Tim Haeberle API SC6 2012 Winter Meeting API Specification 6A Furnace Calibration Requirements Carry Over From API SC6 2011 Summer Meeting Tim Haeberle API SC6 2012 Winter Meeting

The Problem Current Wording: API Spec 6A 20th Edition, Annex M, “Qualification of heat-treating equipment”, Section M.3.3, “Temperature survey method for calibration of batch-type furnaces”, states the following in the last sentence: “When a furnace is repaired or rebuilt, a new temperature survey shall be carried out before the furnace is used for heat treatment.” The Problem: This implies a time-consuming and costly full survey is required, even for minor repairs to a furnace that will in no way affect the calibration or temperature uniformity in the furnace.

The Solution Proposal: Revise the API Spec 6A 20th Edition, Annex M, Section M.3.3 to add the following statement after the last sentence: “Repairs that return the furnace to the condition it was in at the time of the last furnace survey and calibration or repairs that do not affect the temperature tolerance of the furnace shall not require a new temperature survey and calibration.”

The Solution Justification: There is no need to perform a costly and time consuming new temperature survey and calibration after repairs that do not affect the temperature tolerance of the furnace. Other recognized industry standards for furnace calibration permit such repairs without re-calibration. These include: SAE AMS 2750D

AMS 2750D Reprinted with permission from SAE AMS2750D © 2005 SAE International

AMS 2750D Reprinted with permission from SAE AMS2750D © 2005 SAE International

API CSOEM SR3 Form Form ready for submittal No money requested

API Ballot Form ready for submittal

Action Required Send the issue to a TG set up under the Materials Resource Group for review, refinement, and submittal for approval for ballot at the API SC6 2012 Summer Meeting Or Approve for ballot at the API SC6 2012 Winter

End Of Presentation