VoIP Journal Sample. Network Sample Icons Index Basic Config Ethernet Serial Router Rip Router OSPF Rip / OSPF.

Slides:



Advertisements
Similar presentations
Configuring a Router Harold Hernandez, MS, CCNI. 3.1 Configuring a Router Name a router Set passwords Examine show commands Configure a serial interface.
Advertisements

Configuración de un Router. Elementos Preliminares Modos del router Password de acceso Información de direccionamiento IP.
/30 Host Name : R1 Serial 0/0/0.1.2 Host Name : R2 Router Lab 3 : 2 - Routers Connection DTE DCE.
IP Routing Static Routing Information management 2 Groep T Leuven – Information department 2/14 The Router Router Interface is a physical.
 WAN uses Serial ports  Ethernet Ports:  Straight through  Cross over.
CCNA2-1 Chapter 1 Introduction to Routing and Packet Forwarding CLI Configuration and Addressing.
RIP2 CCNA Exploration Semester 2 Chapter 7
CCNP Network Route IPV-6 Part-III IPV-6 Static Routing: R1(Conf t)# ip routing  (Turn on Routing) R1(Conf t)# ipv6 unicast-routing  (Turn on ipv6 routing)
Ver 1,12/09/2012Kode :CIJ 340,Jaringan Komputer Lanjut FASILKOM Routing Protocols and Concepts – Chapter 2 Static Routing CCNA.
© 2009 Cisco Systems, Inc. All rights reserved. ROUTE v1.0—4-1 Implement an IPv4-Based Redistribution Solution Lab 4-1 Debrief.
Introduction to the Cisco IOS
CPIT 470 Lab 2 Lab Instructor: Aisha Ehsan.
IST 228\Ch5\IP Routing1. 2  Review of Chapter 4 Start the router simulator. You will see the prompt "Router>". This is the user mode prompt. Change the.
Static Routing Last Update Copyright Kenneth M. Chipps Ph.D.
IP ROUTING -1 STATIC ROUTING DEFAULT ROUTING.  A routing protocol is used by routers to dynamically find all the networks in the internetwork and to.
1 16-Aug-15 S Ward Abingdon and Witney College Routing CCNA Exploration Semester 2 Chapter 1.
1 16-Aug-15 Static Routing CCNA Exploration Semester 2 Chapter 2.
Chapter 11 Intro to Routing & Switching.  Upon completion of this chapter, you should be able to:  Configure a router with a basic configuration  Configure.
© 2007 Cisco Systems, Inc. All rights reserved.Cisco Public 1 Version 4.0 Static Routing Routing Protocols and Concepts – Chapter 2.
Basic Router Configuration Warren Toomey GCIT. Introduction A Cisco router is simply a computer that receives packets and forwards them on based on what.
© 2007 Cisco Systems, Inc. All rights reserved.Cisco Public 1 Version 4.0 Static Routing Routing Protocols and Concepts – Chapter 2.
ICND2 – OSPF – Mark Lab Reset for lab 4 Configure 2 loopback interfaces on both routers –RTR1 – 10.X.X.2/32 and 10.X.X.3/32 (area X) –RTR2 – 10.X.X.4/32.

