Swelling kinetic of polymeric membranes in ionic liquids

Slides:



Advertisements
Similar presentations
Mixtures and dissolving
Advertisements

Solutions.
Water A.Structure of water B.Ionization of water C.Solvent properties of water D.Thermal properties of water E.Monomers and polymers.
Water & pH lecture-2.
Determination of Partition Coefficient of NAD + on Nafion 117 membranes Importance: Partitioning process affects actual NAD + and NADH concentrations,
Multi-faceted nature of equilibrium self-association phenomena Karl F. Freed & Jacek Dudowicz James Franck Inst., U. Chicago Jack F. Douglas Polymers Div.,
Solutions Chapter 14. Key concepts 1.Understand the solvation process at the molecular level. 2.Be able to qualitatively describe energy changes during.
Explain which factors can affect solubility of solids, liquids and gases.
Properties of Solutions
I. Characteristics of solutions a. Mixtures and solutions i. Mixtures are either heterogeneous or homogeneous. 1. Heterogeneous mixtures have non-uniform.
Influence of ionic liquid content on properties of dense polymer membranes M. Kohoutová a, A. Sikora b, Š. Hovorka c, A. Randová.
Solution Formation Learning Targets: What is solubility?
Objectives To understand the process of dissolving
Solutions. Some definitions…. Solution: homogeneous mixture of at least two substances where each retains its own chemical identity Solvent: the component.
1 Section II Respiratory Gases Exchange 2 3 I Physical Principles of Gas Exchange.
NEMATIC FLUCTUATIONS AS A PROBE OF THE PROPERTIES OF LIQUID CRYSTAL ELASTOMERS Martin Čopič Irena Drevenšek-Olenik Andrej Petelin Boštjan Zalar.
Membrane Transport Chapter 6.
Copyright© by Houghton Mifflin Company. All rights reserved. Chapter 15 Solutions.
Biomaterials and Protein Adsorption
Solutions The Solution Process.
13.2 The Solution Process Factors Affecting the Rate of Dissolution
Coupled esterification reaction in ionic liquids and product recovery by pervaporation P. Izák 1, N.M.M. Mateus 2, C.A.M. Afonso.
Dr Saad Al-ShahraniChE 334: Separation Processes  Nonideal Liquid Solutions  If a molecule contains a hydrogen atom attached to a donor atom (O, N, F,
Molarity and Molality Copyright © 2011 Pearson Canada Inc. Slide 1 of 46 General Chemistry: Chapter 13 Molarity (M) = Amount of solute (in moles) Volume.
Polymer Nanofibers from Recycling of Waste Expanded Polystyrene Research at The University Of Akron C. Shin and G. G. Chase Polymer Nanofibers from Recycling.
Chapter 3: WATER AND THE FITNESS OF THE ENVIRONMENT.
Weekly Warm Up What is a mixture? What are the two types of mixtures?
Protein purification always begin with intact tissue  Disrupt  Blender, homogenizer  Remove debris  Centrifugation  Precipitate/concentrate  Ammonium.
Increase of the product recovery of Clostridium acetobutylicum fermentation product by pervaporation P. Izák 1, V. Jarmarová 1,
Thermodynamics Introduction.
Properties of Water Essential Questions: What are the properties of Water? What are Mixtures, Solutions and Suspensions? Why is water important for living.
Chapter 11a : Solutions and Their Properties. Introduction 1. A mixture is any intimate combination of two or more pure substances 2. Can be classified.
Lecture 5 Interactions Introduction to Statistical Thermodynamics
Testing a Mechanism: Reaction Kinetics Case I. Testing a Mechanism: Reaction Kinetics Case II.
