1. Engineer Training Installing the UV Lamp TJ8300 / TJ8500 Installing the UV Lamp

2. Engineer Training Installing the UV Lamp TJ8300 / TJ8500 Confidential 2 Safety  Shut down the machine completely by pushing the OFF button in the operation panel.  On the UV system power cabinet, padlock the main isolator in the ‘OFF’ position.

3. Engineer Training Installing the UV Lamp TJ8300 / TJ8500 Confidential 3 Installing the UV Lamp 1.In order to hinge up the lamp head cover, you have to pull and rotate the locker pin on both sides.

4. Engineer Training Installing the UV Lamp TJ8300 / TJ8500 Confidential 4 Installing the UV Lamp (Cont.) 2.Disconnect the air pressure to the machine, then open the shutter manually to gain access to the lamp socket.

5. Engineer Training Installing the UV Lamp TJ8300 / TJ8500 Confidential 5 3.Release the lamp retaining plates by unclipping the slide latches. Installing the UV Lamp (Cont.)

6. Engineer Training Installing the UV Lamp TJ8300 / TJ8500 Confidential 6 4.Do not touch the lamp, as skin acids will permanently mark the quartz sleeve. 5.It is recommended to wear cotton gloves or to cut the nylon package only on the edges as shown. Installing the UV Lamp (Cont.)

7. Engineer Training Installing the UV Lamp TJ8300 / TJ8500 Confidential 7 Inserting the Lamp Note: This procedure must be preformed by two people. 1.Connect the lamp to its terminal. 2.Connect the yellow cable to the lamp terminal and secure it tightly.

8. Engineer Training Installing the UV Lamp TJ8300 / TJ8500 Confidential 8 Inserting the Lamp (Cont.) 3.Place the lamp at its location, as shown in the picture.

9. Engineer Training Installing the UV Lamp TJ8300 / TJ8500 Confidential 9 Inserting the Lamp (Cont.) 4.Place the lamp retaining plates and secure the slide latches. 5.Verify that the lamp can move freely (a few millimeters to the sides) Note: the lamp expands towards the sides during operation.

10. Engineer Training Installing the UV Lamp TJ8300 / TJ8500 Confidential 10 Inserting the Lamp (Cont.) 6.Cut the rest of the nylon package. 7.Hinge down the lamp head cover. 8.Close the lockers pin. 9.Switch on the air and electrical supplies. 10.Check the shutter operation.