Chapter 8: Density mass volume density = for example, the density of benzene is: 0.880 g mL.

Slides:



Advertisements
Similar presentations
Convection Density of Fluids Investigation 5, Part 1.
Advertisements

Observations Check the three observations that are GOOD observations applicable to this lab. Underline QUANTATIVE observations. □ The pennies are a circle.
Measuring small volumes un a biotechnology lab
Due Today: Density Part 1 Pre-Lab Homework: 1. Density Part-2 Pre Lab DENSITY PART I.
Sugar Content Analysis
Unknown Foods: Macromolecule Lab Chapter 2: Carbohydrates, Lipids, and Proteins.
Pre-Lab 4.1. Purpose To determine if you can dissolve all of a solid into a liquid.
The steps how to calculate mass, volume, and density
DNA Isolation, Restriction Enzyme, Digestion, and Gel Electrophoresis.
Introduction to Equipment
Lab Station # 1: Toothpick 1.Obtain a toothpick from the beaker and break it into several pieces. Discard the broken pieces in the waste beaker. 2.Record.
Lab Techniques How to do a Manual Titration. Rinse the inside of the Burette Rinse the burette with 2-3 mLs of standarized NaOH solution. Make sure all.
How to do a Manual Titration. Rinse the Burette with 2-3 mL of standardized NaOH solution. Make sure all inside walls including the tip are rinsed. Discard.
Measure 25 ml of red water and pour it into test tube A. Step 1 Remember 25 is 5 lines above the 20.
Marine Biology Mr. Robinson
Can you build a 6, 7, or 8-layer density column? Think of it as a layered burrito…..
Properties of water Labs Explanation. Water Labs There are 7 labs to do Each bucket is labeled with the lab and all the directions are in the bucket.
Warm Up: August 30, 2013 Ally dropped a delicate glass vase 6 feet from the top of a ladder onto a concrete floor. The glass did not break. Why?
Layering Liquids. Today you are going to: layer 4 unknown liquids in a straw so that none of the liquids mixes with another.
The Scientific Method & Measurement. The Scientific Method Purpose Hypothesis Materials Procedure Observations Conclusions.
Layered Solutions: A Lab on Density. Observations/ Data: -The red solution was a little murky with some of the salt not settled. -Yellow and green seemed.
Using a Graduated Cylinder Uses: 1.To measure the volume of liquids very accurately 2. To find the volume of solid objects that do not have regular dimensions.
Lab Techniques How to do a Manual Titration. Rinse the inside of the Burette Rinse the burette with 2-3 cm 3 of water then with 2-3 cm 3 the solution.
Layers of the Ocean Lab Salt water added to fresh water Observations
Pre Lab Definitions: (Fill these in on your lab paper) Serial: In a series, order or interval. Measured steps. Dilution: Water Down. Pipette: “Little pipe”
Density Why some things sink and others float. Rainbow Lab.
% by Mass Another way to measure the concentration of a solution % by mass = mass solute x 100 mass solution Solution = solute + solvent.
Solution Concentration. Concentration Describes the amount of solute dissolved in a specific amount of solvent.
Experiment 1 Basic Laboratory Techniques Parts A, D, E, and an Unknown
Lab Instructions. Materials and Equipment Distilled Water Zinc metal Filter Paper Plastic Wash Bottle Copper II sulfate Tap water Pencil (not a pen) Plastic.
Density Lab Equipment, Procedures & Safety Density Lab Equipment, Procedures & Safety.
Make up Labs 4.1 and 4.3.
The Density Column. Question… If the lead weight is dropped into the beaker of water… will it sink or float? d= 11.4 g/ml What will happen if it is dropped.
Density Column Lab. What is a physical property?
A Chemistry Demonstration for Elementary School Students
Lab STRAP Tape description of lab STRAP into the front cover of your notebook Density of solids and liquids lab.
Water to add to beaker (total volume always 100ml) Temperature of water ( o C) Time taken for sugar cube to dissolve (seconds) 100 ml of kettle water 75.
The Basics of Solution Making. Making solutions with solid solutes Follow the steps below: –Measure out the appropriate mass of solute –Dissolve the solid.
Title Procedure Lab Name Date Class. Purpose Students will understand the significance of following procedure properly step by step. (Remember the cookbook.
Mixtures and Solutions. Name the two parts of a solution.
Review Questions Write your answer, and nothing else, on the white board. Work together with people around you. Hold up your answer, but don’t say it too.
Measurement Labs. Measuring Length Lab Follow the directions to find the length of the following items. 1.Use the meter stick to measure your Science.
| resources for science teachers who like to think TopicDensity and the particle model LevelFor.
Practical Analytical Chemistry (1) Practical (8) Faculty of Pharmacy Department of Pharmaceutical Chemistry.
Density of Liquids and Solids. A. Instructor Demonstration Take down observations as each step is performed by the instructor Make sure to label each.
Identification of Substances by Physical Properties.
Measuring Liquid Volume
Density.
Volume by Water Displacement
How to do a Manual Titration
QQ: How does density affect the ocean currents?
Lab Techniques How to do a Titration.
Movement through a Membrane.
How to do a Manual Titration
Sugar Content Analysis
Lab Equipment.
Scientific Tools of Measurement
Density of Fluids Investigation 5, Part 1
Density Lab Intro.
Experiment 1 Basic Laboratory Techniques Parts A, D, E, and an Unknown
3.1 Building a Density Column
Sugar Content Analysis
Density of Fluids Investigation 5, Part 1
Using a Pipette Filler Do NOT let the water get into the bulb
Procedure for calculating density
Density              .
DNA Extraction from Wheat Germ
Using a Pipette Filler Do NOT let the water get into the bulb
Lab 8 The Density of Water Purpose Background PART 1
Density Practice Problems
Presentation transcript:

