DETECTOR PIXEL CHIP MCM PIXEL BUS COOLING TUBE PIXEL BUS AND PILOT MCM CONNECTIONS (1) SDM comp LASER DIODE 0.28 0.50 Space reserved (15mm) for connections.

Slides:



Advertisements
Similar presentations
Hybrid pixel: pilot and bus K. Tanida (RIKEN) 06/09/03 Si upgrade workshop Outline Overview on ALICE pilot and bus Requirements Pilot options Bus options.
Advertisements

ITS-week CERN December 3, 2001 Michel Morel CERN EP/ED.
Using three IR sensors, SensingBot can sense the front obstacles so it can avoid them. Sensing.
Cooling Channel Count Recap Cooling channel components # Engineering? Absorber: temperature 8*3 yes pressure 2*3 yes He temp 2*3 level 8*3 yes length (optical)
Cable Channel tests ____________________________________________________________ 17/Apr/07 Pisa Group Four configurations of insulation has been tested.
NA62 GTK Cables & Patch Panels. TCC8_GTK1 TCC8_GTK2_GTK3.
SPD general meeting Pixel bus and Pilot MCM Integration CERN October 8, 2002.
Chapter 10 Optical fiber measuring instruments and testing single-mode fiber networks.
15-pin monitor male cable connects to pin female monitor port.
1 CARRIER BUS LAYOUT(a) ± 193 mm ladder1ladder mm mm Pixel chip Michel Morel EP/ED 09/ x 425µ 256 x 50µ Decoupling capacitors
External hardware examples. External hardware examples Flat-panel, Monitor, and LCD Keyboard Microphone Mouse Printer Projector Scanner Speakers USB thumb.
Performance of the DZero Layer 0 Detector Marvin Johnson For the DZero Silicon Group.
1 CARRIER BUS LAYOUT(a) ± 193 mm ladder1ladder mm mm Pixel chip Michel Morel EP/ED 09/ x 425µ 256 x 50µ Decoupling capacitors
SVX4 chip 4 SVX4 chips hybrid 4 chips hybridSilicon sensors Front side Back side Hybrid data with calibration charge injection for some channels IEEE Nuclear.
18-Jan-021W. Karpinski System Test Design verification of petals and interconnect boards and control links without detectors a)mechanics b)electrical.
Ladder QA manual. Check items 1 Interlock - Temperature of NOVEC. ✓ Check the difference from the value where the QA in RIKEN was performed is less than.
CVD PCB, first steps. 15 mm 25 mm Chip area. No ground plane underneath the chip. Bulk isolated => only one ground line Power lines Connector: 11,1mm*2,1mm:
NA62 GigaTracKer Working Group meeting Integration and GTK-carrier PCB design April 9, 2013 Michel Morel.
PHENIX Silicon Pixel Detector Construction, Operation, and the first Results Atsushi Taketani RIKEN Nishina center RIKEN Brookhaven Research Center Outline.
Off Detector Electronics System [LNF-INFN] 1 Off Detector Electronics System Fan Unit ODEODE 1 ODEODE 2 ODEODE 3 ODEODE 4 ODEODE 5 ODEODE 6 ODEODE 7 ODEODE.
1 Module and stave interconnect Rev. sept. 29/08.
GigaTracker Working Group meeting Status of the GTK_carrier /03/2015.
Long distance cable ( ) –Double DB9-to-DB9 cable (2x10 shielded twisted pair cable) SCEM –AWG28, Impedance 113 Ω –9.6 CHF/m.
ALICE DCS Workshop 28/29 May 2001 Vito Manzari, INFN Bari SSD (Silicon Strip Detector) SDD (Silicon Drift Detector) SPD (Silicon Pixel Detector) Detector.
Modern Electronic Communication 9th edition Jeffrey S. Beasley and Gary M. Miller Copyright ©2008 by Pearson Education, Inc. Upper Saddle River, New Jersey.
Nanonics MultiView 2000™ Product Presentation. MultiView 2000 ™ Complete System MultiView 2000™ Product Presentation.
The SPD geometry in AliRoot Alberto Pulvirenti University & INFN Catania In collaboration with: Domenico Elia (INFN Bari) Outline:  Implementation  Volumes.
