COOLING SYSTEM: CHECK CONDITION AND CONCENTRATION OF COOLANT CS1 A.1 D. 7 P-1.

Slides:



Advertisements
Similar presentations
Service Tips April COOLING SYSTEM To check and/or fill the cooling system it is necessary to remove the rear fender, the fuel tank (photo 1) and.
Advertisements

PROPER USE OF FLOOR JACK AND SAFETY STANDS
K&W Permanent Metallic ® Block Seal
Cooling System Service CS6 NATEF Task A.1 D.7 By Vance Bloom.
Cooling System Get the engine up to optimum operating Temperature as quickly as possible and maintains it at that temperature. Controls the heat produced.
Permanent Head Gasket & Block Repair w/Nanotechnology, 32 Fl Oz
REMOVE AND INSTALL THERMOSTAT AND TEST OPERATION CS4 A.1 D.6 P-5/6.
Problem Does Hot Water or Cold Water Freeze Faster?
Basic Automotive Care Oil, Transmission Fluid, Brake Fluid, Power Steering Fluid, Radiator Coolant, Tires.
Engine Cylinder Leakage Test Tune 8 NATEF Section A8, A.11 P-1.
Under-Hood Vehicle Inspection
How to Change Your Oil By: Sam Wallace. Overview Introduction (Importance) When? Tools Required Changing the Oil Clean Up.
A Penny for your Thoughts.
THE FLOW OF FOOD: AN INTRODUCTION
DONNING & REMOVING Personal Protective Equipment (PPE) for SARS
Colligative Properties
Science The Scientific Method: Lesson 2: The Scientific Method (bag experiment)
© 2012 Delmar, Cengage Learning Cooling System Service Chapter 21.
POWDER PUFF AUTO’S Beginners’ Automotive Training for Moms.
Reclaiming Clay. Why Reclaim Clay Good for the environment (avoiding landfill and extra mining of clay) Saves money.
WEATHERING Question: What is weathering and how does it affect the Earth’s surface?
Load Testing a Battery SC4B Objective Student will determine the state of charge of a battery and load test a battery in or out of the vehicle. Do you.
BATTERY State of Charge SC1 Objective Student will determine the “State of Charge” of a battery using the “Voltage Method” and document results. Student.
1 Engine Cooling Systems R. Bortignon. 2 Cooling Systems During the power stroke, temperatures of 1200°C or more are generated by the burning air/fuel.
The Cooling System.
Cooling System Service CS6 NATEF Task A.1 D.7. O BJECTIVE Student will inspect, test and flush cooling system.
BATTERY DRAW TEST SC10 By Vance Bloom Objective Student will determine if an abnormal “Key OFF Battery Drain” is present.
Diffusion Experiment.
FMTV COOLING SYSTEMS 4/23/2017.
Tempest Blower SECTION: Tools and Equipment ISSUED: REVISED: ##-####
Cooling System. 1. List the basic parts of a cooling system: -Thermostat -Fan -Water pump -Radiator -Ethelyne glycole -Shroud.
Check Spark Plug Wires. Objectives Student will visually inspect and test with ohmmeter, spark plug wires, evaluate, then recommend if replacement is.
TUNE UP SKILL T-1 AIR FILTER Removal, Installation and Evaluation.
Testing Alternator Output By Vance Bloom & Florante Boac SC6.
Charging a Battery SC2 Objective Student will determine the state of charge of a battery and charge a battery in or out of the vehicle.
USING SCAN TOOLS ON OBD II VEHICLES (1996 OR NEWER)
Auto shop safety Safety around the shop. Safety Which characteristic is essential for the professional auto technician? Responsible attitude Knowledge.
CS2 Pressure Test Objective: Students will inspect, pressure test, determine location of leaks, and determine needed repairs of the coolant system.
BATTERY State of Charge SC1 By Vance Bloom Objective Student will determine the “State of Charge” of a battery using the “Voltage Method” and document.
Horticulture II - Landscape UNIT C LANDSCAPE INSTALLATION AND MAINTENANCE.
Let’s watch a DVD… DVD Instructor Notes
The Cooling System.
Cooling System CS 1B Evaluating Coolant Checking For Dissolved Metals.
How and When to Clean and Sanitize ______________________ Process of removing food and other dirt from a surface All surfaces must be cleaned and rinsed.
TUNE UP SKILL T-2 PCV VALVE Removal, Installation and Testing Operation By Vance Bloom CTE Automotive Technology Hemet High School.
Safety In the Science Lab Rules and Symbols Lab Safety: Everyone Is Responsible! Mr. R. Martinez Stell Middle School
BELL WORK: Answer the question below IN COMPLETE SENTENCES. If a saltwater fish (such as a clownfish) were placed in a freshwater lake, it would die. Explain.
COOLING SYSTEM: CHECK CONDITION AND CONCENTRATION OF COOLANT CS1 A.1 D. 7 P-1.
Boost/Jump Starting SC3B Jump Starting a Vehicle With Jumper Cables By Vance Bloom.
Tarleton State University 201 Agricultural Power Units Cooling Systems Department of Agricultural Services and Development.
Chapter 39 Cooling System Fundamentals.
How to set up your Spider Habitat. Spider Habitat Remove the label. Save the cap.
MAINTENANCE INTERVAL SCHEDULE D6R TRACK TYPE TRACTOR 7AR EVERY 10 SERVICE HOURS OR DAILY.
12. Guidelines for the Effective Use of Sanitizers 10-2 Chlorine Water temperature ≥ 100°F (38°C) ≥ 75°F (24°C) Water pH ≤ 10 ≤8≤8 Water hardness As per.
Maintenance of a Vehicle’s Cooling System. Regular maintenance of a vehicle's cooling system is important to keep the vehicle running properly and to.
Practical Analytical Chemistry (1) Practical (8) Faculty of Pharmacy Department of Pharmaceutical Chemistry.
The Engine Cooling System
HOW THE COOLING SYSTEM OF YOUR CAR WORKS.
What are the Essential Fluids to Keep your Car Running Smoothly
Cooling System Get the engine up to optimum operating Temperature as quickly as possible and maintains it at that temperature. Controls the heat produced.
Cooling System Test.
Chapter 14 Cooling System.
Testing Alternator Output Vance Bloom & Florante Boac
Service Tips April 2005.
STARTER DRAW TEST SC8 By Vance Bloom.
BATTERY State of Charge SC1 By Vance Bloom.
Charging a Battery SC2 By Vance Bloom.
PROPER USE OF FLOOR JACK AND SAFETY STANDS
To know What the water cycle is
Ocean Acidification Results.
Presentation transcript:

