Condensate Trap Heater KGAHT0201KIT 2013 Fall Zone Meeting Gary Georgette/Jerry Shipman UTC Climate, Controls & Security Confidential and Proprietary Information - Not for Further Distribution

KGAHT0201CFP Kit Contents: –Condensate trap with heat pad installed Includes: Low voltage harness External thermostat –115 VAC to 24 VAC Step-down transformer –Trap grommet Horizontal direct vent installations –7/8-in. casing knockout grommet UTC Climate, Controls & Security Confidential and Proprietary Information - Not for Further Distribution

Kit Contents-Trap Heater Heat pad is factory-applied and wraps around the entire trap assembly External thermostat Low voltage harness & transformer leads UTC Climate, Controls & Security Confidential and Proprietary Information - Not for Further Distribution

Kit Contents-Transformer 115 VAC, Neutral & Ground Leads UL Label Mounting Screw Low Voltage Screw Terminals UTC Climate, Controls & Security Confidential and Proprietary Information - Not for Further Distribution

Kit Contents-Grommets Trap Grommet 7/8-in. Casing Knockout Grommets UTC Climate, Controls & Security Confidential and Proprietary Information - Not for Further Distribution

Basic Wiring Diagram UTC Climate, Controls & Security Confidential and Proprietary Information - Not for Further Distribution

Basic Installation Remove factory trap from furnace Install trap from kit on furnace Remove (2) 7/8-in. knockouts on same side of furnace Install transformer from kit on field-supplied J-box Mount J-box to knockout on furnace casing Install 7/8-in. grommet through knockout for J- box/furnace casing UTC Climate, Controls & Security Confidential and Proprietary Information - Not for Further Distribution

Basic Installation Route external 115 VAC power leads and furnace power leads to J-box –Use external disconnect when required by code Connect external, furnace and transformer leads together Install 7/8-in. grommet in other 7/8-in. knockout in casing Route trap heater leads under inducer assembly and through that grommet in casing Verify trap heater leads are not touching hot surfaces Connect low voltage leads to screw terminals on transformer UTC Climate, Controls & Security Confidential and Proprietary Information - Not for Further Distribution

Trap Heater Installed UTC Climate, Controls & Security Confidential and Proprietary Information - Not for Further Distribution

External Connections Low Voltage Leads & Casing Grommet Furnace Line Voltage Power Leads & Casing Grommet Secure Excess Wire & Connect to Transformer Complete Line Voltage Connections In J Box UTC Climate, Controls & Security Confidential and Proprietary Information - Not for Further Distribution

Conclusion It’s quick It’s easy Instructions on HVACpartners –AG-KGAHT-01 Questions? UTC Climate, Controls & Security Confidential and Proprietary Information - Not for Further Distribution