1. Streams Hydrodynamics
It is useful to have a system to identify types of streams by hydrodynamic characteristics.
Various factors influence the amount of flowing water (discharge), stream channel shape and flow dynamics (fluvial geomorphology).
Watershed size (total land area draining into a stream).
Watershed topography (geological processes)
Vegetation cover and land-use (evapotranspiration)
Soil type (influences on infiltration and percolation)
Climate (frequency and duration of rains; and temperature affects on evaporation)
High precipitation regions, stream flow is more permanent
Arid regions, stream flow is more ephemeral.

2. Watershed size vs. discharge volume
Fig. 5.3

3. Stream Order Smallest streams = first order.
Streams increase in order by 1 only when joined with a stream of same order.
Discharge increases with order number, but also depends on number of additional tributaries of lower order.
Low-order streams are most common. Collective length of low-order streams is more than high-order streams.
Terrestrial-stream interactions predominantly occur on small streams.
Which streams need to be targets of management?

4. How does water enter streams?
Most water enters via groundwater; this is called base flow.
It takes a lot of rain to create sheet flow (runoff) in most areas.
Base Flow

5. Stream Discharge
Discharge is the volume of water passing through the stream per unit time (different from current velocity).
Plotting discharge rate vs. time (hydrograph) can provide a good idea of stream dynamics:Dry areas = high variability within years
Wet areas = high variation between years
Ground water fed = fewer peaks in discharge; more base flow
Surface water fed = lots of peaks in discharge; “flashy”
Terrestrial surface influence variability greater for stream-fed;Groundwater fed has more stable water quality.

6. Flooding
When rain is high enough to create significant sheet flow, floods often occur.
Increases discharge rate.
Can be period, cyclic (10 yr flood, etc.).
Intensity of precipitation, infiltration rate, runoff rate influence severity of floods in a watershed
Human activities (urbanization) have increased flood rates.

7. The Stream Channel and Stage Frequency

8. Profile of a Stream Three basic types of sections:
Riffle: Shallow, fast, turbulent water
Run: Deeper, fast, smooth-surface water
Pool: Deep, slow area
Reach: A stretch of stream containing runs, riffles and pools
The sediment composition and topography of a stream can affect the appearance of these different sections (e.g.: fine sediments, no riffles)

9. Fig. 5.10
(Dodds, 2002; Fig. 5.11)

10. In-Stream Flow Profile
Thalweg: Line of highest current velocity.
* In straight streams, thalweg in center.
* In meanders, thalweg lies along the outside of the bend.
(Dodds, 2002; Fig. 5.10)

11. Stream and River Bends
High velocity flow at outside of bend erodes and transports more sediment.
Low velocity flow on inside of bend deposits sediments.
Current velocity profile at outside of bend creates a downward flow that undercuts bank.

12. Erosion at outside of bend and sediment deposition at inside of bend strengthens and exaggerates the formation of the bend.
Meanders are a common feature of flowing water. They are self-organizing and get exaggerated through time.

16. Characteristics of Meanders
Sinuosity = thalweg : linear distance ratio; S >1.5 is meander.
The radius of the meander is ~ 11 x channel width.
Radius is about 1/5 the wavelength.
Large channel -> large radius -> high discharge.
On flatter planes where sheet flow is dominant, streams become braided.

18. Floodplain
As a river meanders back and forth through the valley over geologic time, it creates a floodplain.
The floodplain gets inundated with water following seasonal flood cycles, providing a riparian wetland habitat.

20. Floodplain Heterogeneity
All these different processes (meanders, velocity profiles, etc.) creates highly variable system over different spatial scales in the river / stream valley.
Natural levees, oxbow lakes, boulders, fallen logs, vegetation patterns, etc.
This landscape heterogeneity plays an important role in flood control and ecology.

21. Fig. 5.13

22. Material Transport
Organic Matter: DOM (70-90%), FPOM, CPOM, large woody debris (branches to whole trees).
Inorganic Matter (Mineral): alluvium & bedload
Higher discharge streams can carry more and larger particles.
Suspended load: fine suspended particles (turbidity).
Bed load: Larger particles that bounce along bottom of stream.
The relative amount of suspended vs. bed loads is dependent on velocity and turbulence of stream flow.

24. Total concentration of suspended particles highest near bottom.
After rain, higher turbidity is not just a function of sediment run off; higher flow velocity suspends more sediments from bottom.

25. Velocity & Material Transport Size

26. Sediment Impacts & Contamination
Lack of sediments make erosion more aggressive
(e.g. below dams)
Excess Sedimentation:
reduces hard substrate for periphyton.
“clogs” gravel interstices.
Reduces spawning habitat for many fish species.
Many chemicals, contaminants will collect within and adhere to sediments.
Variable transport of contaminated sediments can have severe impact on biota:
Sediments collect in pools
Contaminated sediments can be retained for long periods of time.