Raymond Giron, Adam Bahr, George Asbeck.  Originally developed by HP in the 1960’s  Wanted an easier way to interface the instruments and controllers.
N 2 Laser 300  QQ 150m HF  HF + 9 PMT Boxes  QP Calib Box 1  4 Counting Room HF Calibration Optical Fiber Path 9 PMT Boxes / Quad 24 PMT Tubes.
1 Outer Tracker Front-End Layout Distribution of Signals and Bias NIKHEF/HeidelbergOctober 2002.
LIGO-G W eLigo PSL laser diode room strawman design Rick Savage, Anamaria Effler, Peter King.
Ladder QA manual. Check items 1 Interlock - Temperature of NOVEC. ✓ Check the difference from the value where the QA in RIKEN was performed is less than.
AIDA 1 Mezzanine board Contacts for underside connectors Thermal contact pads.
EP/ED group meeting1 ALICE PIXELS DETECTOR.
1 PreFPIX2 Inner board and test beam triggering Gabriele Chiodini Fermilab - Jan 07, 02.
W. Karpinski, Nov CMS Electronics week CMS Microstrip Tracker grounding & shielding of the CMS Tracker R. Hammarstrom (CERN EP/CMT) & W. Karpinski.
GLAST LAT ProjectSLAC, May 14, 2003 A.Brez 1 Honeycomb grounding of the GLAST trays Tray electrical conductivity: Carbon Carbon, carbon fiber and Al core.
Service box / Patch panel Cabling detector counting room Power supplies LV and HV LHCb Outer Tracker Services and Infrastructure.
SPD CFSS screening/Harness RB24-RB26 /ALICE Week A. Pepato – INFN PD 1 CFSS and ES electrical screening for SPD Harness RB24-RB26 Electrical.
13 January 2004V. Manzari - Quark Matter Oakland1 The Silicon Pixel Detector (SPD) for the ALICE Experiment V. Manzari/INFN Bari, Italy for the.
1394b Gigabit Ethernet The transmitter Group (G8) Design Proposal Mubin Ansari Zubair P. Siddiqui February 14, 2002.
Smart Agent Installation Required Customer Connections 5 Core Power Cable To Laser Head 1.Power To Laser Head 2.Ethernet 10/100 Connector 3.Mains Input.
Implementing a 10 Gb/s VCSEL Driven Transmitter for Short Range Applications Irfan N. Ali Michael C. Clowers David S. Fink Sean K. Garrison Jeff A. Magee.
Front End Board (16 channels) Superlayer Cross Section Frontend Enclosure HV cap board HV cap Board Signals from chamber wires go to HV cap board to be.
Vessel dimensions GTK assembly carrier Electrical connections Cooling pipes integration Vessel alignment with the beam Next steps Conclusion 3/10/20102.
The Development of the Fabrication Process of Low Mass circuits Rui de Oliveira TS-DEM.
9/18/2003Safety Review Electronics Electronics design LV, HV power supply Fusing Heat.
December Status of MRS photodiodes ND280 Convener’s Meeting, 9 June 2006 Yury Kudenko INR, Moscow.
CERN SPD meeting, 4/06/2002V. Manzari for Bari SPD-Group1 Half-stave assembly Gluing procedure & glue characteristics Status of dummy components.
Progress on the Prototype design Catania Goikoetxea, Mikel Navarro Medrano, Javier Mainz, March 31st,
Integration of the MVD Demonstrator S. Amar-Youcef, A. Büdenbender, M. Deveaux, D. Doering, J. Heuser, I. Fröhlich, J. Michel, C. Müntz, C. Schrader, S.
Rene BellwiedSTAR Tracking Upgrade Meeting, Boston, 07/10/06 1 ALICE Silicon Pixel Detector (SPD) Rene Bellwied, Wayne State University Layout, Mechanics.
Atsushi Taketani 2005/06/03 VTX meeting 1 PIXEL BUS status 1.Circuit design 2.Design rule and design 3.Schedule.
Assembly, construction and testing of the ALICE Silicon Pixel Detector V. Manzari / INFN Bari, Italy for the SPD Project in the ALICE Experiment INFN and.
9/11/14 Objectives: To disassemble and assemble a desktop computer.
Low Mass Alice Pixel Bus Rui de Oliveira TE/MPE/EM 6/9/20161Rui de Oliveira Alice worshop.