Introduction to Dispersed Systems FDSC400 09/28/2001.
Solutions and Solubility Notes. I. Solutions A. Solutions are also known as homogeneous mixtures. (mixed evenly; uniform)
Solution properties Definitions –Solution –Solvent –Solute –Solubility –Saturated solution Concentration expression Matter – Solid, liquid, gas Vapor.
Solutions The Solution Process.
7 7-1 © 2003 Thomson Learning, Inc. All rights reserved Bettelheim, Brown, and March General, Organic, and Biochemistry, 7e.
Chapter Eight Solutions. Copyright © Houghton Mifflin Company. All rights reserved.8 | 2 Steve Allen/Peter Arnold, Inc. Solutions →CO 8.1 Ocean water.
Investigating Solutions. Components of a Solution Homogeneous mixture  at least 2 substances  proportions of the substances are not fixed (variable.
 SWBAT summarize what causes surface tension in water.  SWBAT define solution, solute, solvent and polar molecule.  SWBAT summarize the steps of dissolving.
Fractional Crystallization Problem - I Problem: Sodium sulphate sample contained ammonium sulphate as contaminant Objective: To develop a method.
HPLC.
Solutions & Solubility Vocabulary. agitation ___ is the act of stirring, shaking, or mixing.
Diffusion and Osmosis Transport- Passive or Active Passive transport-the movement of materials across a cell membrane without the expenditure of cell.
Properties of Solutions The Solution Process  Solution – homogeneous mixture Solute – present in smaller quantity Solvent – present in larger quantity.
Professor: CHENG-HO CHEN Student: CHIH-HAO WANG Date: 2015/12/22.
Cell Membrane *Clip*. FLUID MOSAIC MODEL Properties of the cell membrane: Properties of the cell membrane: –Fluid-like because of the phospholipid bilayer.
Section 6.2 Water & Diffusion p How much (%) water is in the following? Watermelon Watermelon 90% 90% Cucumber Cucumber 97% 97% Tomato Tomato.
Characterization of the interaction between Lomefloxacin and Certain Gastro-retentive Polymers Amir Ibrahim Mohamed a, Osama A. A. Ahmed b, Amira Osama.
Water. Water 70% - 95% of most organisms 70% - 95% of most organisms Water is one of the most important compounds in living organisms because… Water is.
Interfacial Tension and Interfacial profiles: The essentials of the microscopic approach Costas Panayiotou University of Thessaloniki, Greece.
Solutions. Definitions Solution: homogeneous mixture of 2 or more substances in a single physical state Solute: the substance dissolved in the solution.
Section 15.1 Forming Solutions 1.To understand the process of dissolving 2.To learn why certain substances dissolve in water 3.To learn qualitative terms.
NOTES: 2.2 – Properties of Water
Blend membrane by using the PVA/chitosan and crosslinking with TEOS for pervaporation separation for water acetic acid mixtures Shivshankar Chaudhari1,
Aim: How can we describe solutions?
Effect of water and ethanol on the size distribution
Section 13.2 Factors Affecting Solvation
CONCURRENT ENROLLMENT
Physical Properties of Solutions
Sulfonated Block Copolymers Containing Glassy Hydrophobic Blocks
Membrane Structure and Function
Chapter 15 Solutions.
Section 14.3 Factors Affecting Solvation
Chapter 7 Reaction Rates and Chemical Equilibrium
What is Diffusion? What does it mean to diffuse?
Transport through cell membranes
C SOLUBILITY AND PRECIPITATION
Presentation transcript:

Swelling kinetic of polymeric membranes in ionic liquids P. Izák, Š. Hovorka, T. Bartovský, L. Bartovská, J. G. Crespo

The aim Possibility to obtain new experimental data, which will contribute to better understanding of the swelling process. Development of an optical technique allowing follow small and even very slow swelling kinetics. Cation - exchange membrane Nafion®, hydrophobic membranes, polyurethane-polybutadiene elastomer (PU/PBDO) and polydimethylsiloxane (PDMS).

Introduction During the transport into the membrane, two ways of mutual affecting of components may be considered: The free volume effect, generally increasing the diffusivity of components (i.e. plasticizing effect). The coupling effect, due to remaining interaction among molecules in the polymer, which can increase or decrease diffusivity of molecules in the membrane (i.e. the interaction effect).

Swelling - balance between the forces where Fmix - force of thermodynamic mixing between the net polymer and the solvent, Fion – forces between immobilized and free ions, Fel – elastic force of the polymer, Fint – inter-chain attractive force The expansion of the polymer is due to the entropic diffusion of its constituent chains and their counterions. On the other hand, swelling is countered by elastic forces in the chain and inter-chain attractive forces.

Experimental Ethyl acetate, ethyl hexanoate, and hexyl acetate were of analytical grade (Fluka, Germany). Room temperature ionic liquids (RTILs): [C4mim] [BF4], [C4mim] [PF6], [C8mim] [PF6] PU/PBDO, PDMS membrane, Nafion® 122

Experimental We looked for ways to promote a micro-turbulence to the binary mixture and thus minimize the concentration polarization at the membrane surface during pervaporation separation process Fine-tuned surface of the dense membrane by UV radiation and application of shear stress The fine-tuned surface of the membrane prepared from liquid crystalline polyurethane shows primary (stripes) and secondary (bands) set of periodic structures, which are perpendicular to each other

Structure of surface modified PU/PBDO blend Controlled shear rate (F = 85 N m-2) was then periodically (at least 30 stretching cycles) applied reaching maximum elongation of 1.2 UV radiated (λ = 254 nm) for 24 hours Solvent + ≡ X Transverse direction Casting direction (Toluene) (PBDO) (PU) Y where Shear ( ≈ 47 Å) PU: PBDO: ≡ ( ≈ 263 Å)

FCT - Universidade Nova de Lisboa Portugal 3D topography image (50 × 50 μm2 scan with a image surface area of 2598 μm2) of the PU/PBDO-UV dense membrane in region 2 after pervaporation experiment. FCT - Universidade Nova de Lisboa Portugal

Apparatus for swelling kinetics of membranes MG SH TV TCS RCT digital camera magnifying glass circle Teflon cell thermostated vessel infra-red remote control and timer stand with holders

Results and discussion Table I. Membrane swelling equilibrium and water saturation of “pure” RTILs at 25°C Table II. Membrane swelling equilibrium of binary mixture [C4mim] [BF4] and hexyl acetate at 25°C

Isotropic swelling kinetics of PU/PBDO membrane in hexyl acetate at 60°C

Results and discussion Table III. Membrane swelling equilibrium of binary mixture [C4mim] [BF4] and hexyl acetate at 60°C Table IV. Membrane swelling equilibrium of binary mixture [C4mim] [BF4] and hexyl acetate at 25°C

FCT - Universidade Nova de Lisboa Portugal Membrane swelling equilibrium with binary mixture [C4mim] [BF4] and hexyl acetate at 25°C FCT - Universidade Nova de Lisboa Portugal

Results and discussion Table V. Membrane swelling equilibrium of binary mixture [C4mim] [BF4] and ethyl hexanoate at 25°C Table VI. Membrane swelling equilibrium of binary mixture [C4mim] [BF4] and ethyl acetate at 25°C

FCT - Universidade Nova de Lisboa Portugal Swelling equilibrium of Nafion in binary mixture H2O and [C4mim] [BF4] at 25°C FCT - Universidade Nova de Lisboa Portugal

Yeager and Steck 3-phase model of Nafion clusters A - fluorocarbon backbone material B - large fractional void volume, which contains side-chain material, a small amount of water, and some free sulfonate exchange sites C - ion clusters, counterions and sorbed water [C4mim]+ [C4mim]+

Stylized view of polar/nonpolar microphase separation in a hydrated ionomer

FCT - Universidade Nova de Lisboa Portugal Anisotropic swelling and deswelling kinetics of Nafion membrane in H2O at 25°C FCT - Universidade Nova de Lisboa Portugal

FCT - Universidade Nova de Lisboa Portugal Anisotropic swelling and deswelling kinetics of Nafion membrane in binary mixture 50% w/w H2O and 50% w/w [C4mim] [BF4] at 25°C FCT - Universidade Nova de Lisboa Portugal

Conclusions Nafion - anisotropic swelling and isotropic swelling of PU/PBDO, and PDMS membranes in all measured mixtures Swelling of Nafion, PU/PBDO, and PDMS membranes is faster in casting than in transverse direction Membrane swelling of all polymers increased with the content of ester in all mixtures (RTIL + ester) Nafion: δhexyl acetate > δethyl hexanoate > δethyl acetate

Conclusions, cont. PU/PBDO, PDMS: δhexyl acetate >δethyl hexanoate >δethyl acetate Swelling equilibrium of Nafion membrane in liquid binary mixture ([C4mim] [BF4] + H2O) clearly shows the maximum in the middle of the concentration range at 25°C This is caused by forming of the larger clusters contains [C4mim]+ and H2O between hydrophobic and ionic parts of Nafion network It was observed only little increase of polymer swelling with temperature

Acknowledgement The financial support of the FEDER through the project grant (POCTI/EQU/35437/1999) is gratefully acknowledged. P. Izák would like to acknowledge the post-doc grant (SFRH/BPD/9470/2002) from Fundação para a Ciência e a Tecnologia, Portugal. The co-authors from Czech Republic acknowledge the financial support from the MSM 2234 00008 grant from Ministry of Education of the Czech Republic.

FCT - Universidade Nova de Lisboa Portugal