Robin Lafever For Russell wilcox Fiber Synch System Basic Box Fit-up 25mm and 50mm deep boxes installed in 17” chassis 12/1/20151Robin Lafever LBNL

12/1/2015Robin Lafever LBNL2 Russ, I have worked up new versions of the Basic Box, and installed them in a typical chassis. Here is the 25 mm deep version.

12/1/2015Robin Lafever LBNL3 Russ, I have worked up new versions of the Basic Box, and installed them in a typical chassis. And, here is the 50 mm deep version.

12/1/2015Robin Lafever LBNL4 For this exercise, I have included a generic slot as a fiber bundle feed- through. (ignoring, for the moment, how we seal the feed-throughs) Here is the 25 mm box

12/1/2015Robin Lafever LBNL5 For this exercise, I have included a generic slot as a fiber bundle feed- through. (ignoring, for the moment, how we seal the feed-throughs) Here is the 25 mm box, and, here is the 50 mm box for comparison

12/1/2015Robin Lafever LBNL6 This is a generic 14” x 17” chassis Vibration isolation mounts

12/1/2015Robin Lafever LBNL7 Generic 14” x 17” chassis Vibration isolation mounts Aluminum base plate

12/1/2015Robin Lafever LBNL8 Generic 14” x 17” chassis Vibration isolation mounts Aluminum base plate ¾” Foam insulation

12/1/2015Robin Lafever LBNL9 Generic 14” x 17” chassis Vibration isolation mounts Aluminum base plate ¾” Foam insulation 25 mm Box with Heat-sinks installed

12/1/2015Robin Lafever LBNL10 Generic 14” x 17” chassis Aluminum base plate ¾” Foam insulation 25 mm Box with Heat-sinks installed

12/1/2015Robin Lafever LBNL11 Generic 14” x 17” chassis Aluminum base plate ¾” Foam insulation 25 mm Box with Heat-sinks installed

12/1/2015Robin Lafever LBNL12 50 mm Box Two complete Box units will NOT fit side-by-side in a standard chassis. Also note that the 50 mm unit is higher than the standard 4.5” high chassis 25 mm Box

12/1/2015Robin Lafever LBNL13 However, two units CAN fit side-by-side if they share the center insulation wall

12/1/2015Robin Lafever LBNL14 Note that the Nylon clamp bolts are now inside the overall profile and penetrate through the insulating foam.

12/1/2015Robin Lafever LBNL15 Note that the Nylon clamp bolts now are now inside the overall profile and penetrate through the insulating foam.

12/1/2015Robin Lafever LBNL16 This leaves very little room for routing fibers. But. This looks reasonable. What do you think?

12/1/2015Robin Lafever LBNL17 Completely imaginary fiber bundles

12/1/2015Robin Lafever LBNL18 Completely imaginary fiber bundles

12/1/2015Robin Lafever LBNL19 Completely imaginary fiber bundles

12/1/2015Robin Lafever LBNL20 Final installation.