2. In December of last year (2011) a supervisor in the prep lab was crushing ore samples with a rolls crusher. Oversized material became jammed in- between the roller heads, a common occurrence. The employee proceeded to turn the power off to the unit and attempted to remove the rock prior to locking out the unit. The residual energy contained within the roller heads was sufficient enough pull in and crush the ring finger and middle finger of the employee.

3. Rolls Crusher before modifications were made to guarding

4. Rolls Crusher before Modifications were made to guarding

5. Basic Operation of a Rolls Crusher: Large Ore Particles The two rolls force the particles between their rotating surface into the ever smaller gap area, this fractures the rock from the compressive forces presented by the rotating rolls Crushed material down to 10 mesh (about 2mm)

6. ***WARNING*** The next slide shows the workers glove caught between the rollers of the unit, this picture was taken right after the incident Viewer discretion is advised (but I am sure many of you have seen much worse)

7. Picture taken after incident, this is the workers glove that was left in the rollers.

8. The employees injury is displayed in red. His bandages are still being changed on a daily basis, but the healing process is going very well. His only concern at the moment is his golf swing... Very positive attitude, realizing that this injury could have been much worse

9. Steps taken at time of Incident: Worker was given first aid and sent to hospital Scene was frozen, an investigation was started and work area was shut down Prep lab crew was assembled and informed about the incident New lock-out procedure implemented immediately Plans to review and update all Prep lab SOP’s

10. Steps taken since Incident New hopper top over feed chute of rolls

11. Steps taken since Incident SOP for rolls crusher and other lab equipment have been reviewed and updated (including pictures and visual aids)

12. Steps taken since Incident Lock out procedure has been laid out step by step in SOP with picture representation Rolls lock out

13. Direct causes: Failure to follow proper lock out procedure Improper sequence (bypassing jaw crusher which would create material of proper size for rolls crusher ) Worker put hand in unsafe location Inadequate guarding of rollers/chute Latent Causes Experienced worker became complacent in his position and put himself in a dangerous situation

14. Conclusion Supervisor has been put on light duty as he continues to recover New hopper guard has been put in place to keep workers from accessing moving rollers Updated and more detailed SOP’s involve locking out any machine in the prep lab when a jam or hang up occurs and, Workers are being re-trained in safe work practices with input from the JHSC, prep workers and management

15. Safety is Everyone's Responsibility... Especially Yours!