COOLING SYSTEM: CHECK CONDITION AND CONCENTRATION OF COOLANT CS1 A.1 D. 7 P-1

Objective: Student will check engine coolant, determine concentration, condition, boiling and freezing points, and make recommendations needed to bring coolant up to factory specifications.

Materials Needed: EYE PROTECTION Coolant Tester Vehicle

Procedure: WEAR EYE PROTECTION! With engine cool! Locate and remove radiator cap. Using coolant tester draw out enough coolant to fill tester almost full. Check readings on both sides of tester and note on skill sheet: Boiling Point and Freezing Point. Look inside of radiator neck and at coolant in tester and note appearance on skill sheet. (Dirty, Contaminated, Color, All water, etc...)

STEP ONE WEAR EYE PROTECTION!

STEP TWO With engine cool! Locate and remove radiator cap.

STEP THREE Using coolant tester draw out enough coolant to fill tester almost full.

STEP FOUR Check readings on both sides of tester and note Boiling Point and Freezing Point.

STEP FIVE Look inside of radiator neck and at coolant in tester and note appearance. –(Dirty, Contaminated, Color, All water, etc...)

CONCLUSION Clean Up Your Mess Rinse out coolant tester with water Put Away All Tools Record Information on Skill/Task Sheet Get Skill/Task Sheet Signed

ANY QUESTIONS ASK INSTRUCTOR