1. SAFE WORK INSTRUCTIONS
Title of Subject : Non Production Tramming/Positioning of Equipment
Last Reviewed Date: October 2015
SAFE WORK INSTRUCTIONS
Steps for Initial SWI Training:
Prepare – Review the SWI.
Present – Quick Card at the machine with experienced operator.
Tryout – Person runs the machine with supervision in non production.
Follow up – Competency points are verified by supervisor and is signed by the trainee/trainer to complete the training.
Steps for Retraining:
Review SWI or Quick Card
Verify Competency Points
Complete Annual Training Requalification Form
Competency Points for Non Production Tramming/Positioning:
Pre-ops ©
E-stops/Panic Switches ©
Tramming Section Equipment (Miner, Bolters, Shuttle Cars, Coal Haulers, Auxiliary Fan, Loader, Shearer, Feeder) ©
Training must be completed for each specific piece of equipment
The following safe work instructions in NOT INTENDED to replace hands on training requirements of the code of federal regulations. The intent is to provide an overview of known potential safety hazards associated with equipment operation. Hands on training with an experienced operator on each specific model must be conducted. The trainee can not proceed onto production until they are determined ready to proceed by the supervisor of the training. Before any operation or maintenance procedure is performed with or on this vehicle, it is important that personnel have a complete understanding of the location and functions of all controls and indicators, as well as, the location and use of all emergency shutdown controls and procedures
Buchanan Minerals, LLC is providing this safety guidance in order to specify the minimum safety standards, practices or policies that are expected to be observed by persons operating on Buchanan Minerals property. Additional or different safety standards, practices or policies may be applicable to your business or situation. You are solely responsible for establishing the safety standards, practices and policies that are applicable to your business and your situation and Buchanan Minerals, LLC assumes no responsibility or liability in that regard. Note: Only information that is maintained on the Buchanan Minerals web site is deemed controlled.

2. SAFE WORK INSTRUCTIONS
Title: Non Production Tramming/Positioning of Equipment
SAFE WORK INSTRUCTIONS
KEY POINTS
SAFETY PRECAUTIONS
Pre-operational checks
Check the overall condition of the equipment to be trammed.
Check the cable, plugs and breaker for proper ID tags, any defects or damage prior to energizing equipment.
Check the control levers to make sure that all levers are centered and not sticking.
Check the area where you will be tramming for any obstacles and condition of the tram roads. Tram roads must be maintained in a damp to wet condition.
Equipment stored outside for mechanics working on the surface is more prone to freezing or sticking levers and subject to animals making homes inside of equipment.
Energizing the equipment
Sound audible alarms prior to starting equipment to alert others of start up.
Communicate your intentions with anyone in your work area.
Once the equipment is energized and prior to moving check all E-stops and Panic switches to ensure proper operation.
Review all potential pinch points and red zones associated with the equipment that you will be tramming.
Use proper body positioning to avoid potential pinch points and red zones.
Use remote control devices whenever possible to avoid pinch points and red zones.
Never enter into or allow anyone else to enter into potential pinch points or red zones while the equipment is energized.
Tramming
If the equipment is equipped with an operators compartment the equipment must be operated from within the operators compartment.
When tramming section feeders use proper body positioning to avoid pinch points and red zones. (Use remote control devices whenever possible).
When tramming auxiliary fans do not stand between the tight side of the machine and the rib.
Whenever possible stay in the center of the entry or crosscut.
If tramming the equipment for maintenance or servicing examine the area where you are tramming from and the area where you will be working.
Be aware of cables in areas you are tramming.
When tramming the shearer for longwall operations be aware of tripping hazards in the walkway. (relay bars)