6 Feb. 2003 (update) A.P.Kashchuk (LNF/INFN, on leave from PNPI) 1 Triple GEM is the best candidate for station M1 regions R1/R2 Triple GEM has better.

Slides:



Advertisements
Similar presentations
GEM Chambers at BNL The detector from CERN, can be configured with up to 4 GEMs The detector for pad readout and drift studies, 2 GEM maximum.
Advertisements

Muon EDR: Chamber design M2/3 R1/2 16/04/20031T.Schneider/LHCb Muon EDR 1.General description - AW read out -Cathode pad read out -HV supply 2.Details.
INFN Trieste, October 2008 Summary of measurements on: CsI coated ThGEM triple CERN.
E. Atkin, E. Malankin, V. Shumikhin NRNU MEPhI, Moscow 1.
Bulk Micromegas Our Micromegas detectors are fabricated using the Bulk technology The fabrication consists in the lamination of a steel woven mesh and.
E-field calculations for the TPC/HBD N. Smirnov Upgrade Working Group Meeting 05/13/03, BNL.
1 VCI, Werner Riegler RPCs and Wire Chambers for the LHCb Muon System  Overview  Principles  Performance Comparison: Timing, Efficiency,
Werner Riegler CERN, November 2003 CARIOCA Werner Riegler, CERN November 24 th, 2003, LHCb week Discussion of the final Prototype results Plans for CARIOCA.
Status of the LHCb RPC detector Changes with respect to Note cm strips instead of 3 cm (cost optimization) All gaps same size (standardization)
PNPI in LHCb A.Vorobyov HEPD Scientific Board meeting, December 26,2003 Status report for 2003.
G. Carboni - Open LHCC - July 2001 Technical Design Report for the LHCb Muon System Giovanni Carboni on behalf of the Muon Group Part II: RPC Detectors,
7 January 2005 MDI Workshop M. Breidenbach 1 SiD Electronic Concepts SLAC –D. Freytag –G. Haller –J. Deng –mb Oregon –J. Brau –R. Frey –D. Strom BNL –V.
J. Inman, “Studies with a TPC … measure ion feedback”, REU presentation, 08-Aug of 20 Studies with a TPC and development of a procedure to measure.
D. Peterson, “ILC Detector Work”, Cornell Group Meeting, 4-October ILC Detector Work This project is supported by the US National Science Foundation.
Ionization. Measuring Ions A beam of charged particles will ionize gas. –Particle energy E –Chamber area A An applied field will cause ions and electrons.
D. Peterson, “The Cornell/Purdue TPC”, ALCPG, Snowmass, 23-August The Cornell/Purdue TPC Information available at the web site:
Position sensing in a GEM from charge dispersion on a resistive anode Bob Carnegie, Madhu Dixit, Steve Kennedy, Jean-Pierre Martin, Hans Mes, Ernie Neuheimer,
July 2003American Linear Collider Workshop Cornell U. Development of GEM-based Digital Hadron Calorimetry Andy White U.Texas at Arlington (for J.Yu, J.Li,
Development of novel R/O electronics for LAr detectors Max Hess Controller ADC Data Reduction Ethernet 10/100Mbit Host Detector typical block.
19 March 2005 LCWS 05 M. Breidenbach 1 SiD Electronic Concepts SLAC –D. Freytag –G. Haller –J. Deng –mb Oregon –J. Brau –R. Frey –D. Strom BNL –V. Radeka.
A.Kashchuk Muon meeting, CERN Presented by A.Kashchuk.
Performance test of STS demonstrators Anton Lymanets 15 th CBM collaboration meeting, April 12 th, 2010.
G.Bencivenni LNF/INFNMuon Meeting 21-October-2002 Status Report on triple-GEM detector M.Alfonsi 1, G. Bencivenni 1, W. Bonivento 2,A.Cardini 2,C. Deplano.
New Developments in Large Area THGEMs & APV Exercise INFN – Sezione di Trieste Carlos Alexandre Fernandes dos Santos 11/December/2014.
1 Status of the Test System of the MWPC for the LHCb Muon System Andre’ Massafferri (Universita’ Tor Vergata – INFN sezione II - Roma) V. Bocci, R. Nobrega.
Straw spatial resolution (beam test 2007 and 2008) A.Zinchenko, S.Shkarovskiy.
1 Hall D Drift Chamber ElectronicsFJ Barbosa Drift Chamber Review6-8 March 2007 Electronics for CDC and FDC Hall D 1.Motivation 2.ASIC Development 3.Preamp.
David Emschermann CBM Collaboration Meeting - GSI – 12/04/2010 TRD geometry in CBMroot and conclusions for detector module design David Emschermann Institut.
