XYZ 1330 Basic Operation Manual 1) Spindle Speed Selection 2) Spindle Operation 3) Setting automatic feed speed rate mm/revolution 4) Operating automatic feed of carriage along bed of machine 5) Operating automatic feed of cross-slide across bed of machine 6) Drilling holes in material using Tailstock &) Turning a taper using the compound slide

Spindle Speed Selection rpm 1) To select 175 rpm spindle speed locate position on speed selector panel and rotate inner selector lever (1) to the correct column as in diagram (A) below 2) Look along row to the left and diagram shows two horses (this is motor speed) 3) Rotate motor speed switch (2) to the two horse position as in diagram (B) below 4) Look along row to right and diagram shows a tortoise. 5) Rotate outer selector lever (3) to tortoise position as in diagram (A) below. (6) This procedure is followed for any speed by setting switch and levers to correct positions (A) (B) 3 2 1

Spindle Operation To operate spindle in forward direction pull clutch lever (1) out to the right and push down as in diagram below To stop spindle lift clutch lever back up into neutral position as in diagram below To operate spindle in reverse direction pull clutch lever out to the right and pull up

Setting automatic feed speed rate mm/revolution 1) Refer to chart of feed rates located on control panel as in diagram (A) 2) Select feed rate for example 0.10 mm/rev in left hand column 3) Look at gear selector positions in central column and top row 4) Rotate gear selector levers until they line up with correct letters/number as indicated in diagram (B) (A) (B)

Operating automatic feed of carriage along bed of machine Push feed direction selector button (1) in as shown below Start machine spindle using clutch lever. Pull feed engage button (2) out to engage feed Push feed engage button in to stop automatic feed Note disengage feed before turning spindle off on shut down 1 2

Operating automatic feed of cross-slide across bed of machine Pull feed direction selector button (1) out as shown below Start machine spindle using clutch lever. Pull feed engage button (2) out to engage feed Push feed engage button in to stop automatic feed Note disengage feed before turning spindle off on shut down 1 2

Drilling holes in material using Tailstock Rotate hand-wheel (A) on tailstock clockwise until scale on quill (B) is visible as in diagram below Insert chuck with centre drill fitted into quill ensuring tang lines up correctly as below. Move tailstock along machine bed until centre drill is around 20mm from work-piece then lock in position by pushing locking lever (C) forward Turn spindle on and rotate hand-wheel (A) clockwise to drill into work-piece Rotate anti-clockwise to withdraw, change drill to correct size and repeat process C B A

Turning a taper using the compound slide Using correct size Allen key loosen compound slide securing screws (A) one on front one on rear Rotate compound slide to align correct angle with datum line, example 20 degrees and lock securing nuts Move Carriage along bed of machine until tool is close to material Set tool at corner of material and wind back slightly carriage , move cross-slide forward by 0.5mm Rotate hand-wheel (B) on compound clockwise at a constant speed to cut taper When cutting stops rewind compound slide, apply further 0.5mm cut using cross-slide and repeat until correct taper is produced A B