Vent window installed
Install door frame side latch
The other door
Windshield
Finish windshield installation
Radio antenna installed
Door strap
Cooling shrouds to be cleaned/repaired
Painted the frame black
Other side of the frame
From the rear
Top, sides, bottom – some tiny spaces to paint
New brakes and cylinders
Brake hub turned – painted Aluminum
13mm wrench to adjust brakes
New wide tires for the rear - radials
brake adjusters
Brake cleaner used prior to finish painting and mounting brakes and cylinders
Tremclad gloss black paint
Original brake cylinders - seized
Rear brakes finished
Engine cover (bottom) repainted
Engine cover repainted - top
Engine mounting holes - front
Arrow shows the speedo drive
Speedo cable – engine mounted
Square drive inside
Speedo cable – side view – mounts on the motor
Use the small brake fluid container for filling the reservoir
Bleeder kit mounted to the front brake nipple – 8mm wrench required
Pumped out brake fluid from the brake lines
Dirty – should be clear
Fill the reservoir
Left rear brakes being bled – you can do this by yourself, just look under the cabin
Keep refilling the reservoir as you bleed the brakes
Right rear ready
Watch through the door gap when you do the front brake
Brake bleeder kit – you can make your own
How to make a brake bleeder – start in the kitchen
Get yourself a plastic container with a lid, clear tubing to fit tightly over the bleeder nipple and a vent hole in the lid