ORDERING INFORMATION PART NUMBER DESCRIPTION OPTICAL PWR BUDGET MAX DISTANCE (Option) 8dB 10Km SINGLE-MODE 9/125um PRODUCT SPECIFICATION EL – HD2202 TX.
SVD Cables & Pipes Markus Friedl (HEPHY Vienna) B2GM, 24 July 2012.
Tapes and Integration of Powering (endcap) Pepe Bernabeu (IFIC) Valencia/UK - Experience and future collaboration on staves/petals, June 17 th 2010.
Markus Friedl (HEPHY Vienna)
Update of MVD services and requests
Micro Vertex Detector of PANDA Strip Detector
SCT/Pixel Draft Rack Layout rcj
SPD cable length and rack location


TEC Services Status 30/12/2018 Nick Lumb.
Back & Front panels FRONT VIEW BACK VIEW ZSX ZSX ZSX ZSX ZSX 4
Компания Reichle & De-Massari (R&M)
Presentation transcript:

DETECTOR PIXEL CHIP MCM PIXEL BUS COOLING TUBE PIXEL BUS AND PILOT MCM CONNECTIONS (1) SDM comp LASER DIODE Space reserved (15mm) for connections between Pixel bus & MCM and pixel bus & power supply extender extender

COOLING TUBE PIXEL BUS AND PILOT MCM CONNECTIONS (2) 1.90 SDM comp FADC (fBGA) Thermal grease 0.22 glue mcm extender LASER DIODE Glob top

COOLING TUBE PIXEL BUS AND PILOT MCM CONNECTIONS (3) MCM PIXEL BUS POWER SUPPLY EXTENDER D_PILOT (fBGA) 1.60 Thermal grease LASER DIODE

Glob top COOLING TUBE PIXEL BUS AND PILOT MCM CONNECTIONS (4) MCM PIXEL BUS POWER SUPPLY EXTENDER GOL (fBGA) 1.60 LASER DIODE Thermal grease LASER DIODE

Glob top COOLING TUBE PIXEL BUS AND PILOT MCM CONNECTIONS (5) MCM PIXEL BUS POWER SUPPLY EXTENDER 3.00 LASER DIODE 0.90 Optical fibers 1.90 LASER DIODE

Glob top PIXEL BUS POWER SUPPLY EXTENDER Optical fibers FLAT CABLE 15 PINS ZIF CONNECTOR MCM COOLING TUBE Grounding foil to gnd connection LASER DIODE

PIXEL BUS AND PILOT MCM CONNECTIONS (7) PIXEL BUS POWER SUPPLY EXTENDER (VDD + GND) Optical fibers COOLING TUBE FLAT CABLE (biases + senses + Temp monitor +mcm PS) LASER DIODE

PIXEL BUS AND PILOT MCM CONNECTIONS (8) 9.2mm PHOENIX CONTACT 2 PINS MALE CONNECTOR TYPE MC1,5/2-G-3,81 (9.2mm x x 9.01) Or PHOENIX CONTACT 2 PINS FEMALE CONNECTOR TYPE MC1/2-STZ-3,81 (23,1mm x 8,7 x 8,41) Cable 1.5mm2 Cable 2.5mm2 LASER DIODE