1. Tiny Book Workshop!

2. Step 1: Pick your Tiny Book
Choose a book to make and cut out the tiny front cover and the tiny back cover

3. Step 2: Cut out a template
Choose the colour you’d like the spine of the book to be, and cut out one template along the outside lines.

4. Step three: Seal on the covers
- Glue the front cover on the right side of the template, and the back cover on the left side. - Brush Mod Podge on top of the covers. - Set aside to dry.

5. Step four: Cut the Inside Pages
Take a stack of 4 – 8 sheets of white paper
Cut out a small stack that is approximately 5cm wide and 4cm tall
Fold in half

6. Step Five: Sew the pages
Push one end of thread through the eye of a needle
Push the needle through cut stack of paper, near the top of the folded middle line, and pull thread through

7. Step five Continued
- Use the threaded needle to push through a new hole below the 1st hole, near the bottom of the folded line - Thread the needle through the top hole and the bottom hole 2 or 3 more times, securing the binding. - Cut the thread , and tie both ends together

8. Step six: Punch a hole
- Use the small hole punch to punch a hole in the cardstock, near the top of the spine

9. Step Seven: attaching the pages
- Fold all the flaps on the lines - Flip the cardstock cover piece upside down, and apply glue to the entire back side

10. Step Seven Continued
- Press the front and back page from your bound booklet onto the glue on the cardstock cover

11. Step Seven Continued
- Fold the flaps onto the front and back pages, and press them firmly. Apply more glue if necessary.

12. Step Eight: Attach to Jewelry
- Once dry, put a jump ring through the hole in the spine AND through a necklace cord, keychain, or earring. - Use pressure or plyers to close the jump ring

13. Enjoy your tiny books!