Metalwork Tools 2 Quiz

What is the correct name for this tool? Bevel Edged Chisel What is the correct name for this tool? Firmer Chisel Mortise Chisel Gouge Cold Chisel

Wrought Iron 2. What type of metal is a cold chisel made from? High Carbon Steel Mild Steel Cast Iron High Speed Steel

3. What is the correct name for the tool shown below Rivet Bar Rivet Set & Snap Rivet Punch Riveter

4. What is a hand countersink used for? Centre Punching Holes Removing Burrs Drilling Holes

5) What is the correct name for this tool? Tinsnips Pliers End Cutters Shears

6. Which of the following tools would be used to cut 6mm Dia steel bar? A Coping Saw A Piercing saw A Jnr Hacksaw A Panel Saw

7. What is another name for Mole Grips? Self Grip Pliers Engineers Pliers Long nose Pliers Stillson Plumbers Wrench

It can grip round objects like pipe 8. What major advantage does a Stillson Wrench have over an Adjustable Spanner? It is cheaper to buy It is easier to use It can grip round objects like pipe It has been drop forged

9. What is the correct name for this tool? Tin Snips Heavy Duty Snips Jewellers Snips Diagonal Cutters

10. Which tool is designed to cut rivets? Engineers Pliers Long Nose Pliers Diagonal Cutters End Cutters

11. What is the correct name for this tool? Stillson Engineers Pliers Water Pump Pliers Long Nose Pliers

12. Which tool is designed for working in tight areas and cutting fine wire? Engineers Pliers Long Nose Pliers Diagonal Cutters End Cutters

13. What is the correct name for this tool? Pin Hammer Ball Pein Hammer Cross Pein Hammer Planishing Hammer Claw Hammer Repousse Hammer Blocking Hammer

14. What is the correct name for these tools? Centre Punches Nail Punches Parallel Punches Letter Punches

15. Letter stamps can be used to stamp letters on which of the following? Perspex Acrylic Aluminium High Speed Steel

16. What are Toolmakers clamps used for? The Toolmakers clamp can be used to hold small pieces of work while it is being brazed The Toolmakers clamp can be used to hold small pieces of work while working on them The Toolmakers clamp can be used to hold small pieces of work while it is being welded

Cross Pein Hammer 17. Which tool could be used to create this dimpled pattern on the back of this drawer handle? Repousse Hammer Pillar Drill Centre Punch Parallel Punch

18. Which of the following tools would be used to cut 0 18. Which of the following tools would be used to cut 0.5mm thick Copper Sheet? A Coping Saw Tin Snips Engineers Pliers A Panel Saw

19. What is the main disadvantage to using an adjustable spanner It takes time to adjust the spanner to the correct size. The adjustable Spanner has a tendency to round the corners of the nut or bolt. Adjustable spanners are bigger than ordinary spanners.

Quiz Completed Well Done

 Wrong Click here to try again