Chapter 8: Density mass volume density = for example, the density of benzene is: g mL

Chapter 8: Density g/mL 1.59 g/mL 13.5 g/mL

Chapter 8: Density g mL What is the mass of 25.0 mL of benzene at 20°C? (Density = g/mL) X 25.0 mL = 22.0 g

Chapter 8: Density Lab activity: Pipetting different density sucrose solutions Insert pipette by holding it near the end closest to the pipetter Don’t hold the pipette at the other end! It could break and stab your hand!

Chapter 8: Density Lab activity: Pipetting different density sucrose solutions push here to bring liquid up ( ) the pipette push here to move liquid down ( ) the pipette practice pipetting with a beaker of water

Chapter 8: Density Lab activity: Pipetting different density sucrose solutions make sure you read the correct scale! 9 mL 10 mL

Chapter 8: Density 1.Line up four glasses. Add 15 g of sugar to the first glass, 30 g of sugar to the second glass, 45 g to the third glass, and 60 g to the fourth glass. 2.Add 45 ml of water to each of the glasses. Stir each solution. If the sugar does not dissolve in any of the four glasses, then add one more tablespoon (15 ml) of water to the glass. 3.Add 2-3 drops of red food coloring to the first glass, yellow food coloring to the second glass, green food coloring to the third glass, and blue food coloring to the fourth glass. Stir each solution and record the volume.

Chapter 8: Density 4.Now let's make a rainbow using the different density solutions. Fill a 15 mL Falcon tube with 2 ml of the blue sugar solution. 5.Carefully layer 2 ml of green sugar solution above the blue liquid. Do this by slightly tilting the Falcon tube and pour the green sugar solution down the side of the tube. If you do this right, you won't disturb the blue solution much at all. 6.Now layer 2 ml of the yellow solution above the green liquid, using the same technique. Finally, layer 2 ml of the red solution above the yellow liquid.

Chapter 8: Density now calculate the densities! ? g/ml sucrose