1. Installation Overview
Customizing Panels
Installation Overview

2. Uses for Customizing panels
Permanent studio installation
Wall-to-wall temporary installetion

3. Materials needed 2 x 4 lumber for edges
MDF sheet goods-cut to width and length
Customizing panels
Drywall screws

4. Step 1
Lay 2 x 4’s around edge of room where panels will be installed

5. Step 2
Measure all customizing panels to span gap between full Sub Floor panels and 2 x 4’s at edges.
See next slide

7. Step 3
Cut panels to size
Lay panels in place
See next slide

9. Step 4 Cut ½” MDF to fit over customizing panel and 2 x 4.
Drill countersink holes
Screw MDF to 2 x 4 perimeter
Screw MDF to “waves” of adjacent SubFloor panel

10. Additional photos See additional photos to learn about:
Doorway treatment
Corners
Non-square edges

14. Questions?? Call Tracey at Rosco: 800 67 2669 x234
Call Matt at Rosco: x 213