S.Vereschagin, Yu.Zanevsky, F.Levchanovskiy S.Chernenko, G.Cheremukhina, S.Zaporozhets, A.Averyanov R&D FOR TPC MPD/NICA READOUT ELECTRONICS Varna, 2013.
VCI 2004Gaia Lanfranchi-LNF/INFN1 Time resolution performances and aging properties of the MWPC and RPC for the LHCb muon system Gaia Lanfranchi – INFN/LNF.
Detector R&D for Muon Chamber Anand K. Dubey For VECC group.
1 Development of the input circuit for GOSSIP vertex detector in 0.13 μm CMOS technology. Vladimir Gromov, Ruud Kluit, Harry van der Graaf. NIKHEF, Amsterdam,
Update on SBS Back Tracker UVa K. Gnanvo, N. Liyanage, V Nelyubin, K. Saenboonruang, Seth Saher, Nikolai Pillip (visiting from Univ. Tel Aviv, Israel)
Digital HCAL using GEM J. Yu* Univ. of Texas at Arlington, Aug. 26 – 30, 2002 Jeju Island, Korea (*on behalf of the UTA team; A. Brandt, K. De, S. Habib,
Front-end boards tests G. Auriemma, D. Fidanza G. Pirozzi( $ ) & C. Satriano ( $ ) Present address: European Patent Office, Branch at The Hague, Patentlaan.
Dressing Test for the LHCb Muon MWP Chambers LECC 2006 Valencia Speaker: Rafael Antunes Nobrega (INFN Roma1) INFN Roma1: V. Bocci, R. Nobrega INFN Roma2:
CARDIAC meeting – 30 Sept 05 M3R3-M5R3-M5R4 FEE status.
Development of the Readout ASIC for Muon Chambers E. Atkin, I. Bulbalkov, A. Voronin, V. Ivanov, P. Ivanov, E. Malankin, D. Normanov, V. Samsonov, V. Shumikhin,
E-Cal Readout Boards - 8 Boards total -Design & Fabrication at Jlab - Assembly at Orsay Nick Nganga HPS Collaboration Oct Jlab.
1 Luciano Musa, Gerd Trampitsch A General Purpose Charge Readout Chip for TPC Applications Munich, 19 October 2006 Luciano Musa Gerd Trampitsch.
AIDA design review Davide Braga Steve Thomas ASIC Design Group 11 February 2009.
Readout Architecture for MuCh Introduction of MuCh Layout of Much ( proposed several schemes) Read ASIC’s Key features Basic Readout chain ROC Block Diagram.
RD51 Group Saha Institute of Nuclear Physics 14 February, 2014
Investigation of crosstalk in the readout structure of the Beamcal K.Afanaciev.
LHCb Muon System TDR Outline: Introduction –Physics requirements –Background conditions Overview of the Muon System Physics Performance –L0 muon trigger.
29-Feb-16S.Movchan Straw status1 Choose of FEE chip for NA62 straw detector Beam tests results 2007 and 2008 (Straw spatial resolution) Comparison FEE.
1 19 th January 2009 M. Mager - L. Musa Charge Readout Chip Development & System Level Considerations.
30 September 2005, Frascati Anatoli Kachtchouk) 1 From CARDIAC version 2 to CARDIAC version 3 N.Bondar, A.Kachtchouk, P.Neustroev (PNPI)
MuTr Chamber properties K.Shoji Kyoto Univ.. Measurement of MuTr raw signal Use oscilloscope & LabView Read 1 strip HV 1850V Gas mixture Ar:CO 2 :CF 4.
1 9 December 2002A.P.Kashchuk (LNF/INFN), Frascati) New approach to CPC design.
Gas Electron Multiplier
Engineering: MWPC design configuration schemas. Wire Pad Chamber (WPC), one gap Avalanche Cdet in parallel to current source (not shown) will reduce current.
On behalf of the LCTPC collaboration -Uwe Renz- University of Freiburg Albert-Ludwigs- University Freiburg Physics Department.
Trigger & Tracking detector for CMS
FEE for TPC MPD__NICA JINR
A General Purpose Charge Readout Chip for TPC Applications
A Readout Electronics System for GEM Detectors
DCH preamplifier developments In Montreal
News on second coordinate readout
M. Alexeev on behalf of Torino TIGER Test Group
High Current V-I Circuits
A Fast Binary Front - End using a Novel Current-Mode Technique
LHCb Muon Detector MWPC & GEM
SiD Electronic Concepts
Status of the CARIOCA project
Beamstrahlung Monitor
Pre-installation Tests of the LHCb Muon Chambers
Simone Brusa / INFN – Ferrara On behalf of LHCb muon group:
Engineering Design Review
Gain measurements of Chromium GEM foils
Presentation transcript:

6 Feb (update) A.P.Kashchuk (LNF/INFN, on leave from PNPI) 1 Triple GEM is the best candidate for station M1 regions R1/R2 Triple GEM has better Cluster size High rate capability Systematic studied aging if compare to MWPC

6 Feb (update) A.P.Kashchuk (LNF/INFN, on leave from PNPI) 2 Remarks for further improvements of the Triple GEM detector w.r.t. M0 prototype tested in October Cdet must and can be reduced from 50pF to 5pF (change design), then ASDQ chip can be used effectively (better than ASDQ++ and CARIOCA): ENC= e/pF=1550e (RMS) x 4 =>>> 1fC (threshold) compare: at present design with ASDQ++ (CARIOCA will be similar) ENC= e/pF=4000e (RMS) x 4 =>>> 3fC (threshold); 2.Further S/N improvement if double signal by OR-ing on the amplifier input (instead to readout single detector to own amplifier, one can use 2 amplifiers for reliability, but read double signal to each one, output select by DIALOG); 3.As it is needed for GEM, ASDQ chip has discharge protection on the negative input: 550pF at 3kV, 1.5mJ. CARIOCA will need external protection, and additional noise of the protection board will be added: 10pF and 15 Ohm =>> 500e; 4.Guard traces must be added between readout pads to reduce crosstalks from pad to pad (ASDQ has Rin=300 Ohm); 5.Full charge (50fC in average from 6mm gas gap) will be collected by ASDQ. It is equivalent to gas gain 10 4.

6 Feb (update) A.P.Kashchuk (LNF/INFN, on leave from PNPI) 3 Where this ‘blocking’ capacitor?

6 Feb (update) A.P.Kashchuk (LNF/INFN, on leave from PNPI) 4 Cathode Drift gap GEM1 GEM2 GEM3 Anode Transfer1 Transfer2 Induction gap ‘Blocking’ capacitor ( defines the current return path) in chain To be cancelled or minimized To be maximized

6 Feb (update) A.P.Kashchuk (LNF/INFN, on leave from PNPI) 5 Cdet=5pF, Cbl=100pF Cdet=50pF, Cbl=100pF Cdet=5pF, Cbl=1000pF Zoom x100 ‘Blocking’ capacitor ( defines crosstalks) x1 Simplified GEM (induction gap) spice-model Signal (green) Crosstalk (blue/red) at various conditions Neighbor pads 2D array Cdet=5pF, Cbl=0 High crosstalk (even with opposite polarity) bad! Crosstalks are equal on all pads! tr=100um/ns tf=RampCin

6 Feb (update) A.P.Kashchuk (LNF/INFN, on leave from PNPI) 6 Cdet=5-50pF, Rin=300, Cbl=1000pF x10 Cdet=5-50pF, Rin=30 x10 Signal (green/ red) Crosstalk (blue) at various conditions One can see from here, that Triple GEM has to be optimized Cdet=5pF, Rin=300, Camp=5-50pF, Cbl=500pF x100

6 Feb (update) A.P.Kashchuk (LNF/INFN, on leave from PNPI) 7 Cbl=1000pF Cdet=Camp=5pF, Ramp=300 Attention: crosstalks to pads from the GEM-foil Cbl=100pF Cbl=10pF Noise source on GEM-foil (e.g.history) Qin=50fC Noise=blue/top Signal=green/bottom