Use Common Sense Safety begins by using your head. Most accidents are caused by misuse, not equipment failure. Don’t be Stupid! Horseplay and tools don’t belong together!

Power Drills Safe Drill Use Always secure the piece you will be drilling. A loose piece WILL spin and hit you Avoid loose clothing/long hair Make sure the drill bit is secure. A loose bit will not drill a hole Let the drill do the work. Do not press too hard. If the bit isn’t cutting, make sure the drill is spinning the proper direction. Drill pilot holes when necessary! A pilot hole is a smaller sized hole than one needed. This helps guide the drill bit (e.g. drilling a 1/16” hole to guide a 1/4” drill bit).

PVC Cutters PVC Cutter Safety Always close and lock the cutter jaws when not in use Never put your fingers between the blades Remember what your mother told you (see comic) Wear safety glasses when using. PVC can splinter

Soldering Iron Soldering Saftey Never touch the tip of the soldering iron Do not use the soldering iron near water Work in a well ventilated area and don’t breathe vapors Never leave a hot iron unattended Wear safety glasses and gloves Wash your hands after soldering. Solder usually contains lead.

Other Tools General Safety for other tools If it’s hot, don’t touch it If it is electrical, keep it away from water If it can pinch or cut you, keep your fingers out of it (e.g. vise) Always use safety equipment, even if you think you don’t need it (e.g. gloves, safety glasses) If it has fumes, don’t inhale them Never use them as toys And ALWAYS think before using any tool