© 2007 Cisco Systems, Inc. All rights reserved.ICND1 v1.0—5-1 WAN Connections Enabling Static Routing.
M. Dahshan - TCOM52721 TCOM 5272 Telecomm Lab Dr. Mostafa Dahshan OU-Tulsa 4W 2 nd floor
CCNA Journal Sample. Index Basic Ethernet Serial Router Rip.
CCNA Configuration Journal Sample. Index Basic Ethernet Serial Router Rip …
/24 Host Name :R1 Model : 1841 WIC-1T Serial 0/0/0 Basic Configuration.
Seminar ON CISCO ROUTER CONFIGURATION. CONTENT Introduction to Router Series of Router Interfaces of Router Types of Router Protocols used in Router Configuring.
Open standard protocol Successor of RIP Classless routing protocol Uses Shortest Path First (SPF) Algorithm Updates are sent through Multicast IP address.
E /24 LAN /24LAN – / /8 S0 S /8 Head Office Branch Office E /16.
© 2007 Cisco Systems, Inc. All rights reserved.Cisco Public ITE PC v4.0 Chapter 1 1 Introduction to Routing and Packet Forwarding Routing Protocols and.
Chapter 11 Configuring Enhanced IGRP. Objectives Upon completion of this chapter, you will be able to perform the following tasks: Describe Enhanced IGRP.
Route Redistribution Last Update Copyright 2012 Kenneth M. Chipps Ph.D.
Configuring a Router. Router user interface The Cisco IOS software uses a command-line interface (CLI) as the traditional console environment. This environment.
Module 4: Learning about Other Devices These Labs can be performed using the following topology or using the ones in the lab books: Creating a Network.
Configuring Routers I’ve got to program a router! What do I have to do.
Configuring Routers Oh No! I’ve got to program a router! What do I have to do.
Subnetting -2.
Module 3 Configuring a Router.
1 CSE3153 Semester Case Study 1 V1.0 The Concept of an IP Network Due Date: By end of the Lab Session Student Name: __________________________________________.
1 Swinburne University of Technology Faculty of Information and Communication Technology HIT2125 Data Communications and Computer Networks Network Case.
© 2002, Cisco Systems, Inc. All rights reserved. 1 Routing Overview.
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 2 v3.0 Module 9 Basic Router Troubleshooting.
Chabot College ELEC Routing Loops.
1 © 2004, Cisco Systems, Inc. All rights reserved. CCNA 2 v3.1 Module 9 Basic Router Troubleshooting.
Cisco Systems Networking Academy S2 C 12 Routing Protocols.
Configuration Modes and TFTP Honolulu Community College Cisco Academy Training Center Semester 2 Version 2.1.
1 9-Feb-16 S Ward Abingdon and Witney College Static Routing CCNA Exploration Semester 2 Chapter 2.
After 2.2 Revised Which cable(s) are crossover cables in this diagram? A.A B.B C.C D.D E.None of the above Q 1 of 5.
University of the Western Cape Chapter 12: Routing Protocols Interior and Exterior Routing Protocols Aleksandar Radovanovic.
2016/2/211 資訊網路專題 Router & Practice. 2016/2/212 Router Basics Computers have four basic components: a CPU, memory, interfaces, and a bus. –A router also.
Lab6 Configure Dynamic route.  RIP(Routing information protocol)  IGRP(interior gate way routing protocol)
1 © 2003, Cisco Systems, Inc. All rights reserved. CCNA 2 v3.0 Module 9 Basic Router Troubleshooting.
1 Pertemuan 20 Network Testing. Discussion Topics Introduction to network testing Using a structured approach to troubleshooting Testing by OSI layers.
Cisco S2 C8 Router Configuration 2. Router Configuration Process Router # –Debug commands –Reload –Configure router Router (config)# –Enable secret –Interface.
Configure and verify operation status of a device interface.
Configuring a Router Module 3 Semester 2. Router Configuration Tasks Name a router Set passwords Examine show commands Configure a serial interface Configure.
Swinburne University of Technology Faculty of Information and Communication Technologies HIT2125 Data Communications and Computer Networks Network Case.
Redes de Computadores Prática - Roteamento. Equipamentos ● Switch Cisco 1900 Series – 12 portas Ethernet – 2 portas FastEthernet ● Roteador Cisco 2501.
What are the two types of routes used by network administrators?
Basic router configuration
Switch Commands Exec Commands Switch#? exec Commands
Semester 2 JEOPARDY CHAPTERS 12 & 13 REVIEW S2C13 Jeopardy Review.
CCNA Configuration Journal Sample
CCNA Journal Sample.
Load Sharing (pages ) Can be equal cost or unequal-cost
Configuring a Router Module 3 Semester 2.
Routing Protocols and Concepts – Chapter 2
資訊網路專題 Router & Practice
Presentation transcript:

VoIP Journal Sample

Network Sample Icons

Index Basic Config Ethernet Serial Router Rip Router OSPF Rip / OSPF

Basic Configuration enable config t password cisco secret class line con 0 logging synch login password cisco

Ethernet interface Show run ip interface brief ip route (ping) Debug packets Special … Fa 0/ interface fa 0/0 ip address no shutdown

Serial Interface Show run ip int brief ip route cdp neighbors (ping) Debug packets Special … int serial 0/0 ip address No shutdown int serial 0/1 ip address Clock rate S0/ DTE S0/ DCE

Show run ip interface brief ip route (ping) Debug packets Special … router rip network network network Rip

IGRP Show run ip interface brief ip route Debug … Special … Router EIGRP 100 router eigrp 100 redistribute connected redistribute eigrp 200 network network network default-metric no auto-summary

EIGRP / RIP Show run ip route ip interface brief cdp neighbors Debug … Special … Rip Eigrp Rip Eigrp router EIGRP 100 redistribute connected redistribute rip network network network default-metric no auto-summary router rip redistribute connected redistribute eigrp 100 network network default-metric 1 no auto-summary