine Adjustment Nosepiece Objective Lens Stage Diaphragm Base Light Source

 1 lens  Example: Magnifying Glass  Magnification Just the one lens  2 lenses  Example: Compound Microscope  Magnification cular bjective  Multiple for total magnification = 50x 10x 5x X

 Carry it with one hand.  Move the ocular to show someone something.  Move the microscope to show someone something  Use the coarse adjustment in high power (will crack the slide)

1. Place the specimen on a slide. 2. Start with the low power objective (red) 3. Place the slide over the hole of the stage (where light comes through), raise the stage as high as it can go using the coarse adjustment (large knob) 4. Look into the ocular lens (eyepiece) as you move the coarse adjustment to focus the specimen. 5. Use the fine adjustment to focus more precisely on the specimen. 6. If using the higher power (yellow), just move the objective lens into place. Your specimen should be in view. Again use the fine adjustment knob to focus.

 Place 1 drop of water on the slide  Place your specimen on the drop of water  Place another drop of water on top of the specimen  Slowly lower the coverslip over the specimen on a 45 degree angle (to prevent air bubbles)  Do not bend the cover slip, or push down on it.

1. Prepare a wet mount. 2. Rip off a piece of small paper towel with a flat edge (if it doesn’t have a flat edge, fold it over to create one) 3. Place a drop of stain along one edge of the cover slip (lets say the left edge) 4. Place the paper towel along the other edge (the right edge) so that it begins to draw the stain across the slide.

1. Most of the information was provided with guided notes throughout this unit.